Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userRadio detection of cosmic rays with the Auger Engineering Radio Array
66
0
0.0
(
0
)
Authors
Tim Huege
Ask ChatGPT about the research
No Arabic abstract
The Auger Engineering Radio Array (AERA) complements the Pierre Auger Observatory with 150 radio-antenna stations measuring in the frequency range from 30 to 80 MHz. With an instrumented area of 17 km$^2$, the array constitutes the largest cosmic-ray radio detector built to date, allowing us to do multi-hybrid measurements of cosmic rays in the energy range of 10$^{17}$ eV up to several 10$^{18}$ eV. We give an overview of AERA results and discuss the significance of radio detection for the validation of the energy scale of cosmic-ray detectors as well as for mass-composition measurements.
rate research
Read More
The very low statistics of cosmic rays above the knee region make their study possible only through the detection of the extensive air showers (EAS) produced by their interaction with the constituents of the atmosphere. The Pierre Auger Observatory located in Argentina is the largest high energy cosmic-ray detection array in the world, composed of fluorescence telescopes, particle detectors on the ground and radio antennas. The Auger Engineering Radio Array (AERA) is composed of 153 autonomous radio stations that sample the radio emission of the extensive air showers in the 30 MHz to 80 MHz frequency range. It covers a surface of 17 km$^2$, has a 2$pi$ sensitivity to arrival directions of ultra-high energy cosmic rays (UHECR) and provides a duty cycle close to 100%. The electric field emitted by the secondary particles of an air shower is highly correlated to the primary cosmic ray characteristics like energy and mass, and the emission mechanisms are meanwhile well understood. In this contribution, recent progress on the reconstruction of the mass composition and energy measurements with AERA will be presented.
The Auger Engineering Radio Array (AERA) is part of the Pierre Auger Observatory and is used to detect the radio emission of cosmic-ray air showers. These observations are compared to the data of the surface detector stations of the Observatory, which provide well-calibrated information on the cosmic-ray energies and arrival directions. The response of the radio stations in the 30 to 80 MHz regime has been thoroughly calibrated to enable the reconstruction of the incoming electric field. For the latter, the energy deposit per area is determined from the radio pulses at each observer position and is interpolated using a two-dimensional function that takes into account signal asymmetries due to interference between the geomagnetic and charge-excess emission components. The spatial integral over the signal distribution gives a direct measurement of the energy transferred from the primary cosmic ray into radio emission in the AERA frequency range. We measure 15.8 MeV of radiation energy for a 1 EeV air shower arriving perpendicularly to the geomagnetic field. This radiation energy -- corrected for geometrical effects -- is used as a cosmic-ray energy estimator. Performing an absolute energy calibration against the surface-detector information, we observe that this radio-energy estimator scales quadratically with the cosmic-ray energy as expected for coherent emission. We find an energy resolution of the radio reconstruction of 22% for the data set and 17% for a high-quality subset containing only events with at least five radio stations with signal.
An integrated approach has been developed to study radio signals induced by cosmic rays entering the Earths atmosphere. An engineering array will be co-located with the infill array of the Pierre Auger Observatory. Our R&D effort includes the physics processes leading to the development of radio signals, end-to-end simulations of realistic hardware configurations, and tests of various systems on site, where coincidences with the other detector systems of the Observatory are used to benchmark the systems under development.
Nearly 50 years ago, the first radio signals from cosmic ray air showers were detected. After many successful studies, however, research ceased not even 10 years later. Only a decade ago, the field was revived with the application of powerful digital signal processing techniques. Since then, the detection technique has matured, and we are now in a phase of transition from small-scale experiments accessing energies below 1018 eV to experiments with a reach for energies beyond 1019 eV. We have demonstrated that air shower radio signals carry information on both the energy and the mass of the primary particle, and current experiments are in the process of quantifying the precision with which this information can be accessed. All of this rests on a solid understanding of the radio emission processes which can be interpreted as a coherent superposition of geomagnetic emission, Askaryan charge-excess radiation, and Cherenkov-like coherence effects arising in the density gradient of the atmosphere. In this article, I highlight the state of the art of radio detection of cosmic rays and briefly discuss its perspectives for the next few years.
The southern Auger Observatory provides an excellent test bed to study the radio detection of extensive air showers as an alternative, cost-effective, and accurate tool for cosmic-ray physics. The data from the radio setup can be correlated with those from the well-calibrated baseline detectors of the Pierre Auger Observatory. Furthermore, human-induced radio noise levels at the southern Auger site are relatively low. We have started an R&D program to test various radio-detection concepts. Our studies will reveal Radio Frequency Interferences (RFI) caused by natural effects such as day-night variations, thunderstorms, and by human-made disturbances. These RFI studies are conducted to optimise detection parameters such as antenna design, frequency interval, antenna spacing and signal processing. The data from our initial setups, which presently consist of typically 3 - 4 antennas, will be used to characterise the shower from radio signals and to optimise the initial concepts. Furthermore, the operation of a large detection array requires autonomous detector stations. The current design is aiming at stations with antennas for two polarisations, solar power, wireless communication, and local trigger logic. The results of this initial phase will provide an important stepping stone for the design of a few tens kilometers square engineering array
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
