No Arabic abstract
We discuss the effect of atmospheric dispersion on the performance of a mid-infrared adaptive optics assisted instrument on an extremely large telescope (ELT). Dispersion and atmospheric chromaticity is generally considered to be negligible in this wavelength regime. It is shown here, however, that with the much-reduced diffraction limit size on an ELT and the need for diffraction-limited performance, refractivity phenomena should be carefully considered in the design and operation of such an instrument. We include an overview of the theory of refractivity, and the influence of infrared resonances caused by the presence of water vapour and other constituents in the atmosphere. `Traditional atmospheric dispersion is likely to cause a loss of Strehl only at the shortest wavelengths (L-band). A more likely source of error is the difference in wavelengths at which the wavefront is sensed and corrected, leading to pointing offsets between wavefront sensor and science instrument that evolve with time over a long exposure. Infrared radiation is also subject to additional turbulence caused by the presence of water vapour in the atmosphere not seen by visible wavefront sensors, whose effect is poorly understood. We make use of information obtained at radio wavelengths to make a first-order estimate of its effect on the performance of a mid-IR ground-based instrument. The calculations in this paper are performed using parameters from two different sites, one `standard good site and one `high and dry site to illustrate the importance of the choice of site for an ELT.
We present the results of mid-infrared nulling interferometric observations of the main-sequence star alpha Lyr (Vega) using the 6.5 m MMT with its adaptive secondary mirror. From the observations at 10.6 microns, we find that there is no resolved emission from the circumstellar environment (at separations greater than 0.8 AU) above 2.1% (3 sigma limit) of the level of the stellar photospheric emission. Thus, we are able to place an upper limit on the density of dust in the inner system of 650 times that of our own solar systems zodiacal cloud. This limit is roughly 2.8 times better than those determined with photometric excess observations such as those by IRAS. Comparison with far-infrared observations by IRAS shows that the density of warm dust in the inner system (< 30 AU) is significantly lower than cold dust at larger separations. We consider two scenarios for grain removal, the sublimation of ice grains and the presence of a planetary mass sweeper. We find that if sublimation of ice grains is the only removal process, a large fraction (> 80%) of the material in the outer system is ice.
MAORY is the adaptive optics module for ELT providing two gravity invariant ports with the same optical quality for two different client instruments. It enable high angular resolution observations in the near infrared over a large field of view (~1 arcmin2 ) by real time compensation of the wavefront distortions due to atmospheric turbulence. Wavefront sensing is performed by laser and natural guide stars while the wavefront sensor compensation is performed by an adaptive deformable mirror in MAORY which works together with the telescopes adaptive and tip tilt mirrors M4 and M5 respectively.
The Mid-infrared ELT Imager and Spectrograph (METIS) will provide the Extremely Large Telescope (ELT) with a unique window to the thermal- and mid-infrared (3 - 13 microns). Its single-conjugate adaptive optics (SCAO) system will enable high contrast imaging and integral field unit (IFU) spectroscopy (R~100,000) at the diffraction limit of the ELT. This article describes the science drivers, conceptual design, observing modes, and expected performance of METIS.
METIS, the Mid-infrared ELT Imager and Spectrograph (formerly called MIDIR), is a proposed instrument for the European Extremely Large Telescope (E-ELT), currently undergoing a phase-A study. The study is carried out within the framework of the ESO-sponsored E-ELT instrumentation studies. METIS will be designed to cover the E-ELT science needs at wavelengths longward of 3um, where the thermal background requires different operating schemes. In this paper we discuss the main science drivers from which the instrument baseline has been derived. Specific emphasis has been given to observations that require very high spatial and spectral resolution, which can only be achieved with a ground-based ELT. We also discuss the challenging aspects of background suppression techniques, adaptive optics in the mid-IR, and telescope site considerations. The METIS instrument baseline includes imaging and spectroscopy at the atmospheric L, M, and N bands with a possible extension to Q band imaging. Both coronagraphy and polarimetry are also being considered. However, we note that the concept is still not yet fully consolidated. The METIS studies are being performed by an international consortium with institutes from the Netherlands, Germany, France, United Kingdom, and Belgium.
METIS will be among the first generation of scientific instruments on the E-ELT. Focusing on highest angular resolution and high spectral resolution, METIS will provide diffraction limited imaging and coronagraphy from 3-14um over an 20x20 field of view, as well as integral field spectroscopy at R ~ 100,000 from 2.9-5.3um. In addition, METIS provides medium-resolution (R ~ 5000) long slit spectroscopy, and polarimetric measurements at N band. While the baseline concept has already been discussed, this paper focuses on the significant developments over the past two years in several areas: The science case has been updated to account for recent progress in the main science areas circum-stellar disks and the formation of planets, exoplanet detection and characterization, Solar system formation, massive stars and clusters, and star formation in external galaxies. We discuss the developments in the adaptive optics (AO) concept for METIS, the telescope interface, and the instrument modelling. Last but not least, we provide an overview of our technology development programs, which ranges from coronagraphic masks, immersed gratings, and cryogenic beam chopper to novel approaches to mirror polishing, background calibration and cryo-cooling. These developments have further enhanced the design and technology readiness of METIS to reliably serve as an early discovery machine on the E-ELT.