Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userUltra-shallow junction electrodes in low-loss silicon micro-ring resonators
73
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Electrodes in close proximity to an active area of a device are required for sufficient electrical control. The integration of such electrodes into optical devices can be challenging since low optical losses must be retained to realise high quality operation. Here, we demonstrate that it is possible to place a metallic shallow phosphorus doped layer in a silicon micro-ring cavity that can function at cryogenic temperatures. We verify that the shallow doping layer affects the local refractive index while inducing minimal losses with quality factors up to 10$^5$. This demonstration opens up a pathway to the integration of an electronic device, such as a single-electron transistor, into an optical circuit on the same material platform.
rate research
Read More
Electro-optic modulators with low voltage and large bandwidth are crucial for both analog and digital communications. Recently, thin-film lithium niobate modulators have enable dramatic performance improvements by reducing the required modulation voltage while maintaining high bandwidths. However, the reduced electrode gaps in such modulators leads to significantly higher microwave losses, which limit electro-optic performance at high frequencies. Here we overcome this limitation and achieve a record combination of low RF half-wave voltage of 1.3 V while maintaining electro-optic response with 1.8-dB roll-off at 50 GHz. This demonstration represents a significant improvement in voltage-bandwidth limit, one that is comparable to that achieved when switching from legacy bulk to thin-film lithium niobate modulators. Leveraging the low-loss electrode geometry, we show that sub-volt modulators with $>$ 100 GHz bandwidth can be enabled.
We demonstrate an ultra-compact waveguide taper in Silicon Nitride platform. The proposed taper provides a coupling-efficiency of 95% at a length of 19.5 um in comparison to the standard linear taper of length 50 um that connects a 10 um wide waveguide to a 1 um wide photonic wire. The taper has a spectral response > 75% spanning over 800 nm and resilience to fabrication variations; >200 nm change in taper and end waveguide width varies transmission by <5%. We experimentally demonstrate taper insertion loss of <0.1 dB/transition for a taper as short as 19.5 um, and reduces the footprint of the photonic device by 50.8% compared to the standard adiabatic taper. To the best of our knowledge, the proposed taper is the shortest waveguide taper ever reported in Silicon Nitride.
We demonstrate continuous tuning of the squeezing level generated in a double-ring optical parametric oscillator by externally controlling the coupling condition using electrically controlled integrated microheaters. We accomplish this by utilizing the avoided crossing exhibited by a pair of coupled silicon nitride microring resonators. We directly detect a change in the squeezing level from 0.5 dB in the undercoupled regime to 2 dB in the overcoupled regime, which corresponds to a change in the generated on-chip squeezing factor from 0.9 dB to 3.9 dB. Such wide tunability in the squeezing level can be harnessed for on-chip quantum enhanced sensing protocols which require an optimal degree of squeezing.
We demonstrate advanced integrated photonic filters in silicon-on-insulator (SOI) nanowires implemented by cascaded Sagnac loop reflector (CSLR) resonators. We investigate mode splitting in these standing-wave (SW) resonators and demonstrate its use for engineering the spectral profile of on-chip photonic filters. By changing the reflectivity of the Sagnac loop reflectors (SLRs) and the phase shifts along the connecting waveguides, we tailor mode splitting in the CSLR resonators to achieve a wide range of filter shapes for diverse applications including enhanced light trapping, flat-top filtering, Q factor enhancement, and signal reshaping. We present the theoretical designs and compare the CSLR resonators with three, four, and eight SLRs fabricated in SOI. We achieve versatile filter shapes in the measured transmission spectra via diverse mode splitting that agree well with theory. This work confirms the effectiveness of using CSLR resonators as integrated multi-functional SW filters for flexible spectral engineering.
A novel thin-film LiNbO3 (TFLN) electro-optic modulator is proposed and demonstrated. LiNbO3-silica hybrid waveguide is adopted to maintain low optical loss for an electrode spacing as narrow as 3 {mu}m, resulting in a record low half-wave-voltage length product of only 1.7 V*cm. Capacitively loaded traveling-wave electrodes (CL-TWEs) are employed to reduce the microwave loss, while quartz substrate is used in place of silicon substrate to achieve velocity matching. The fabricated TFLN modulator with a 5-mm-long modulation region exhibits a half-wave-voltage of 3.4 V and merely 1.3 dB roll-off in electro-optic response up to 67 GHz, and a 3-dB modulation bandwidth over 110 GHz is predicted.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
