Electromagnetic filtering is essential for the coherent control, operation and readout of superconducting quantum circuits at milliKelvin temperatures. The suppression of spurious modes around the transition frequencies of a few GHz is well understood and mainly achieved by on-chip and package considerations. Noise photons of higher frequencies -- beyond the pair-breaking energies -- cause decoherence, and require spectral engineering before reaching the packaged quantum chip. The external wires through the refrigerator down to the quantum circuit provides a direct path, and this article contains quantitative analysis and experimental data for noise photon flux through the coaxial filtered wiring. The coaxial cable room temperature attenuation and the noise photon flux estimates for typical wiring configurations are provided, and compact cryogenic microwave low-pass filters with CR-110 and Esorb-230 absorptive dielectric fillings along with experimental data at room and cryogenic temperatures and up to 70 GHz presented. The filter cut-off frequencies between 1 to 10 GHz are set by the filter length, and the roll-off is material dependent. The relative dielectric permittivity and magnetic permeability for the Esorb-230 material in the pair-breaking frequency range from 75 to 110 GHz are measured, and the filter properties in this frequency range are calculated. The filter contribution to the noise photon flux implies a dramatic reduction, proving their usefulness for experiments with superconducting quantum systems.
Download