Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSpin-polarized transport through carbon nanotubes
77
0
0.0
(
0
)
Authors
S. Krompiewski
Ask ChatGPT about the research
No Arabic abstract
Carbon nanotubes (CNT) belong to the most promising new materials which can in the near future revolutionize the conventional electronics. When sandwiched between ferromagnetic electrodes, the CNT behaves like a spacer in conventional spin-valves, leading quite often to a considerable giant magneto-resistance effect (GMR). This paper is devoted to reviewing some topics related to electron correlations in CNT. The main attention however is directed to the following effects essential for electron transport through nanotubes: (i) nanotube/electrode coupling and (ii) inter-tube interactions.It is shown that these effects may account for some recent experimental reports on GMR, including those on negative (inverse) GMR.
rate research
Read More
Spin-dependent coherent quantum transport through carbon nanotubes (CNT) is studied theoretically within a tight-binding model and the Greens function partitioning technique. End-contacted metal/nanotube/metal systems are modelled and next studied in the magnetic context, i.e. either with ferromagnetic electrodes or at external magnetic fields. The former case shows that quite a substantial giant magnetoresistance (GMR) effect occurs ($pm 20%$) for disorder-free CNTs. Anderson-disorder averaged GMR, in turn, is positive and reduced down to several percent in the vicinity of the charge neutrality point. At parallel magnetic fields, characteristic Aharonov-Bohm-type oscillations are revealed with pronounced features due to a combined effect of: length-to-perimeter ratio, unintentional electrode-induced doping, Zeeman splitting, and energy-level broadening. In particular, a CNT is predicted to lose its ability to serve as a magneto-electrical switch when its length and perimeter become comparable. In case of perpendicular geometry, there are conductance oscillations approaching asymptotically the upper theoretical limit to the conductance, $4 e^2/h$. Moreover in the ballistic transport regime, initially the conductance increases only slightly with the magnetic field or remains nearly constant because spin up- and spin down-contributions to the total magnetoresistance partially compensate each other.
We have contacted single-walled carbon nanotubes after aligning the tubes by the use of surface acoustic waves. The acoustoelectric current has been measured at 4.2 K and a probing of the low-dimensional electronic states by the surface acoustic wave has been detected. By decreasing the acoustic wavelength resulting in an adjustment to the length of the defined carbon nanotube constriction a quantization of the acoustoelectric current has been observed.
We study theoretically the impact of Zener tunneling on the charge-transport properties of quasi-metallic (Qm) carbon nanotubes (characterized by forbidden band gaps of few tens of meV). We also analyze the interplay between Zener tunneling and elastic scattering on defects. To this purpose we use a model based on the master equation for the density matrix, that takes into account the inter-band Zener transitions induced by the electric field (a quantum mechanical effect), the electron-defect scattering and the electron-phonon scattering. In presence of Zener tunnelling the Qm tubes support an electrical current even when the Fermi energy lies in the forbidden band gap. In absence of elastic scattering (in high quality samples), the small size of the band gap of Qm tubes enables Zener tunnelling for realistic values of the the electric field (above $sim$ 1 V/mu m). The presence of a strong elastic scattering (in low quality samples) further decreases the values of the field required to observe Zener tunnelling. Indeed, for elastic-scattering lengths of the order of 50 nm, Zener tunnelling affects the current/voltage characteristic already in the linear regime. In other words, in quasi-metallic tubes, Zener tunneling is made more visible by defects.
We report low temperature transport measurements on suspended single walled carbon nanotubes (both individual tubes and ropes). The technique we have developed, where tubes are soldered on low resistive metallic contacts across a slit, enables a good characterization of the samples by transmission electron microscopy. It is possible to obtain individual tubes with a room temperature resistance smaller than 40 kOhms, which remain metallic down to very low temperatures. When the contact pads are superconducting, nanotubes exhibit proximity induced superconductivity with surprisingly large values of supercurrent. We have also recently observed intrinsic superconductivity in ropes of single walled carbon nanotubes connected to normal contacts, when the distance between the normal electrodes is large enough, since otherwise superconductivity is destroyed by (inverse) proximity effect. These experiments indicate the presence of attractive interactions in carbon nanotubes which overcome Coulomb repulsive interactions at low temperature, and enables investigation of superconductivity in a 1D limit never explored before.
We produce 120 um thick buckypapers from aligned carbon nanotubes. Transport characteristics evidence ohmic behavior in a wide temperature range, non linearity appearing in the current-voltage curves only close to 4.2 K. The temperature dependence of the conductance shows that transport is mostly due to thermal fluctuation induced tunneling, although to explain the whole temperature range from 4.2 K to 430 K a further linear contribution is necessary. The field emission properties are measured by means of a nanocontrolled metallic tip acting as collector electrode to access local information about buckypaper properties from areas as small as 1 um2. Emitted current up to 10-5A and turn-on field of about 140V/um are recorded. Long operation, stability and robustness of emitters have been probed by field emission intensity monitoring for more than 12 hours at pressure of 10-6 mbar. Finally, no tuning of the emitted current was observed for in plane applied currents in the buckypaper.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
