Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userConfirming ALMA Calibration using Planck and ACT Observations
60
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We test the accuracy of ALMA flux density calibration by comparing ALMA flux density measurements of extragalactic sources to measurements made by the Planck mission; Planck is absolutely calibrated to sub-percent precision using the dipole signal induced by the satellites orbit around the solar system barycenter. Planck observations ended before ALMA began systematic observations, however, and many of the sources are variable, so we employ measurements by the Atacama Cosmology Telescope (ACT) to bridge the two epochs. We compare ACT observations at 93 and $sim$145 GHz to Planck measurements at 100 and 143 GHz and to ALMA measurements made at 91.5 and 103.5 GHz in Band 3. For both comparisons, flux density measurements were corrected to account for the small differences in frequency using the best available spectral index for each source. We find the ALMA flux density scale (based on observations of Uranus) is consistent with Planck. All methods used to make the comparison are consistent with ALMA flux densities in Band 3 averaging 0.99 times those measured by Planck. One specific test gives ALMA/Planck = $0.996 pm 0.024.$ We also test the absolute calibration of both ACT at 93 and $sim$145 GHz and the South Pole Telescope (SPT) at 97.43, 152.9 and 215.8 GHz, again with reference to Planck measurements at 100, 143 and 217 GHz, as well as the internal consistency of measurements of compact sources made by all three instruments.
rate research
Read More
ALMA 870$mu$m continuum imaging has uncovered a population of blends of multiple dusty star-forming galaxies (DSFGs) in sources originally detected with the Herschel Space Observatory. However, their pairwise separations are much smaller that what is found by ALMA follow-up of other single-dish surveys or expected from theoretical simulations. Using ALMA and VLA, we have targeted three of these systems to confirm whether the multiple 870$mu$m continuum sources lie at the same redshift, successfully detecting $^{12}$CO($J = 3$-2) and $^{12}$CO($J = 1$-0) lines and being able to confirm that in the three cases all the multiple DSFGs are likely physically associated within the same structure. Therefore, we report the discovery of two new gas-rich dusty protocluster cores (HELAISS02, $z = 2.171 pm 0.004$; HXMM20, $z = 2.602 pm 0.002$). The third target is located in the well known COSMOS overdensity at $z = 2.51$ (named CL J1001+0220 in the literature), for which we do not find any new secure CO(1-0) detection, although some of its members show only tentative detections and require further confirmation. From the gas, dust, and stellar properties of the two new protocluster cores, we find very large molecular gas fractions yet low stellar masses, pushing the sources above the main sequence, while not enhancing their star formation efficiency. We suggest that the sources might be newly formed galaxies migrating to the main sequence. The properties of the three systems compared to each other and to field galaxies may suggest a different evolutionary stage between systems.
We present a detailed description of the special procedures for calibration and quality assurance of Atacama Large Millimeter/submillimeter Array (ALMA) observations in Very Long Baseline Interferometry (VLBI) mode. These procedures are required to turn the phased ALMA array into a fully calibrated VLBI station. As an illustration of these methodologies, we present full-polarization observations carried out with ALMA as a phased array at 3mm (Band 3) and 1.3mm (Band 6) as part of Cycle-4. These are the first VLBI science observations conducted with ALMA and were obtained during a 2017 VLBI campaign in concert with other telescopes worldwide as part of the Global mm-VLBI Array (GMVA, April 1-3) and the Event Horizon Telescope (EHT, April 5-11) in ALMA Bands 3 and 6, respectively.
The pressure of hot gas in groups and clusters of galaxies is a key physical quantity, which is directly linked to the total mass of the halo and several other thermodynamical properties. In the wake of previous observational works on the hot gas pressure distribution in massive halos, we have investigated a sample of 31 clusters detected in both the Planck and Atacama Cosmology Telescope (ACT), MBAC surveys. We made use of an optimised Sunyaev-Zeldovich (SZ) map reconstructed from the two data sets and tailored for the detection of the SZ effect, taking advantage of both Planck coverage of large scales and the ACT higher spatial resolution. Our average pressure profile covers a radial range going from 0.04xR_500 in the central parts to 2.5xR_500 in the outskirts. In this way, it improves upon previous pressure-profile reconstruction based on SZ measurements. It is compatible, as well as competitive, with constraints derived from joint X-ray and SZ analysis. This work demonstrates the possibilities offered by large sky surveys of the SZ effect with multiple experiments with different spatial resolutions and spectral coverages, such as ACT and Planck.
We discuss the methods employed to photometrically calibrate the data acquired by the Low Frequency Instrument on Planck. Our calibration is based on a combination of the Orbital Dipole plus the Solar Dipole, caused respectively by the motion of the Planck spacecraft with respect to the Sun and by motion of the Solar System with respect to the CMB rest frame. The latter provides a signal of a few mK with the same spectrum as the CMB anisotropies and is visible throughout the mission. In this data release we rely on the characterization of the Solar Dipole as measured by WMAP. We also present preliminary results (at 44GHz only) on the study of the Orbital Dipole, which agree with the WMAP value of the Solar System speed within our uncertainties. We compute the calibration constant for each radiometer roughly once per hour, in order to keep track of changes in the detectors gain. Since non-idealities in the optical response of the beams proved to be important, we implemented a fast convolution algorithm which considers the full beam response in estimating the signal generated by the dipole. Moreover, in order to further reduce the impact of residual systematics due to sidelobes, we estimated time variations in the calibration constant of the 30GHz radiometers (the ones with the largest sidelobes) using the signal of a reference load. We have estimated the calibration accuracy in two ways: we have run a set of simulations to assess the impact of statistical errors and systematic effects in the instrument and in the calibration procedure, and we have performed a number of consistency checks on the data and on the brightness temperature of Jupiter. Calibration errors for this data release are expected to be about 0.6% at 44 and 70 GHz, and 0.8% at 30 GHz. (Abriged.)
We present a description of the pipeline used to calibrate the Planck Low Frequency Instrument (LFI) timelines into thermodynamic temperatures for the Planck 2015 data release, covering four years of uninterrupted operations. As in the 2013 data release, our calibrator is provided by the spin-synchronous modulation of the cosmic microwave background dipole, but we now use the orbital component, rather than adopting the Wilkinson Microwave Anisotropy Probe (WMAP) solar dipole. This allows our 2015 LFI analysis to provide an independent Solar dipole estimate, which is in excellent agreement with that of HFI and within $1sigma$ (0.3% in amplitude) of the WMAP value. This 0.3% shift in the peak-to-peak dipole temperature from WMAP and a global overhaul of the iterative calibration code increases the overall level of the LFI maps by 0.45% (30 GHz), 0.64% (44 GHz), and 0.82% (70 GHz) in temperature with respect to the 2013 Planck data release, thus reducing the discrepancy with the power spectrum measured by WMAP. We estimate that the LFI calibration uncertainty is now at the level of 0.20% for the 70 GHz map, 0.26% for the 44 GHz map, and 0.35% for the 30 GHz map. We provide a detailed description of the impact of all the changes implemented in the calibration since the previous data release.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
