Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCME-Driven and Flare-Ignited Fast Magnetosonic Waves Successively Detected in a Solar Eruption
95
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We present SDO/AIA observation of three types of fast-mode propagating magnetosonic waves in a GOES C3.0 flare on 2013 April 23, which was accompanied by a prominence eruption and a broad coronal mass ejection (CME). During the fast rising phase of the prominence, a large-scale dome-shaped extreme ultraviolet (EUV) wave firstly formed ahead of the CME bubble and propagated at a speed of about 430 km/s in the CMEs lateral direction. One can identify the separation process of the EUV wave from the CME bubble. The reflection effect of the on-disk counterpart of this EUV wave was also observed when it interacted with a remote active region. Six minutes after the first appearance of the EUV wave, a large-scale quasi-periodic EUV train with a period of about 120 seconds appeared inside the CME bubble, which emanated from the flare epicenter and propagated outward at an average speed up to 1100 km/s. In addition, another narrow quasi-periodic EUV wave train was observed along a closed-loop system connecting two adjacent active regions, which also emanated from the flare epicenter, propagated at a speed of about475 km/s and with a period of about 110 seconds. We propose that all the observed waves are fast-mode magnetosonic waves, in which the large-scale dome-shaped EUV wave ahead of the CME bubble was driven by the expansion of the CME bubble, while the large-scale quasi-periodic EUV train within the CME bubble and the narrow quasi-periodic EUV wave train along the closed-loop system were excited by the intermittent energy-releasing process in the flare. Coronal seismology application and energy carried by the waves are also estimated based on the measured wave parameters.
rate research
Read More
Solar flares and coronal mass ejections (CMEs) are closely coupled through magnetic reconnection. CMEs are usually accelerated impulsively within the low solar corona, synchronized with the impulsive flare energy release. We investigate the dynamic evolution of a fast CME and its associated X2.8 flare occurring on 2013 May 13. The CME experiences two distinct phases of enhanced acceleration, an impulsive one with a peak value of ~5 km s$^{-2}$ followed by an extended phase with accelerations up to 0.7 km s$^{-2}$. The two-phase CME dynamics is associated with a two-episode flare energy release. While the first episode is consistent with the standard eruption of a magnetic flux rope, the second episode of flare energy release is initiated by the reconnection of a large-scale loop in the aftermath of the eruption and produces stronger nonthermal emission up to $gamma$-rays. In addition, this long-duration flare reveals clear signs of ongoing magnetic reconnection during the decay phase, evidenced by extended HXR bursts with energies up to 100--300 keV and intermittent downflows of reconnected loops for >4 hours. The observations reveal that the two-step flare reconnection substantially contributes to the two-phase CME acceleration, and the impulsive CME acceleration precedes the most intense flare energy release. The implications of this non-standard flare/CME observation are discussed.
We study recent observations of propagating fluctuations in a prominence foot with Hinode Solar Optical Telescope (SOT) high-resolution observations in Ca~II and H alpha emission which we identify as nonlinear fast magnetosnic waves. Here we analyze further the observations of propagating waves and flows with Interface Region Imaging Spectrograph (IRIS) Mg~II slit jaw images, in addition to Hinode/SOT Ca~II images. We find that the waves have typical periods in the range of 5 - 11 minutes and wavelengths in the plane of the sky (POS) of about 2000 km, while the flows in narrow threads have typical speed in the POS of ~16-46 km/s. We also detect apparent kink oscillations in the threads with flowing material, and apply coronal seismology to estimate the magnetic field strength in the range 5-17 G. Using 2.5D MHD we model the combined effects of nonlinear waves and flows on the observed dynamics of the prominence material, and reproduce the propagating and refracting fast magnetosonic waves, as well as standing kink-mode waves in flowing material along the magnetic field. The modeling results are in good qualitative agreements with the observations of the various waves and flows in the prominence foot, further confirming coronal seismology analysis and improving the understanding of the fine scale dynamics of the prominence material.
We studied a circular-ribbon flare, SOL2014-12-17T04:51, with emphasis on its thermal evolution as determined by the Differential Emission Measure (DEM) inversion analysis of the extreme ultraviolet (EUV) images of the Atmospheric Imaging Assembly (AIA) instrument onboard the Solar Dynamics Observatory (SDO). Both temperature and emission measure start to rise much earlier than the flare, along with an eruption and formation of a hot halo over the fan structure. In the main flare phase, another set of ribbons forms inside the circular ribbon, and expands as expected for ribbons at the footpoints of a postflare arcade. An additional heating event further extends the decay phase, which is also characteristic of some eruptive flares. The basic magnetic configuration appears to be a fan-spine topology, rooted in a minority-polarity patch surrounded by majority-polarity flux. We suggest that reconnection at the null point begins well before the impulsive phase, when the null is distorted into a breakout current sheet, and that both flare and breakout reconnection are necessary in order to explain the subsequent local thermal evolution and the eruptive activities in this confined magnetic structure. Using local DEMs, we found a postflare temperature increase inside the fan surface, indicating that the so-called EUV late phase is due to continued heating in the flare loops.
Coronal disturbances associated with solar flares, such as H$alpha$ Moreton waves, X-ray waves, and extreme ultraviolet (EUV) coronal waves are discussed herein in relation to magnetohydrodynamics fast-mode waves or shocks in the corona. To understand the mechanism of coronal disturbances, full-disk solar observations with high spatial and temporal resolution over multiple wavelengths are of crucial importance. We observed a filament eruption, whose shape is like a dandelion, associated with the M1.6 flare that occurred on 2011 February 16 in the H$alpha$ images taken by the Flare Monitoring Telescope at Ica University, Peru. We derive the three-dimensional velocity field of the erupting filament. We also identify winking filaments that are located far from the flare site in the H$alpha$ images, whereas no Moreton wave is observed. By comparing the temporal evolution of the winking filaments with those of the coronal wave seen in the extreme ultraviolet images data taken by the Atmospheric Imaging Assembly on board the {it Solar Dynamics Observatory} and by the Extreme Ultraviolet Imager on board the {it Solar Terrestrial Relations Observatory-Ahead}, we confirm that the winking filaments were activated by the EUV coronal wave.
Aims.We aim to locate the origin of a stealth coronal mass ejection (CME) detected in situ by the MAG instrument on board Solar Orbiter, and make connections between the CME observed at the Sun, and the interplanetary CME (ICME) measured in situ. Methods. Remote sensing data are analysed using advanced image processing techniques to identify the source region of the stealth CME, and the global magnetic field at the time of the eruption is examined using Potential Field Source Surface (PFSS) models. The observations of the stealth CME at the Sun are compared with the magnetic field measured by the Solar Orbiter spacecraft, and plasma properties measured by the Wind spacecraft. Results. The source of the CME is found to be a quiet Sun cavity in the northern hemisphere. We find that the stealth CME has a strong magnetic field in situ, despite originating from a quiet Sun region with an extremely weak magnetic field. Conclusions. The interaction of the ICME with its surrounding environment is the likely cause of a higher magnetic field strength measured in situ. Stealth CMEs require multi-wavelength and multi-viewpoint observations in order to confidently locate the source region, however their elusive signatures still pose many problems for space weather forecasting. The findings have implications for Solar Orbiter observing sequences with instruments such as EUI that are designed to capture stealth CMEs
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
