Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userUncovering the origin of the emitting states in Bi3+-activated CaMO3 (M = Zr, Sn, Ti) perovskites: metal-to-metal charge transfer versus s-p transitions
49
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
After more than a century of studies on the optical properties of Bi3+ ions, the assignment of the nature of the emissions and the bands of the absorption spectra remain ambiguous. Here, we report an insight into the spectroscopy of Bi3+-activated CaMO3 perovskites (M = Zr, Sn, and Ti), discussing the factors driving the metal-to-metal charge transfer and sp -> s2 transitions. With the aim to figure out the whole scenario, a combined experimental and theoretical approach is employed. The comparison between the temperature dependence of the photoluminescence emissions with the temperature dependence of the exciton energy of the systems has led to an unprecedented evidence of the chargetransfer character of the emitting states in Bi3+-activated phosphors. Low-temperature vacuum ultraviolet spectroscopy together with the design of the vacuum-referred binding energy diagram of the luminescent center is exploited to shed light on the origin of the absorption bands. In addition, the X-ray absorption near the edge structure unambiguously confirmed the stabilization of Bi3+ in the Ca2+ site in both CaSnO3 and CaZrO3 perovskites. This breakthrough into the understanding of the excited-state origin of Bi3+ could pave the way toward the design of a new generation of effective Bi3+-activated phosphors.
rate research
Read More
The samples LaCoO3 with dilute substitutions on cobalt sites have been studied using the resistivity, thermopower and magnetic susceptibility measurements over the temperature range up to ~900 K. The Co-site substitution does not affect the magnetic transition at ~100 K and the onset of massive population of hole carriers at ~500 K, characteristic for undoped LaCoO3. On the other hand, the low-temperature transport and magnetism is markedly distinct for samples with extra charge on cobalt ions introduced by the heterovalent dopants (Mg2+, Ti4+) compared to samples with minor non-stoichiometry (LaCoO3, Ga3+ doped sample). Magnetic properties suggest that these extra charges create thermally stable magnetic polarons of total S ~ 2-3. Common features of Co-site doped and La-site doped samples (La1-xSrxCoO3) are discussed
The mechanisms that drive metal-to-insulator transitions (MIT) in correlated solids are not fully understood. For example, the perovskite (PV) SrCoO3 is a FM metal while the oxygen-deficient (n-doped) brownmillerite (BM) SrCoO2.5 is an anti-ferromagnetic (AFM) insulator. Given the magnetic and structural transitions that accompany the MIT, the driver for such a MIT transition is unclear. We also observe that the perovskite metals LaNiO3, SrFeO3, and SrCoO3 also undergo MIT when n-doped via high-to-low valence compositional changes. Also, pressurizing the insulating BM SrCoO2.5 phase, drives a gap closing. Using DFT and correlated diffusion Monte Carlo approaches we demonstrate that the ABO3 perovskites most prone to MIT are self hole-doped materials, reminiscent of a negative charge-transfer system. Upon n-doping away from the negative-charge transfer metallic phase, an underlying charge-lattice (or e-phonon) coupling drives the system to a bond-disproportionated gapped state, thereby achieving ligand hole passivation at certain sites only, leading to charge-disproportionated states. The size of the gap opened is correlated with the size of the hole-filling at these ligand sites. This suggests that the interactions driving the gap opening to realize a MIT even in correlated metals is the charge-transfer energy, but it couples with the underlying phonons to enable the transition to the insulating phase. Other orderings (magnetic, charge, etc.) driven by weaker interactions are secondary and may assist gap openings at small dopings, but its the charge-transfer energy that predominantly determines the bandgap, with a negative energy preferring the metallic phase. This n-doping can be achieved by modulations in stoichiometry or composition or pressure. Hence, controlling the amount of the ligand-hole is key in controlling MIT. We compare our predictions to experiments where possible.
Metal contacts are a key limiter to the electronic performance of two-dimensional (2D) semiconductor devices. Here we present a comprehensive study of contact interfaces between seven metals (Y, Sc, Ag, Al, Ti, Au, Ni, with work functions from 3.1 to 5.2 eV) and monolayer MoS2 grown by chemical vapor deposition. We evaporate thin metal films onto MoS2 and study the interfaces by Raman spectroscopy, X-ray photoelectron spectroscopy, X-ray diffraction, transmission electron microscopy, and electrical characterization. We uncover that, 1) ultrathin oxidized Al dopes MoS2 n-type (> 2x10^12 1/cm^2) without degrading its mobility, 2) Ag, Au, and Ni deposition causes varying levels of damage to MoS2 (broadening Raman E peak from <3 1/cm to >6 1/cm), and 3) Ti, Sc, and Y react with MoS2. Reactive metals must be avoided in contacts to monolayer MoS2, but control studies reveal the reaction is mostly limited to the top layer of multilayer films. Finally, we find that 4) thin metals do not significantly strain MoS2, as confirmed by X-ray diffraction. These are important findings for metal contacts to MoS2, and broadly applicable to many other 2D semiconductors.
Using density-functional theory calculations, we analyze the optical absorption properties of lead (Pb)-free metal halide perovskites (AB$^{2+}$X$_3$) and double perovskites (AB$^+$B$^{3+}$X$_6$) (A = Cs or monovalent organic ion, B$^{2+}$ = non-Pb divalent metal, B$^+$ = monovalent metal, B$^{3+}$ = trivalent metal, X = halogen). We show that, if B$^{2+}$ is not Sn or Ge, Pb-free metal halide perovskites exhibit poor optical absorptions because of their indirect bandgap nature. Among the nine possible types of Pb-free metal halide double perovskites, six have direct bandgaps. Of these six types, four show inversion symmetry-induced parity-forbidden or weak transitions between band edges, making them not ideal for thin-film solar cell application. Only one type of Pb-free double perovskite shows optical absorption and electronic properties suitable for solar cell applications, namely those with B$^+$ = In, Tl and B$^{3+}$ = Sb, Bi. Our results provide important insights for designing new metal halide perovskites and double perovskites for optoelectronic applications.
Integrating multiple properties in a single system is crucial for the continuous developments in electronic devices. However, some physical properties are mutually exclusive in nature. Here, we report the coexistence of two seemingly mutually exclusive properties-polarity and two-dimensional conductivity-in ferroelectric Ba$_{0.2}$Sr$_{0.8}$TiO$_3$ thin films at the LaAlO$_3$/Ba$_{0.2}$Sr$_{0.8}$TiO$_3$ interface at room temperature. The polarity of a ~3.2 nm Ba$_{0.2}$Sr$_{0.8}$TiO$_3$ thin film is preserved with a two-dimensional mobile carrier density of ~0.05 electron per unit cell. We show that the electronic reconstruction resulting from the competition between the built-in electric field of LaAlO$_3$ and the polarization of Ba$_{0.2}$Sr$_{0.8}$TiO$_3$ is responsible for this unusual two-dimensional conducting polar phase. The general concept of exploiting mutually exclusive properties at oxide interfaces via electronic reconstruction may be applicable to other strongly-correlated oxide interfaces, thus opening windows to new functional nanoscale materials for applications in novel nanoelectronics.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
