No Arabic abstract
The first simultaneous detection of a short gamma-ray burst (SGRB) with a gravitational-wave (GW) signal ushered in a new era of multi-messenger astronomy. In order to increase the number of SGRB-GW simultaneous detections, we need full sky coverage in the gamma-ray regime. BurstCube, a CubeSat for Gravitational Wave Counterparts, aims to expand sky coverage in order to detect and localize gamma-ray bursts (GRBs). BurstCube will be comprised of 4 Cesium Iodide scintillators coupled to arrays of Silicon photo-multipliers on a 6U CubeSat bus (a single U corresponds to cubic unit $sim$10 cm $times$ 10 cm $times$ 10 cm) and will be sensitive to gamma-rays between 50 keV and 1 MeV, the ideal energy range for GRB prompt emission. BurstCube will assist current observatories, such as $Swift$ and $Fermi$, in the detection of GRBs as well as provide astronomical context to gravitational wave events detected by Advanced LIGO, Advanced Virgo, and KAGRA. BurstCube is currently in its development and testing phase to prepare for launch readiness in the fall of 2021. We present the mission concept, preliminary performance, and status.
A fleet of nanosatellites using precise timing synchronization provided by the Global Positioning System is a new concept for monitoring the gamma-ray sky that can achieve both all-sky coverage and good localization accuracy. We are proposing this new concept for the mission CubeSats Applied for MEasuring and LOcalising Transients (CAMELOT). The differences in photon arrival times at each satellite are to be used for source localization. Detectors with good photon statistics and the development of a localization algorithm capable of handling a large number of satellites are both essential for this mission. Large, thin CsI scintillator plates are the current candidates for the detectors because of their high light yields. It is challenging to maximize the light-collection efficiency and to understand the position dependence of such thin plates. We have found a multi-channel readout that uses the coincidence technique to be very effective in increasing the light output while keeping a similar noise level to that of a single channel readout. Based on such a detector design, we have developed a localization algorithm for this mission and have found that we can achieve a localization accuracy better than 20 arc minutes and a rate of about 10 short gamma-ray bursts per year.
The Planet Formation Imager (PFI) project aims to image the period of planet assembly directly, resolving structures as small as a giant planets Hill sphere. These images will be required in order to determine the key mechanisms for planet formation at the time when processes of grain growth, protoplanet assembly, magnetic fields, disk/planet dynamical interactions and complex radiative transfer all interact - making some planetary systems habitable and others inhospitable. We will present the overall vision for the PFI concept, focusing on the key technologies and requirements that are needed to achieve the science goals. Based on these key requirements, we will define a cost envelope range for the design and highlight where the largest uncertainties lie at this conceptual stage.
MagAO is the new adaptive optics system with visible-light and infrared science cameras, located on the 6.5-m Magellan Clay telescope at Las Campanas Observatory, Chile. The instrument locks on natural guide stars (NGS) from 0$^mathrm{th}$ to 16$^mathrm{th}$ $R$-band magnitude, measures turbulence with a modulating pyramid wavefront sensor binnable from 28x28 to 7x7 subapertures, and uses a 585-actuator adaptive secondary mirror (ASM) to provide flat wavefronts to the two science cameras. MagAO is a mutated clone of the similar AO systems at the Large Binocular Telescope (LBT) at Mt. Graham, Arizona. The high-level AO loop controls up to 378 modes and operates at frame rates up to 1000 Hz. The instrument has two science cameras: VisAO operating from 0.5-1 $mu$m and Clio2 operating from 1-5 $mu$m. MagAO was installed in 2012 and successfully completed two commissioning runs in 2012-2013. In April 2014 we had our first science run that was open to the general Magellan community. Observers from Arizona, Carnegie, Australia, Harvard, MIT, Michigan, and Chile took observations in collaboration with the MagAO instrument team. Here we describe the MagAO instrument, describe our on-sky performance, and report our status as of summer 2014.
A status report of the second phase of the MAGIC ground-based gamma-ray facility (as of October 2009) is presented. MAGIC became recently a stereoscopic Cherenkov observatory with the inauguration of its second telescope, MAGIC-II, which is currently approaching the end of its commissioning stage.
The Tunka Radio Extension (Tunka-Rex) is a digital radio array operating in the frequency band of 30-80 MHz and detecting radio emission from air-showers produced by cosmic rays with energies above 100 PeV. The experiment is installed at the site of the TAIGA (Tunka Advanced Instrument for cosmic rays and Gamma Astronomy) observatory and performs joint measurements with the co-located particle and air-Cherenkov detectors in passive mode receiving a trigger from the latter. Tunka-Rex collects data since 2012, and during the last five years went through several upgrades. As a result the density of the antenna field was increased by three times since its commission. In this contribution we present the latest results of Tunka-Rex experiment, particularly an updated analysis and efficiency study, which have been applied to the measurement of the mean shower maximum as a function of energy for cosmic rays of energies up to EeV. The future plans are also discussed: investigations towards an energy spectrum of cosmic rays with Tunka-Rex and their mass composition using a combination of Tunka-Rex data with muon measurements by the particle detector Tunka-Grande.