Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSTM and ab initio study of holmium nanowires on a Ge(111) Surface
94
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
A nanorod structure has been observed on the Ho/Ge(111) surface using scanning tunneling microscopy (STM). The rods do not require patterning of the surface or defects such as step edges in order to grow as is the case for nanorods on Si(111). At low holmium coverage the nanorods exist as isolated nanostructures while at high coverage they form a periodic 5x1 structure. We propose a structural model for the 5x1 unit cell and show using an ab initio calculation that the STM profile of our model structure compares favorably to that obtained experimentally for both filled and empty states sampling. The calculated local density of states shows that the nanorod is metallic in character.
rate research
Read More
Chemisorption of CO on the stepped Cu(211) surface is studied within ab-initio density functional theory (DFT) and scanning tunneling microscopy (STM) imaging as well as manipulation experiments. Theoretically we focus on the experimentally observed ordered (2x1) and (3x1) CO-phases at coverages 1/3, 1/2 and 2/3 monolayer (ML). To obtain also information for isolated CO molecules found randomly distributed at low coverages, we also performed calculations for a hypothetical (3x1) phase with 1/3 ML. The adsorption geometry, the stretching frequencies, the work functions and adsorption energies of the CO molecules in the different phases are presented and compared to experimental data. Initially and up to a coverage of 1/2 ML CO adsorbs upright on the on-top sites at step edge atoms. Determining the most favorable adsorption geometry for the 2/3 ML ordered phase turned out to be nontrivial both from the experimental and the theoretical point of view. Experimentally, both top-bridge and top-top configurations were reported, whereby only the top-top arrangement was firmly established. The calculated adsorption energies and the stretching frequencies favor the top-bridge configuration. The possible existence of both configurations at 2/3 ML is critically discussed on the basis of the presently accessible experimental and theoretical data. In addition, we present observations of STM manipulation experiments and corresponding theoretical results, which show that CO adsorbed on-top of a single Cu-adatom, which is manipulated to a location close to the lower step edge, is stronger bound than CO on-top of a step edge atom.
We investigate the adsorption of a single tetracyanoethylene (TCNE) molecule on the silver (001) surface. Adsorption structures, electronic properties, and scanning tunneling microscopy (STM) images are calculated within density-functional theory. Adsorption occurs most favorably in on-top configuration, with the C=C double bond directly above a silver atom and the four N atoms bound to four neighboring Ag atoms. The lowest unoccupied molecular orbital of TCNE becomes occupied due to electron transfer from the substrate. This state dominates the electronic spectrum and the STM image at moderately negative bias. We discuss and employ a spatial extrapolation technique for the calculation of STM and scanning tunneling spectroscopy (STS) images. Our calculated images are in good agreement with experimental data.
In this Letter, we present the first non-contact atomic force microscopy (nc-AFM) of a silicene on silver (Ag) surface, obtained by combining non-contact atomic force microscopy (nc-AFM) and scanning tunneling microscopy (STM). STM images over large areas of silicene grown on Ag(111) surface show both (sqrt13xsqrt13)R13.9{deg} and (4x4) superstructures. For the widely observed (4x4) structure, the nc-AFM topography shows an atomic-scale contrast inversion as the tip-surface distance is decreased. At the shortest tip-surface distance, the nc-AFM topography is very similar to the STM one. The observed structure in the nc-AFM topography is compatible with only one out of two silicon atoms being visible. This indicates unambiguously a strong buckling of the silicene honeycomb layer.
A theoretical study of the surface energy-loss function of freestanding Pb(111) thin films is presented, starting from the single monolayer case. The calculations are carried applying the linear response theory, with inclusion of the electron band structure by means of a first-principles pseudopotential approach using a supercell scheme. Quantum-size effects on the plasmon modes of the thinnest films are found in qualitative agreement with previous work based on the jellium model. For thicker films, results show a dispersionless mode at all thicknesses, in agreeement with electron energy-loss measurements. For sizeable values of the momentum, the raising of the surface plasmon with increasing thickness is retrieved.
We report scanning tunneling microscopy observations of Ge deposited on the Si(111)-7x7 surface for a sequence of sub-monolayer coverages. We demonstrate that Ge atoms replace so-called Si adatoms. Initially, the replacements are random, but distinct patterns emerge and evolve with increasing coverage, till small islands begin to form. Corner adatom sites in the faulted half unit cells are preferred. First-principles density functional calculations find that adatom substitution competes energetically with a high-coordination bridge site, but atoms occupying the latter sites are highly mobile. Thus, the observed structures are indeed more thermodynamically stable.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
