Here, we compare radiative accelerations (g_rad) derived from the new Opacity Project (OP) data with those computed from OPAL and some previous data from OP. For the case where we have full data from OPAL, the differences in the Rosseland mean opacities between OPAL and the new OP data are within 12% and less than 30% between new OP and previous OP data (OP1 at CDS). The radiative accelerations g_rad differ at up to the 17% level when compared to OPAL and up to the 38% level when compared to OP1. The comparison with OP1 on a larger (rho-T) space gives a difference of up to 40% for g_rad(C). And it increases for heavier elements. The differences increase for heavier elements reaching 60% for Si and 65% for S and Fe. We also constructed four representative stellar models in order to compare the new OP accelerations with prior published results that used OPAL data. The Rosseland means overall agree better than 10% for all of our cases. For the accelerations, the comparisons with published values yield larger differences in general. The published OPAL accelerations for carbon are even larger relative to OP compare to what our direct comparisons would indicate. Potential reasons for this puzzling behavior are discussed. In light of the significant differences in the inferred acceleration rates, theoretical errors should be taken into account when comparing models with observations. The implications for stellar evolution are briefly discussed. The sensitivity of g_rad to the atomic physics may provide a useful test of different opacity sources.
Download