Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userAnisotropic Radio-Wave Scattering and the Interpretation of Solar Radio Emission Observations
126
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The observed properties (i.e., source size, source position, time duration, decay time) of solar radio emission produced through plasma processes near the local plasma frequency, and hence the interpretation of solar radio bursts, are strongly influenced by propagation effects in the inhomogeneous turbulent solar corona. In this work, a 3D stochastic description of the propagation process is presented, based on the Fokker-Planck and Langevin equations of radio-wave transport in a medium containing anisotropic electron density fluctuations. Using a numerical treatment based on this model, we investigate the characteristic source sizes and burst decay times for Type III solar radio bursts. Comparison of the simulations with the observations of solar radio bursts shows that predominantly perpendicular density fluctuations in the solar corona are required, with an anisotropy factor $sim 0.3$ for sources observed at around 30~MHz. The simulations also demonstrate that the photons are isotropized near the region of primary emission, but the waves are then focused by large-scale refraction, leading to plasma radio emission directivity that is characterized by a half-width-half-maximum of about 40~degrees near 30~MHz. The results are applicable to various solar radio bursts produced via plasma emission.
rate research
Read More
1.5D PIC, relativistic, fully electromagnetic (EM) simulations are used to model EM wave emission generation in the context of solar type III radio bursts. The model studies generation of EM waves by a super-thermal, hot beam of electrons injected into a plasma thread that contains uniform longitudinal magnetic field and a parabolic density gradient. In effect, a single magnetic line connecting Sun to earth is considered, for which several cases are studied. (i) We find that the physical system without a beam is stable and only low amplitude level EM drift waves (noise) are excited. (ii) The beam injection direction is controlled by setting either longitudinal or oblique electron initial drift speed, i.e. by setting the beam pitch angle. In the case of zero pitch angle, the beam excites only electrostatic, standing waves, oscillating at plasma frequency, in the beam injection spatial location, and only low level EM drift wave noise is also generated. (iii) In the case of oblique beam pitch angles, again electrostatic waves with same properties are excited. However, now the beam also generates EM waves with the properties commensurate to type III radio bursts. The latter is evidenced by the wavelet analysis of transverse electric field component, which shows that as the beam moves to the regions of lower density, frequency of the EM waves drops accordingly. (iv) When the density gradient is removed, electron beam with an oblique pitch angle still generates the EM radiation. However, in the latter case no frequency decrease is seen. Within the limitations of the model, the study presents the first attempt to produce simulated dynamical spectrum of type III radio bursts in fully kinetic plasma model. The latter is based on 1.5D non-zero pitch angle (non-gyrotropic) electron beam, that is an alternative to the plasma emission classical mechanism.
Drift-pair bursts are an unusual type of solar low-frequency radio emission, which appear in the dynamic spectra as two parallel drifting bright stripes separated in time. Recent imaging spectroscopy observations allowed for the quantitative characterization of the drifting pairs in terms of source size, position, and evolution. Here, the drift-pair parameters are qualitatively analyzed and compared with the newly-developed Monte Carlo ray-tracing technique simulating radio-wave propagation in the inhomogeneous anisotropic turbulent solar corona. The results suggest that the drift-pair bursts can be formed due to a combination of the refraction and scattering processes, with the trailing component being the result of turbulent reflection (turbulent radio echo). The formation of drift-pair bursts requires an anisotropic scattering with the level of plasma density fluctuations comparable to that in type III bursts, but with a stronger anisotropy at the inner turbulence scale. The anisotropic radio-wave scattering model can quantitatively reproduce the key properties of drift-pair bursts: the apparent source size and its increase with time at a given frequency, the parallel motion of the source centroid positions, and the delay between the burst components. The trailing component is found to be virtually co-spatial and following the main component. The simulations suggest that the drift-pair bursts are likely to be observed closer to the disk center and below 100 MHz due to the effects of free-free absorption and scattering. The exciter of drift-pairs is consistent with propagating packets of whistlers, allowing for a fascinating way to diagnose the plasma turbulence and the radio emission mechanism.
The Sun frequently accelerates near-relativistic electron beams that travel out through the solar corona and interplanetary space. Interacting with their plasma environment, these beams produce type III radio bursts, the brightest astrophysical radio sources seen from the Earth. The formation and motion of type III fine frequency structures is a puzzle but is commonly believed to be related to plasma turbulence in the solar corona and solar wind. Combining a theoretical framework with kinetic simulations and high-resolution radio type III observations using the Low Frequency Array, we quantitatively show that the fine structures are caused by the moving intense clumps of Langmuir waves in a turbulent medium. Our results show how type III fine structure can be used to remotely analyse the intensity and spectrum of compressive density fluctuations, and can infer ambient temperatures in astrophysical plasma, both significantly expanding the current diagnostic potential of solar radio emission.
Extensive particle-in-cell simulations of fast electron beams injected in a background magnetised plasma with a decreasing density profile were carried out. These simulations were intended to further shed light on a newly proposed mechanism for the generation of electromagnetic waves in type III solar radio bursts [D. Tsiklauri, Phys. Plasmas, 18, 052903 (2011)]. The numerical simulations were carried out using different density profiles and fast electron distribution functions. It is shown that electromagnetic L and R modes are excited by the transverse current, initially imposed on the system. In the course of the simulations no further interaction of the electron beam with the background plasma could be observed.
Standing shocks are believed to be responsible for stationary Type II solar radio bursts, whereas drifting Type II bursts are excited by moving shocks often related to coronal mass ejections (CMEs). Observations of either stationary or drifting Type II bursts are common, but a transition between the two states has not yet been reported. Here, we present a Type II burst which shows a clear, continuous transition from a stationary to a drifting state, the first observation of its kind. Moreover, band splitting is observed in the stationary parts of the burst, as well as intriguing negative and positive frequency-drift fine structures within the stationary emissions. The relation of the radio emissions to an observed jet and a narrow CME was investigated across multiple wavelengths, and the mechanisms leading to the transitioning Type II burst were determined. We find that a jet eruption generates a streamer-puff CME and that the interplay between the CME-driven shock and the streamer is likely to be responsible for the observed radio emissions.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
