Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userOptimization of the growth of the van der Waals materials Bi2Se3 and (Bi0.5In0.5)2Se3 by molecular beam epitaxy
92
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The naturally existing chalcogenide Bi2Se3 is topologically nontrivial due to the band inversion caused by strong spin-orbit coupling inside the bulk of the material. The surface states are spin polarized, protected by the time-inversion symmetry, and thus robust to the scattering caused by non-magnetic defects. A high purity topological insulator thin film can be easily grown via molecular beam epitaxy (MBE) on various substrates to enable novel electronics, optics, and spintronics applications. However, the unique surface state properties have historically been limited by the film quality, which is evaluated by crystallinity, surface morphology, and transport data. Here we propose and investigate different MBE growth strategies to improve the quality of Bi2Se3 thin films grown by MBE. In addition, growths of topological trivial insulator (Bi0.5In0.5)2Se3 (BIS) are also investigated. BIS is often used as a buffer layer or separation layer for topological insulator heterostructures. Based on the surface passivation status, we have classified the substrates into two categories, self-passivated or unpassivated, and determine the optimal growth mechanisms on the representative sapphire and GaAs, respectively. Growth temperature is a crucial control parameter for the van der Waals epitaxy for both types of substrates. For Bi2Se3 on GaAs, the surface passivation status determines the dominant growth mechanism.
rate research
Read More
We report epitaxial growth of vanadium diselenide (VSe$_2$) thin films in the octahedrally-coordinated (1T) structure on GaAs(111)B substrates by molecular beam epitaxy. Film thickness from a single monolayer (ML) up to 30 ML is demonstrated. Structural and chemical studies using by x-ray diffraction, transmission electron microscopy, scanning tunneling microscopy and x-ray photoelectron spectroscopy indicate high quality thin films. Further studies show that monolayer VSe$_2$ films on GaAs are not air-stable and are susceptible to oxidation within a matter of hours, which indicates that a protective capping layer should be employed for device applications. This work demonstrates that VSe$_2$, a candidate van der Waals material for possible spintronic and electronic applications, can be integrated with III-V semiconductors via epitaxial growth for 2D/3D hybrid devices.
The electrical detection of the surface states of topological insulators is strongly impeded by the interference of bulk conduction, which commonly arises due to pronounced doping associated with the formation of lattice defects. As exemplified by the topological insulator Bi2Te2Se, we show that via van der Waals epitaxial growth on thin hBN substrates the structural quality of such nanoplatelets can be substantially improved. The surface state carrier mobility of nanoplatelets on hBN is increased by a factor of about 3 compared to platelets on conventional Si/SiOx substrates, which enables the observation of well-developed Shubnikov-de Haas oscillations. We furthermore demonstrate the possibility to effectively tune the Fermi level position in the films with the aid of a back gate.
We report on the controlled growth of h-BN/graphite by means of molecular beam epitaxy (MBE). X-ray photoelectron spectroscopy (XPS) suggests an interface without any reaction or intermixing, while the angle resolved photoemission spectroscopy (ARPES) measurements show that the h-BN layers are epitaxially aligned with graphite. A well-defined band structure is revealed by ARPES measurement, reflecting the high quality of the h-BN films. The measured valence band maximum (VBM) located at 2.8 eV below the Fermi level reveals the presence of undoped h-BN films (band gap ~ 6 eV). These results demonstrate that, although only weak van der Waals interactions are present between h-BN and graphite, a long range ordering of h-BN can be obtained even on polycrystalline graphite via van der Waals epitaxy, offering the prospect of large area, single layer h-BN.
The exfoliation of two naturally occurring van der Waals minerals, graphite and molybdenite, arouse an unprecedented level of interest by the scientific community and shaped a whole new field of research: 2D materials research. Several years later, the family of van der Waals materials that can be exfoliated to isolate 2D materials keeps growing, but most of them are synthetic. Interestingly, in nature plenty of naturally occurring van der Waals minerals can be found with a wide range of chemical compositions and crystal structures whose properties are mostly unexplored so far. This Perspective aims to provide an overview of different families of van der Waals minerals to stimulate their exploration in the 2D limit.
SrxBi2Se3 is a candidate topological superconductor but its superconductivity requires the intercalation of Sr by into the van-der-Waals gaps of Bi2Se3. We report the synthesis of SrxBi2Se3 thin films by molecular beam epitaxy, and we characterize their structural, vibrational and electrical properties. X-ray diffraction and Raman spectroscopy show evidence of substitutional Sr alloying into the structure, while transport measurements allow us to correlate the increasing Sr content with an increased n-type doping, but do not reveal superconductivity down to 1.5K. Our results suggest that Sr predominantly occupies sites within a quintuple layer, simultaneously substituting for Bi and as an interstitial. Our results motivate future density functional studies to further investigate the energetics of Sr substitution into Bi2Se3.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
