No Arabic abstract
Modern radio astronomical facilities are able to detect extremely weak electromagnetic signals not only from the universe but also from man-made radio frequency interference of various origins. These range from wanted signals to unwanted out-of-band emission of radio services and applications to electromagnetic interference produced by all kinds of electronic and electric devices. Energy harvesting wind turbines are not only equipped with electric power conversion hardware but also copious amounts of electronics to control and monitor the turbines. A wind turbine in the vicinity of a radio telescope could therefore lead to harmful interference, corrupting the measured astronomical data. Many observatories seek to coordinate placement of new wind farms with wind turbine manufacturers and operators, as well as with the local planning authorities, to avoid such a situation. In our study, we provide examples as well as guidelines for the determination of the separation distances between wind turbines and radio observatories, to enable a benign co-existence for both. The proposed calculations entail three basic steps. At first, the anticipated maximum emitted power level based on the European EN 550011 (CISPR-11) standard, which applies to industrial devices, is determined. Then secondly, the propagation loss along the path to the radio receiver is computed via a model provided by the international telecommunication union. Finally, the received power is compared to the permitted power limit that pertains in the protected radio astronomical observing band under consideration. This procedure may be carried out for each location around a telescope site, in order to obtain a map of potentially problematic wind turbine positions.
This paper presents the physical operating principles of several micro wind turbines based on different aerodynamic forces: drag-type Vertical Axis Wind Turbine (VAWT) and lift-type Horizontal Axis Wind Turbine (HAWT). All these devices share the similarity of exploiting the same mechanical-to-electrical conversion: the electrostatic conversion. This type of conversion is based on capacitance variations induced by the motion between a rotor and a stator and requires a source of polarization. We will focus our study on two technologies to polarize the capacitive structure: the use of electrets and the exploitation of triboelectricity. Some experiments conducted in a low-speed wind tunnel between 0 and 20m.s-1 have highlighted power flux densities from 0 to 150{mu}W.cm-2 corresponding to power coefficients of 0 and 9% respectively. Among these results, we can especially retain an ultralow speed operation, which has never been reached until now, in terms of speed and efficiency (9% of efficiency at 1m.s-1). Finally, we will end up comparing different types of circuits to supply a temperature/acceleration sensor, in order to complete the energy harvesting chain.
This review gives an introduction to spectrometers and discusses their use within radio astronomy. While a variety of technologies are introduced, particular emphasis is given to digital systems. Three different types of digital spectrometers are discussed: autocorrelation spectrometers, Fourier transform spectrometers, and polyphase filterbank spectrometers. Given their growing ubiquity and significant advantages, polyphase filterbanks are detailed at length. The relative advantages and disadvantages of different spectrometer technologies are compared and contrasted, and implementation considerations are presented.
The concept of a Square Kilometre Array was developed to ensure that progress in Radio Astronomy in the early 21st Century continued at the same impressive pace as was achieved during the first 50 years. The SKA telescope is designed to pave that road to greater and greater sensitivity. So what technical challenges does the project face and what key innovations will drive the success of the SKA? What will the next Radio Astronomy mega-science project look like? In this article the author discusses the likely avenues of progress in the coming decades and comments on the status of radio astronomy in 2049 - the authors 70th (and presumably her retirement) year.
A community meeting on the topic of Radio Astronomy in the LSST Era was hosted by the National Radio Astronomy Observatory in Charlottesville, VA (2013 May 6--8). The focus of the workshop was on time domain radio astronomy and sky surveys. For the time domain, the extent to which radio and visible wavelength observations are required to understand several classes of transients was stressed, but there are also classes of radio transients for which no visible wavelength counterpart is yet known, providing an opportunity for discovery. From the LSST perspective, the LSST is expected to generate as many as 1 million alerts nightly, which will require even more selective specification and identification of the classes and characteristics of transients that can warrant follow up, at radio or any wavelength. The LSST will also conduct a deep survey of the sky, producing a catalog expected to contain over 38 billion objects in it. Deep radio wavelength sky surveys will also be conducted on a comparable time scale, and radio and visible wavelength observations are part of the multi-wavelength approach needed to classify and understand these objects. Radio wavelengths are valuable because they are unaffected by dust obscuration and, for galaxies, contain contributions both from star formation and from active galactic nuclei. The workshop touched on several other topics, on which there was consensus including the placement of other LSST Deep Drilling Fields, inter-operability of software tools, and the challenge of filtering and exploiting the LSST data stream. There were also topics for which there was insufficient time for full discussion or for which no consensus was reached, which included the procedures for following up on LSST observations and the nature for future support of researchers desiring to use LSST data products.
Data Models are an essential part of automatic data processing, but even more so when trying to tie together data coming from many different data sources, as is the case for the International Virtual Observatory. In this talk we will review the different data models used in the IVOA, which parts of that Data Modelling work are still incomplete, specially in radio wavelengths, and the work the AMIGA group has done within the IVOA Data Modelling Working Group to overcome those shortcomings both in missing data models and support for Radio Astronomy.