Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userA transformative superconducting magnet technology for fields well above 30 T using isotropic round wire multifilament Bi2Sr2CaCu2O8-x conductor
106
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We report here that magnetic fields of almost 34 T, far above the upper 24 T limit of Nb3Sn, can be generated using a multifilament round wire conductor made of the high temperature cuprate superconductor Bi2Sr2CaCu2O8-x (Bi-2212). A remarkable attribute of this Bi-2212 conductor is that it does not exhibit macroscopic texture and contains many high angle grain boundaries but nevertheless attains very high superconducting critical current densities Jc of 2500 A/mm2 at 20 T and 4.2 K. This Bi-2212 conductor does not possess the extreme texture that high Jc coated conductors of REBa2Cu3O7-x (REBCO) require, avoiding also its high aspect ratio, large superconducting anisotropy and the inherent sensitivity to defects of a single filament conductor. Bi-2212 wires can be wound or cabled into almost any type of superconducting magnet and will be especially valuable for very high field NMR magnets beyond the present 1 GHz proton resonance limit of Nb3Sn technology. This demonstration that grain boundary limits to high Jc can be practically overcome suggests the huge value of a renewed focus on grain boundary properties in non-ideal geometries, especially with the goal of translating the lessons of this Bi-2212 conductor into fabrication of multifilament round wire REBCO or Fe-based superconductors.
rate research
Read More
Bi2Sr2CaCu2O8+x is the only cuprate superconductor that can be made into a round-wire conductor form with a high enough critical current density Jc for applications. Here we show that the Jc(5 T,4.2 K) of such Ag-sheathed filamentary wires can be doubled to more than 1.4x10^5 A/cm^2 by low temperature oxygenation. Careful analysis shows that the improved performance is associated with a 12 K reduction in transition temperature Tc to 80 K and a significant enhancement in intergranular connectivity. In spite of the macroscopically untextured nature of the wire, overdoping is highly effective in producing high Jc values.
We report specific heat measurements at magnetic fields up to 20 T on the recently discovered superconductor SmFeAsO$_{0.85}$F$_{0.15}$. The B-T diagram of a polycrystalline SmFeAsO$_{0.85}$F$_{0.15}$ sample with T$_c$ = 46 K was investigated. The temperature dependence of B$_{c2}$ was extracted from the specific heat curves, the corresponding B$_{c2}$(T = 0) value derived from the Werthamer-Helfand-Hohenberg formula being 150 T. Based on magnetization measurements up to 9 T, a first estimation of the field dependence of the inductive critical current J$_c$ is given. Evidence for granularity is found. The presence of a peak effect is reported, suggesting a crossover in the vortex dynamics, in analogy to the behaviour observed in high T$_c$ cuprates.
In this paper, we review some of our ARPES results on the superconducting and pseudo gaps in Bi2Sr2CaCu2O8+x. We find that optimally and overdoped samples exhibit a d-wave gap, which closes at the same temperature, Tc, for all k points. In underdoped samples, a leading edge gap is found up to a temperature T* > Tc. We find that T* scales with the maximum low temperature gap, increasing as the doping is reduced. The momentum dependence of the pseudogap is similar to that of the superconducting gap; however, the pseudogap closes at different temperatures for different k points.
Recent improvements in momentum resolution by a factor of 32 lead to qualitatively new ARPES results on the spectra of Bi2Sr2CaCu2O8 (Bi2212) along the (pi,pi) direction, where there is a node in the superconducting gap. With improved resolution, we now see the intrinsic lineshape, which indicates the presence of true quasiparticles at the Fermi momentum in the superconducting state, and lack thereof in the normal state. The region of momentum space probed here is relevant for charge transport, motivating a comparison of our results to conductivity measurements by infrared reflectivity.
We present the design of a highly compact High Field Scanning Probe Microscope (HF-SPM) for operation at cryogenic temperatures in an extremely high magnetic field, provided by a water-cooled Bitter magnet able to reach 38 T. The HF-SPM is 14 mm in diameter: an Attocube nano-positioner controls the coarse approach of a piezo resistive AFM cantilever to a scanned sample. The Bitter magnet constitutes an extreme environment for SPM due to the high level of vibrational noise; the Bitter magnet noise at frequencies up to 300 kHz is characterized and noise mitigation methods are described. The performance of the HF-SPM is demonstrated by topographic imaging and noise measurements at up to 30 T. Additionally, the use of the SPM as a three-dimensional dilatometer for magnetostriction measurements is demonstrated via measurements on a magnetically frustrated spinel sample.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
