Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userNanoscale control of LaAlO3/SrTiO3 metal-insulator transition using ultra-low-voltage electron-beam lithography
80
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We describe a method to control the insulator-metal transition at the LaAlO3/SrTiO3 interface using ultra-low-voltage electron beam lithography (ULV-EBL). Compared with previous reports that utilize conductive atomic-force-microscope lithography (c-AFM), this approach can provide comparable resolution (~10 nm) at write speeds (10 mm/s) that are up to 10,000x faster than c-AFM. The writing technique is non-destructive and the conductive state is reversible via prolonged exposure to air. Transport properties of representative devices are measured at milli-Kelvin temperatures, where superconducting behavior is observed. We also demonstrate the ability to create conducting devices on graphene/LaAlO3/SrTiO3 heterostructures. The underlying mechanism is believed to be closely related to the same mechanism regulating c-AFM-based methods.
rate research
Read More
Recently superconductivity at the interface between the insulators LaAlO3 and SrTiO3 has been tuned with the electric field effect to an unprecedented range of transition temperatures. Here we perform a detailed finite size scaling analysis to explore the compatibility of the phase transition line with Berezinskii-Kosterlitz-Thouless (BKT) behavior and a 2D-quantum phase(QP)-transition. In an intermediate regime, limited by a gate voltage dependent limiting length, we uncover remarkable consistency with a BKT-critical line ending at a metallic quantum critical point, separating a weakly localized insulator from the superconducting phase. Our estimates for the critical exponents of the 2D-QP-transition, z=1 and nu=0.66, suggest that it belongs to the 3D-xy universality class.
Nanophotonic (nanoplasmonic) structures confine, guide, and concentrate light on the nanoscale. Advancement of nanophotonics critically depends on active nanoscale control of these phenomena. Localized control of the insulator and metallic phases of vanadium dioxide (VO2) would open up a universe of applications in nanophotonics via modulation of the local dielectric environment of nanophotonic structures allowing them to function as active devices. Here we show dynamic reversible control of VO2 insulator-to-metal transition (IMT) locally on the scale of 15 nm or less and control of nanoantennas, observed in the near-field for the first time. Using polarization-selective near-field imaging techniques, we monitor simultaneously the IMT in VO2 and the change of plasmons on gold infrared nanoantennas. Structured nanodomains of the metallic VO2 locally and reversibly transform infrared plasmonic dipolar antennas to monopole antennas. Fundamentally, the IMT in VO2 can be triggered on femtosecond timescale to allow ultrafast nanoscale control of optical phenomena. These unique capabilities open up exciting novel applications in active nanophotonics.
A new method to fabricate non-superconducting mesoscopic tunnel junctions by oxidation of Ti is presented. The fabrication process uses conventional electron beam lithography and shadow deposition through an organic resist mask. Superconductivity in Ti is suppressed by performing the deposition under a suitable background pressure. We demonstrate the method by making a single electron transistor which operated at $T < 0.4$ K and had a moderate charge noise of $2.5 times 10^{-3}$ e/$sqrt{mathrm{Hz}}$ at 10 Hz. Based on nonlinearities in the current-voltage characteristics at higher voltages, we deduce the oxide barrier height of approximately 110 mV.
We report superconductivity in quasi-1D nanostructures created at the LaAlO3/SrTiO3 interface. Nanostructures having line widths w~10 nm are formed from the parent two-dimensional electron liquid using conductive atomic force microscope lithography. Nanowire cross-sections are small compared to the superconducting coherence length in LaAlO3/SrTiO3 (w<<xi~100 nm), placing them in the quasi-1D regime. Broad superconducting transitions with temperature and finite resistances in the superconducting state well below Tc~200 mK are observed. V-I curves show switching between the superconducting and normal states that are characteristic of superconducting nanowires. The four-terminal resistance in the superconducting state shows an unusual dependence on the current path, varying by as much as an order of magnitude.
We investigated metal-insulator transitions for double layer two-dimensional electron hole systems in transition metal dicalcogenides (TMDC) stacked on opposite sides of thin layers of boron nitride (BN). The interparticle interaction is calculated by including the screening due to the polarization charges at different interfaces, including that at the encapsultion and the substrate of experimental structures. We compute and compare the energies of the metallic electron-hole plasma and the newly proposed insulating exciton solid with fixed-node diffusion Monte Carlo simulation including the high valley degeneracy of the electron bands. We found that for some examples of current experimental structures, the transition electron/hole density is in an accessible range of g x 10^12 /cm*2 with g between 4.1 and 14.5 for spacer thicknesses between 2.5 and 7.5 nm. Our result raise the possibility of exploiting this effect for logic device applications.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
