Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userLayer-dependent Optical and Dielectric Properties of Large-size PdSe$_2$ Films Grown by Chemical Vapor Deposition
105
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Palladium diselenide (PdSe$_2$), a new type of two-dimensional noble metal dihalides (NMDCs), has received widespread attention for its excellent electrical and optoelectronic properties. Herein, high-quality continuous centimeter-scale PdSe$_2$ films with layers in the range of 3L-15L were grown using Chemical Vapor Deposition (CVD) method. The absorption spectra and DFT calculations revealed that the bandgap of the PdSe$_2$ films decreased with increasing number of layers, which is due to PdSe$_2$ enhancement of orbital hybridization. Spectroscopic ellipsometry (SE) analysis shows that PdSe2 has significant layer-dependent optical and dielectric properties. This is mainly due to the unique strong exciton effect of the thin PdSe$_2$ film in the UV band. In particular, the effect of temperature on the optical properties of PdSe$_2$ films was also observed, and the thermo-optical coefficients of PdSe$_2$ films with different number of layers were calculated. This study provides fundamental guidance for the fabrication and optimization of PdSe$_2$-based optoelectronic devices.
rate research
Read More
The integration of graphene (Gr) with nitride semiconductors is highly interesting for applications in high-power/high-frequency electronics and optoelectronics. In this work, we demonstrated the direct growth of Gr on Al0.5Ga0.5N/sapphire templates by propane (C3H8) chemical vapor deposition (CVD) at temperature of 1350{deg}C. After optimization of the C3H8 flow rate, a uniform and conformal Gr coverage was achieved, which proved beneficial to prevent degradation of AlGaN morphology. X-ray photoemission spectroscopy (XPS) revealed Ga loss and partial oxidation of Al in the near-surface AlGaN region. Such chemical modification of a 2 nm thick AlGaN surface region was confirmed by cross-sectional scanning transmission electron microscopy (STEM) combined with electron energy loss spectroscopy (EELS), which also showed the presence of a bilayer of Gr with partial sp2/sp3 hybridization. Raman spectra indicated that the deposited Gr is nanocrystalline (with domain size 7 nm) and compressively strained. A Gr sheet resistance of 15.8 kOhm/sq was evaluated by four-point-probe measurements, consistently with the nanocrystalline nature of these films. Furthermore, nanoscale resolution current mapping by conductive atomic force microscopy (C-AFM) indicated local variations of the Gr carrier density at a mesoscopic scale, which can be ascribed to changes in the charge transfer from the substrate due to local oxidation of AlGaN or to the presence of Gr wrinkles.
Despite many efforts the origin of a ferromagnetic (FM) response in ZnMnO and ZnCoO is still not clear. Magnetic investigations of our samples, not discussed here, show that the room temperature FM response is observed only in alloys with a non-uniform Mn or Co distribution. Thus, the control of their distribution is crucial for explanation of contradicted magnetic properties of ZnCoO and ZnMnO reported till now. In the present review we discuss advantages of the Atomic Layer Deposition (ALD) growth method, which enables us to control uniformity of ZnMnO and ZnCoO alloys. Properties of ZnO, ZnMnO and ZnCoO films grown by the ALD are discussed.
Rhombohedral-stacked few-layer graphene (FLG) has been receiving an ever-increasing attention owing to its peculiar electronic properties that could lead to enticing phenomena such as superconductivity and magnetic ordering. Up to now, experimental studies on such material have been mainly limited by the difficulty in isolating it in thickness exceeding 3 atomic layers with device-compatible size. In this work, rhombohedral graphene with thickness up to 9 layers and areas up to ~50 micrometers square is grown via chemical vapor deposition (CVD) on suspended Cu foils and transferred onto target substrates via etch-free delamination. The domains of rhombohedral FLG are identified by Raman spectroscopy and are found to alternate with domains of Bernal-stacked FLG within the same crystal in a stripe-like configuration. A combined analysis of micro-Raman mapping, atomic force microscopy and optical microscopy indicates that the formation of rhombohedral-stacked FLG is strongly correlated to the copper substrate morphology. Cu step bunching results in bending of FLG and interlayer displacement along preferential crystallographic orientations, as determined experimentally by electron microscopy, thus inducing the stripe-like domains. The growth and transfer of rhombohedral FLG with the reported thickness and size shall facilitate the observation of predicted unconventional physics and ultimately add to its technological relevance.
Combining MoS$_2$ monolayers to form multilayers allows to access new functionalities. In this work, we examine the correlation between the stacking order and the interlayer coupling of valence states in MoS$_2$ homobilayer samples grown by chemical vapor deposition (CVD) and artificially stacked bilayers from CVD monolayers. We show that hole delocalization over the bilayer is allowed in 2H stacking and results in strong interlayer exciton absorption and also in a larger A-B exciton separation as compared to 3R bilayers, where both holes and electrons are confined to the individual layers. Comparing 2H and 3R reflectivity spectra allows to extract an interlayer coupling energy of about $t_perp=49$ meV. Obtaining very similar results for as-grown and artificially stacked bilayers is promising for assembling large area van der Waals structures with CVD material, using interlayer exciton absorption and A-B exciton separation as indicators for interlayer coupling. Beyond DFT calculations including excitonic effects confirm signatures of efficient interlayer coupling for 2H stacking in agreement with our experiments.
In the present study we report on properties of ZnCoO films grown at relatively low temperature by the Atomic Layer Deposition, using two reactive organic zinc precursors (dimethylzinc and diethylzinc). The use of these precursors allowed us the significant reduction of a growth temperature to below 300oC. The influence of growth conditions on the Co distribution in ZnCoO films, their structure and magnetic properties was investigated using Secondary Ion Mass Spectroscopy, Scanning Electron Microscopy, Cathodoluminescence, Energy Dispersive X-ray Spectrometry (EDX), X-ray diffraction and Superconducting Quantum Interference Device magnetometry. We achieved high uniformity of the films grown at 160{deg}C. Such films are paramagnetic. Films grown at 200{deg} and at higher temperature are nonuniform. Formation of foreign phases in such films was detected using high resolution EDX method. These samples are not purely paramagnetic and show weak ferromagnetic response at low temperature.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
