No Arabic abstract
An experimental and theoretical study of the structural properties of monoclinic bismuth oxide (alfa-Bi2O3) under high pressures is here reported. Both synthetic and mineral bismite powder samples have been compressed up to 45 GPa and their equations of state have been determined with angle-dispersive x-ray diffraction measurements. Experimental results have been also compared to theoretical calculations which suggest the possibility of several phase transitions below 10 GPa. However, experiments reveal only a pressure-induced amorphisation between 15 and 25 GPa, depending on sample quality and deviatoric stresses. The amorphous phase has been followed up to 45 GPa and its nature discussed.
Electronic, structural, vibrational and elastic properties of PaN have been studied both at ambient and high pressures, using first principles methods with several commonly used parameterizations of the exchange-correlation energy. The generalized gradient approximation (GGA) reproduces the ground state properties satisfactorily. Under pressure PaN is found to undergo a structural transition from NaCl to the R-3m structure near 58 GPa. The high pressure behavior of the acoustic phonon branch along the (1,0,0) and (1,1,0) directions, and the C44 elastic constant are anomalous, which signals the structural transition. With GGA exchange-correlation, a topological transition in the charge density occurs near the structural transition which may be regarded as a quantum phase transition, where the order parameter obeys a mean field scaling law. However, the topological transition is absent when other exchange-correlation functionals are invoked (local density approximation (LDA) and hybrid functional). Therefore, this constitutes an example of GGA and LDA leading to qualitatively different predictions, and it is of great interest to examine experimentally whether this topological transition occurs.
Ferroelectric phase transition in the semiconductor Sn2P2S6 single crystal has been studied by means of neutron scattering in the pressure-temperature range adjacent to the anticipated tricritical Lifshitz point (p=0.18GPa, T=296K). The observations reveal a direct ferroelectric-paraelectric phase transition in the whole investigated pressure range (0.18 - 0.6GPa). These results are in a clear disagreement with phase diagrams assumed in numerous earlier works, according to which a hypothetical intermediate incommensurate phase extends over several or even tens of degrees in the 0.5GPa pressure range. Temperature dependence of the anisotropic quasielastic diffuse scattering suggests that polarization fluctuations present above TC are strongly reduced in the ordered phase. Still, the temperature dependence of the (200) Bragg reflection intensity at p=0.18GPa can be remarkably well modeled assuming the order-parameter amplitude growth according to the power law with logarithmic corrections predicted for a uniaxial ferroelectric transition at the tricritical Lifshitz point.
NMR is the technique of election to probe the local properties of materials. Herein we present the results of density functional theory (DFT) textit{ab initio} calculations of the NMR parameters for fluorapatite (FAp), a calcium orthophosphate mineral belonging to the apatite family, by using the GIPAW method [Pickard and Mauri, 2001]. Understanding the local effects of pressure on apatites is particularly relevant because of their important role in many solid state and biomedical applications. Apatites are open structures, which can undergo complex anisotropic deformations, and the response of NMR can elucidate the microscopic changes induced by an applied pressure. The computed NMR parameters proved to be in good agreement with the available experimental data. The structural evaluation of the material behavior under hydrostatic pressure (from --5 to +100 kbar) indicated a shrinkage of the diameter of the apatitic channel, and a strong correlation between NMR shielding and pressure, proving the sensitivity of this technique to even small changes in the chemical environment around the nuclei. This theoretical approach allows the exploration of all the different nuclei composing the material, thus providing a very useful guidance in the interpretation of experimental results, particularly valuable for the more challenging nuclei such as $^{43}$Ca and $^{17}$O.
This article reports the study of SnO by using the first-principles pseudopotential plane-wave method within the generalized gradient approximation (GGA). We have calculated the structural, elastic, electronic and optical of SnO under high pressure. The elastic properties such as the elastic constants Cij bulk modulus, shear modulus, Young modulus, anisotropic factor, Pugh ratio, Poisson ratio are calculated and analyzed. Mechanical stability of SnO at all pressure are confirmed by using Born stability criteria in terms of elastic constants and are associated with ductile behaviour based on G/B ratios. It is also found that SnO exhibits very high anisotropy. The energy band structure and density of states are also calculated and analyzed. The results show the semiconducting and metallic properties at 0 (zero) and high pressure, respectively. Furthermore, the optical properties such as dielectric function, refractive index, photoconductivity, absorption coefficients, loss function and reflectivity are also calculated. All the results are compared with those of the SnO where available but most of the results at high pressure are not compared due to unavailability of the results.
We use in-situ high pressure angle dispersive x-ray diffraction measurements to determine the equation of state of cubic tin nitride Sn3N4 under pressure up to about 26 GPa. While we find no evidence for any structural phase transition, our estimate of the bulk modulus (B) is 145 GPa, much lower than the earlier theoretical estimates and that of other group IV-nitrides. We corroborate and understand these results with complementary first-principles analysis of structural, elastic and vibrational properties of group IV-nitrides, and predict a structural transition of Sn3N4 at a higher pressure of 88 GPa compared to earlier predictions of 40 GPa. Our comparative analysis of cubic nitrides shows that bulk modulus of cubic C3N4 is the highest (379 GPa) while it is structurally unstable and should not exist at ambient conditions.