Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userOptimal sensor and actuator placement for feedback control of vortex shedding
74
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We consider linear feedback control of the two-dimensional flow past a cylinder at low Reynolds numbers, with a particular focus on the optimal placement of a single sensor and a single actuator. To accommodate the high dimensionality of the flow we compute its leading resolvent forcing and response modes to enable the design of H2-optimal estimators and controllers. We then investigate three control problems: i) optimal estimation (OE) in which we measure the flow at a single location and estimate the entire flow; ii) full-state information control (FIC) in which we measure the entire flow but actuate at only one location; and iii) the overall feedback control problem in which a single sensor is available for measurement and a single actuator is available for control. We characterize the performance of these control arrangements over a range of sensor and actuator placements and discuss implications for effective feedback control when using a single sensor and a single actuator. The optimal sensor and actuator placements found for the OE and FIC problems are also compared to those found for the overall feedback control problem over a range of Reynolds numbers. This comparison reveals the key factors and conflicting trade-offs that limit feedback control performance.
rate research
Read More
An investigation of optimal feedback controllers performance and robustness is carried out for vortex shedding behind a 2D cylinder at low Reynolds numbers. To facilitate controller design, we present an efficient modelling approach in which we utilise the resolvent operator to recast the linearised Navier-Stokes equations into an input-output form from which frequency responses can be computed. The difficulty of applying modern control design techniques to complex, high-dimensional flow systems is thus overcome by using low-order models identified from these frequency responses. The low-order models are used to design optimal control laws using $mathcal{H}_{infty}$ loop shaping. Two distinct control arrangements are considered, both of which employ a single-input and a single-output. In the first control arrangement, a velocity sensor located in the wake drives a pair of body forces near the cylinder. Complete suppression of shedding is observed up to a Reynolds number of $Re=110$. Due to the convective nature of vortex shedding and the corresponding time delays, we observe a fundamental trade-off: the sensor should be close enough to the cylinder to avoid any excessive time lag, but it should be kept sufficiently far from the cylinder to measure any unstable modes developing downstream. It is found that these two conflicting requirements become more difficult to satisfy for larger Reynolds numbers. In the second control arrangement, we consider a practical setup with a body-mounted force sensor and an actuator that oscillates the cylinder according to the lift measurement. It is shown that the system is stabilised only up to $Re=100$, and we demonstrate why the performance of the resulting feedback controllers deteriorates much more rapidly with increasing Reynolds number. The challenges of designing robust controllers for each control setup are also analysed and discussed.
The choice and placement of sensors and actuators is an essential factor determining the performance that can be realized using feedback control. This determination is especially important, but difficult, in the context of controlling transitional flows. The highly non-normal nature of the linearized Navier-Stokes equations makes the flow sensitive to small perturbations, with potentially drastic performance consequences on closed-loop flow control performance. Full-information controllers, such as the linear quadratic regulator (LQR), have demonstrated some success in reducing transient energy growth and suppressing transition; however, sensor-based output feedback controllers with comparable performance have been difficult to realize. In this study, we propose two methods for sensor selection that enable sensor-based output feedback controllers to recover full-information control performance: one based on a sparse controller synthesis approach, and one based on a balanced truncation procedure for model reduction. Both approaches are investigated within linear and nonlinear simulations of a sub-critical channel flow with blowing and suction actuation at the walls. We find that sensor configurations identified by both approaches allow sensor-based static output feedback LQR controllers to recover full-information LQR control performance, both in reducing transient energy growth and suppressing transition. Further, our results indicate that both the sensor selection methods and the resulting controllers exhibit robustness to Reynolds number variations.
The present article represents part of the PhD. dissertation by C. Josserand. We discuss the nucleation of quantized vortices in the nonlinear Schr{o}dinger equation (NLS) for a flow around a disk in two spatial dimensions. It appears that the vortices are nucleated when the flow becomes locally (at the edge of the disk) supersonic. A detailed study of the phase equation for the complex field $psi$ gives an Euler-Tricomi type equation for the stationary solutions below threshold. This equation is closely related to the one known in shock wave dynamics for gas. Then using solvability condition, we extract a time-dependent scenario for the evolution of the amplitude of the solution, which we, finally, relate to a known family solution of NLS which gives rise to a vortex nucleation. We also give a first order correction at the Landau velocity of nucleation, taking into account the geometry of the flow.
Unsteady laminar vortex shedding over a circular cylinder is predicted using a deep learning technique, a generative adversarial network (GAN), with a particular emphasis on elucidating the potential of learning the solution of the Navier-Stokes equations. Numerical simulations at two different Reynolds numbers with different time-step sizes are conducted to produce training datasets of flow field variables. Unsteady flow fields in the future at a Reynolds number which is not in the training datasets are predicted using a GAN. Predicted flow fields are found to qualitatively and quantitatively agree well with flow fields calculated by numerical simulations. The present study suggests that a deep learning technique can be utilized for prediction of laminar wake flow in lieu of solving the Navier-Stokes equations.
Wireless sensor-actuator networks offer flexibility for control design. One novel element which may arise in networks with multiple nodes is that the role of some nodes does not need to be fixed. In particular, there is no need to pre-allocate which nodes assume controller functions and which ones merely relay data. We present a flexible architecture for networked control using multiple nodes connected in series over analog erasure channels without acknowledgments. The control architecture proposed adapts to changes in network conditions, by allowing the role played by individual nodes to depend upon transmission outcomes. We adopt stochastic models for transmission outcomes and characterize the distribution of controller location and the covariance of system states. Simulation results illustrate that the proposed architecture has the potential to give better performance than limiting control calculations to be carried out at a fixed node.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
