Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userImpact of Surface Chemistry of Silicon Nanoparticles on the Structural and Electrochemical Properties of Si/Ni3.4Sn4 Com-posite Anode for Li-Ion Batteries
175
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Embedding silicon nanoparticles in an intermetallic matrix is a promising strategy to produce remarkable bulk anode materials for lithium-ion (Li-ion) batteries with low potential, high electrochemical capacity and good cycling stability. These composite materials can be synthetized at a large scale using mechanical milling. However, for Si-Ni3Sn4 composites, milling also induces a chemical reaction between the two components leading to the formation of free Sn and NiSi2, which is detrimental to the performance of the electrode. To prevent this reaction, a modification of the surface chemistry of the silicon has been undertaken. Si nanoparticles coated with a surface layer of either carbon or oxide were used instead of pure silicon. The influence of the coating on the composition, (micro)structure and electrochemical properties of Si-Ni3Sn4 composites is studied and compared with that of pure Si. Si coating strongly reduces the reaction between Si and Ni3Sn4 during milling. Moreover, contrary to pure silicon, Si-coated composites have a plate-like mor-phology in which the surface-modified silicon particles are surrounded by a nanostructured, Ni3Sn4-based matrix leading to smooth potential profiles during electrochemical cycling. The chemical homogeneity of the matrix is more uniform for carbon-coated than for oxygen-coated silicon. As a consequence, different electrochemical behaviors are obtained depending on the surface chemistry, with better lithiation properties for the carbon-covered silicon able to deliver over 500 mAh/g for at least 400 cycles.
rate research
Read More
Varying the amounts of silicon and carbon, different composites have been prepared by ball milling of Si, Ni$_{3.4}$Sn$_4$, Al and C. Silicon and carbon contents are varied from 10 to 30 wt.% Si, and 0 to 20 wt.% C. The microstructural and electrochemical properties of the composites have been investigated by X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM) and electrochemical galvanostatic cycling up to 1000 cycles. Impact of silicon and carbon contents on the phase occurrence, electrochemical capacity and cycle-life are compared and discussed. For C-content comprised between 9 and 13 wt.% and Si-content >= 20 wt.%, Si nanoparticles are embedded in a Ni$_{3.4}$Sn$_4$-Al-C matrix which is chemically homogeneous at the micrometric scale. For other carbon contents and low Si-amount (10 wt.%), no homogeneous matrix is formed around Si nanoparticles. When homogenous matrix is formed, both Ni$_3$Sn$_4$ and Si participate to the reversible lithiation mechanism, whereas no reaction between Ni$_3$Sn$_4$ and Li is observed for no homogenous matrix. Moreover, best cycle-life performances are obtained when Si nanoparticles are embedded in a homogenous matrix and Si-content is moderate (<= 20 wt.%). Composites with carbon in the 9-13 wt.% range and 20 wt.% silicon lead to the best balance between capacity and life duration upon cycling. This work experimentally demonstrates that embedding Si in an intermetallic/carbon matrix allows to efficiently accommodate Si volume changes on cycling to ensure long cycle-life.
The capacity and stability of constituent electrodes determine the performance of Li-ion batteries. In this study, density functional theory is employed to explore the potential application of recently synthesized two dimensional phosphorene as electrode materials. Our results show that Li atoms can bind strongly with phosphorene monolayer and double layer with significant electron transfer. Besides, the structure of phosphorene is not much influenced by lithiation and the volume change is only 0.2%. A semiconducting to metallic transition is observed after lithiation. The diffusion barrier is calculated to 0.76 and 0.72 eV on monolayer and double layer phosphorene. The theoretical specific capacity of phosphorene monolayer is 432.79 mAh/g, which is larger than other commercial anodes materials. Our findings show that the high capacity, low open circuit voltage, small volume change and electrical conductivity of phosphorene make it a good candidate as electrode material.
For a successful integration of silicon in high-capacity anodes of Li-ion batteries, its intrinsic capacity decay on cycling due to severe volume swelling should be minimized. In this work, Ni-Sn intermetallics are studied as buffering matrix during reversible lithiation of Si-based anodes. Si/Ni-Sn composites have been synthetized by mechanical milling using C and Al as process control agents. Ni3Sn4, Ni3Sn2 intermetallics and their bi-phasic mixture were used as constituents of the buffering matrix. The structure, composition and morphology of the composites have been analyzed by X-ray diffraction (XRD), 119Sn Transmission Mossbauer Spectroscopy (TMS) and scanning electron microscopy (SEM). They consist of ~ 150 nm Si nanoparticles embedded in a multi-phase matrix, the nanostructuration of which improves on increasing the Ni3Sn4 amount. The electrochemical properties of the composites were analyzed by galvanostatic cycling in half-cells. Best results for practical applications are found for the bi-phasic matrix Ni3Sn4-Ni3Sn2 in which Ni3Sn4 is electrochemically active while Ni3Sn2 is inactive. Low capacity loss, 0.04 %/cycle, and high coulombic efficiency, 99.6%, were obtained over 200 cycles while maintaining a high reversible capacity above 500 mAh/g at moderate regime C/5
The diversified essential properties of the stage-n graphite alkali-intercalation compounds are thoroughly explored by the first-principles calculations. According to their main features, the lithium and non-lithium materials might be quite different from each other in stacking configurations, the intercalated alkali-atom concentrations, the free conduction electron densities, and the atom-dominated & (carbon, alkali)-co-dominated energy bands. The close relations between the alkali-doped metallic behaviors and the geometric symmetries will be clarified through the interlayer atomic interactions, in which the significant alkali-carbon chemical bondings are fully examined from the atom- and orbital-decomposed van Hove singularities. The blue shift of the Fermi level, the n-type doping, is clearly identified from the low-energy features of the density of states. This study is able to provide the partial information about anode of Li+-based battery. There are certain important differences between AC$_6$/AC$_8$ and Li$_8$Si$_4$O$_{12}$.
Graphyne, a single atomic layer structure of the carbon six-member rings connected by one acetilenic linkage, is a promising anode of rechargeable batteries. In this paper, a first-principle study has been carried out on graphyne as a new candidate for the anode material of magnesium-ion batteries, using density functional theory calculations. The main focus is on the magnesium adsorption on graphyne surface. The structural properties such as adsorption height and energy, the most stable adsorption sites, the Band structure and DOS of the pristine graphyne the diverse Mg-decorated graphyne structures, and energy barrier against Mg diffusion are also calculated. As a consequence of the band structure and DOS of graphyne structures, it is found that the pristine graphyne and the Mg-decorated graphyne structures show a semiconducting nature and metallic behavior, respectively. Moreover, the migration behavior of Mg on graphyne for the main diffusion paths is determined by the Nudged Elastic Band (NEB) method.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
