No Arabic abstract
New data for the $^mbox{nat}$V(p,x) reactions have been measured in the range 26-70 MeV, with production of the nuclides $^{47}$Sc, $^{43}$Sc, $^{44m}$Sc, $^{44g}$Sc, $^{46}$Sc, $^{48}$Sc, $^{42}$K, $^{43}$K, $^{48}$V, $^{48}$Cr, $^{49}$Cr, and $^{51}$Cr. The focus is on the production of $^{47}$Sc, a $beta^-$-emitter suitable for innovative radiotheranostic applications in nuclear medicine. The measured cross sections for this radionuclide and its contaminants are compared with the theoretical excitation functions calculated with the TALYS code. In view of novel radiopharmaceutical applications, it is essential to accurately describe these cross-sections for the evaluation of yields, purities, and dose releases. Hence, we optimize the level-density parameters of the microscopic models in the TALYS code to obtain the best possible descriptions of the new data. We consider different irradiation conditions to estimate the production yields from the cross sections determined in this work.
The production cross sections of $^{68,69}$Ge and $^{66,67}$Ga by alpha-induced reactions on $^{nat}$Zn have been measured using the stacked-foil activation method and off-line gamma-ray spectrometry from their threshold energies to 50.7 MeV. The derived cross sections were compared with the previous experimental data and the calculated values in the TENLD-2017 library. Our result shows a slightly larger amplitude than the previous data at the peak, though the peak energy is consistent with them.
The Bayesian neural network (BNN) method is used to construct a predictive model for fragment prediction of proton induced spallation reactions with the guidance of a simplified EPAX formula. Compared to the experimental data, it is found that the BNN + sEPAX model can reasonably extrapolate with less information compared with BNN method. The BNN + sEPAX method provides a new approach to predict the energy-dependent residual cross sections produced in proton-induced spallation reactions from tens of MeV/u up to several GeV/u.
$^{72}$As is a promising positron emitter for diagnostic imaging that can be employed locally using a $^{72}$Se generator. However, current reaction pathways to $^{72}$Se have insufficient nuclear data for efficient production using regional 100-200 MeV high-intensity proton accelerators. In order to address this deficiency, stacked-target irradiations were performed at LBNL, LANL, and BNL to measure the production of the $^{72}$Se/$^{72}$As PET generator system via $^{75}$As(p,x) between 35 and 200 MeV. This work provides the most well-characterized excitation function for $^{75}$As(p,4n)$^{72}$Se starting from threshold. Additional focus was given to report the first measurements of $^{75}$As(p,x)$^{68}$Ge and bolster an already robust production capability for the highly valuable $^{68}$Ge/$^{68}$Ga PET generator. Thick target yield comparisons with prior established formation routes to both generators are made. In total, high-energy proton-induced cross sections are reported for 55 measured residual products from $^{75}$As, Cu, and Ti targets, where the latter two materials were present as monitor foils. These results were compared with literature data as well as the default theoretical calculations of the nuclear model codes TALYS, CoH, EMPIRE, and ALICE. Reaction modeling at these energies is typically unsatisfactory due to few prior published data and many interacting physics models. Therefore, a detailed assessment of the TALYS code was performed with simultaneous parameter adjustments applied according to a standardized procedure. Particular attention was paid to the formulation of the two-component exciton model in the transition between the compound and pre-equilibrium regions, with a linked investigation of level density models for nuclei off of stability and their impact on modeling predictive power.
Proton-activation reactions on natural and enriched palladium samples were investigated via the activation technique in the energy range of E_p=2.75 MeV to 9 MeV, close to the upper end of the respective Gamow window of the gamma process. We have determined cross sections for 102Pd(p,gamma)103Ag, 104Pd(p,gamma)105Ag, and 105Pd(p,n)105Ag, as well as partial cross sections of 104Pd(p,n)104Ag^g, 105Pd(p,gamma)106Ag^m, 106Pd(p,n)106Ag^m, and 110Pd(p,n)110Ag^m with uncertainties between 3% and 15% for constraining theoretical Hauser-Feshbach rates and for direct use in gamma-process calculations.
Gamma-ray excitation functions have been measured for 30, 42, 54 and 66 MeV proton beams accelerated onto C + O (Mylar), Mg, Si, and Fe targets of astrophysical interest at the separate-sector cyclotron of iThemba LABS in Somerset West (Cape Town, South Africa). A large solid angle, high energy resolution detection system of the Eurogam type was used to record Gamma-ray energy spectra. Derived preliminary results of Gamma-ray line production cross sections for the Mg, Si and Fe target nuclei are reported and discussed. The current cross section data for known, intense Gamma-ray lines from these nuclei consistently extend to higher proton energies previous experimental data measured up to Ep ~ 25 MeV at the Orsay and Washington tandem accelerators. Data for new Gamma-ray lines observed for the first time in this work are also reported.