Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userPatterning enhanced tetragonality in BiFeO3 thin films with effective negative pressure by helium implantation
107
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Helium implantation in epitaxial thin films is a way to control the out-of-plane deformation independently from the in-plane strain controlled by epitaxy. In particular, implantation by means of a helium microscope allows for local implantation and patterning down to the nanometer resolution, which is of interest for device applications. We present here a study of bismuth ferrite (BiFeO3) films where strain was patterned locally by helium implantation. Our combined Raman, XRD and TEM study shows that the implantation causes an elongation of the BiFeO3 unit cell and ultimately a transition towards the so-called super-tetragonal polymorph via states with mixed phases. In addition, TEM reveals the onset of amorphization at a threshold dose that does not seem to impede the overall increase in tetragonality. The phase transition from the R-like to T-like BiFeO3 appears as first-order in character, with regions of phase coexistence and abrupt changes in lattice parameters.
rate research
Read More
Defect engineering has been a powerful tool to enable the creation of exotic phases and the discovery of intriguing phenomena in ferroelectric oxides. However, accurate control the concentration of defects remains a big challenge. In this work, ion implantation, that can provide controllable point defects, allows us the ability to produce a controlled defect-driven true super-tetragonal (T) phase with enhanced tetragonality in ferroelectric BiFeO3 thin films. This point defect engineering is found to drive the phase transition from the as-grown mixed rhombohedral-like (R) and tetragonal-like (MC) phase to true tetragonal (T) symmetry. By further increasing the injected dose of He ion, we demonstrate an enhanced tetragonality super-tetragonal (super-T) phase with the largest c/a ratio (~ 1.3) that has ever been experimentally achieved in BiFeO3. A combination of morphology change and domain evolution further confirm that the mixed R/MC phase structure transforms to the single-domain-state true tetragonal phase. Moreover, the re-emergence of R phase and in-plane stripe nanodomains after heat treatment reveal the memory effect and reversible phase transition. Our findings demonstrate the control of R-Mc-T-super T symmetry changes and the creation of true T phase BiFeO3 with enhanced tetragonality through controllable defect engineering. This work also provides a pathway to generate large tetragonality (or c/a ratio) that could be extended to other ferroelectric material systems (such as PbTiO3, BaTiO3 and HfO2) which may lead to strong polarization enhancement.
BiFeO$_3$ (BFO) shows both ferroelectricity and magnetic ordering at room temperature but its ferromagnetic component, which is due to spin canting, is negligible. Substitution of transition-metal atoms such as Co for Fe is known to enhance the ferromagnetic component in BFO. In order to reveal the origin of such magnetization enhancement, we performed soft x-ray absorption spectroscopy (XAS) and soft x-ray magnetic circular dichroism (XMCD) studies of BiFe$_{1-x}$Co$_x$O$_3$ ({it x} = 0 to 0.30) (BFCO) thin films grown on LaAlO$_3$(001) substrates. The XAS results indicated that the Fe and Co ions are in the Fe$^{3+}$ and Co$^{3+}$ states. The XMCD results showed that the Fe ions show ferromagnetism while the Co ions are antiferromagnetic at room temperature. The XAS and XMCD measurements also revealed that part of the Fe$^{3+}$ ions are tetrahedrally co-ordinated by oxygen ions but that the XMCD signals of the octahedrally coordinated Fe$^{3+}$ ions increase with Co content. The results suggest that an impurity phase such as the ferrimagnetic $gamma$-Fe$_2$O$_3$ which exists at low Co concentration decreases with increasing Co concentration and that the ferromagnetic component of the Fe$^{3+}$ ion in the octrahedral crystal fields increases with Co concentration, probably reflecting the increased canting of the Fe$^{3+}$ ions.
We demonstrate a direct correlation between the domain structure of multiferroic BiFeO3 thin films and exchange bias of Co0.9Fe0.1/BiFeO3 heterostructures. Two distinct types of interactions, an enhancement of the coercive field (exchange enhancement) and an enhancement of the coercive field combined with large shifts of the hysteresis loop (exchange bias), have been observed in these heterostructures, which depend directly on the type and crystallography of the nanoscale (2 nm) domain walls in the BiFeO3 film. We show that the magnitude of the exchange bias interaction scales with the length of 109 degree ferroelectric domain walls in the BiFeO3 thin films which have been probed via piezoresponse force microscopy and x-ray magnetic circular dichroism.
In this work we report on the controlled fabrication of a self-assembled line network in highly epitaxial BiFeO3 thin films on top of LaAlO3 in the kinetically limited grown region by RF sputtering. As previously shown in the case of manganite thin films, the remarkable degree of ordering is achieved using vicinal substrates with well-defined step-terrace morphology. Nanostructured BiFeO3 thin films show mixed-phase morphology. Besides typical formation following (100) and (010) axes, some mixed phase nanodomains are detected also in-between the regular line network. These particular microstructures open a playground for future applications in multiferroic nanomaterials.
The nanostructural evolution of the strain-induced structural phase transition in BiFeO3 is examined. Using high-resolution X-ray diffraction and scanning-probe microscopy-based studies we have uniquely identified and examined the numerous phases present at these phase boundaries and have discovered an intermediate monoclinic phase in addition to the previously observed rhombohedral- and tetragonal-like phases. Further analysis has determined that the so-called mixed-phase regions of these films are not mixtures of rhombohedral- and tetragonal-like phases, but intimate mixtures of highly-distorted monoclinic phases with no evidence for the presence of the rhombohedral-like parent phase. Finally, we propose a mechanism for the enhanced electromechanical response in these films including how these phases interact at the nanoscale to produce large surface strains.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
