Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMicro-thermocouple on nano-membrane: thermometer for nanoscale measurements
137
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
A thermocouple of Au-Ni with only 2.5-micrometers-wide electrodes on a 30-nm-thick Si3N4 membrane was fabricated by a simple low-resolution electron beam lithography and lift off procedure. The thermocouple is shown to be sensitive to heat generated by laser as well as an electron beam. Nano-thin membrane was used to reach a high spatial resolution of energy deposition and to realise a heat source of sub-1 micrometer diameter. This was achieved due to a limited generation of secondary electrons, which increase a lateral energy deposition. A low thermal capacitance of the fabricated devices is useful for the real time monitoring of small and fast temperature changes, e.g., due to convection, and can be detected through an optical and mechanical barrier of the nano-thin membrane. Temperature changes up to ~2x10^5 K/s can be measured at 10 kHz rate. A simultaneous down-sizing of both, the heat detector and heat source strongly required for creation of thermal microscopy is demonstrated. Peculiarities of Seebeck constant (thermopower) dependence on electron injection into thermocouple are discussed. Modeling of thermal flows on a nano-membrane with presence of a micro-thermocouple was carried out to compare with experimentally measured temporal response.
rate research
Read More
We provide a detailed description of a general procedure by which a nano/micro-mechanical resonator can be calibrated using its thermal motion. A brief introduction to the equations of motion for such a resonator is presented, followed by a detailed derivation of the corresponding power spectral density (PSD) function. The effective masses for a number of different resonator geometries are determined using both finite element method (FEM) modeling and analytical calculations.
The dependent scattering effect (DSE), which arises from the wave nature of electromagnetic radiation, is a critical mechanism affecting the radiative properties of micro/nanoscale discrete disordered media (DDM). In the last a few decades, the approximate nature of radiative transfer equation (RTE) leads to a plethora of investigations of the DSE in various DDM, ranging from fluidized beds, photonic glass, colloidal suspensions and snow packs, etc. In this article, we give a general overview on the theoretical, numerical and experimental methods and progresses in the study of the DSE. We first present a summary of the multiple scattering theory of electromagnetic waves, including the analytic wave theory and Foldy-Lax equations, as well as its relationship with the RTE. Then we describe in detail the physical mechanisms that are critical to DSE and relevant theoretical considerations as well as numerical modeling methods. Experimental approaches to probe the radiative properties and relevant progresses in the experimental investigations of the DSE are also discussed. In addition, we give a brief review on the studies on the DSE and other relevant interference phenomena in mesoscopic physics and atomic physics, especially the coherent backscattering cone, Anderson localization, as well as the statistics and correlations in disordered media. We expect this review can provide profound and interdisciplinary insights to the understanding and manipulation of the DSE in disordered media for thermal engineering applications.
Superconducting triangular Nb wire networks with high normal-state resistance are fabricated by using a negative tone hydrogen silsesquioxane (HSQ) resist. Robust magnetoresistance oscillations are observed up to high magnetic fields and maintained at low temperatures, due to the eective reduction of wire dimensions. Well-defined dips appear at integral and rational values (1/2, 1/3, 1/4) of the reduced flux f = Phi/Phi_0, which is the first observation in the triangular wire networks. These results are well consistent with theoretical calculations for the reduced critical temperature as a function of f.
We present radio-frequency thermometry based on a tunnel junction between a superconductor and proximitized normal metal. It allows operation in a wide range of biasing conditions. We demonstrate that the standard finite-bias quasiparticle tunneling thermometer suffers from large dissipation and loss of sensitivity at low temperatures, whereas thermometry based on zero bias anomaly avoids both these problems. For these reasons the latter method is suitable down to lower temperatures, here to about 25 mK. Both thermometers are shown to measure the same local temperature of the electrons in the normal metal in the range of their applicability.
Magnetic skyrmions are the self-organized topological spin textures behaving like particles. Because of their fast creation and typically long lifetime, experimental verification of skyrmions creation/annihilation processes has been challenging. Here we successfully track skyrmions dynamics in defect-introduced Co9Zn9Mn2, by using pump-probe Lorentz transmission electron microscope. Following the nanosecond-photothermal excitation, we resolve 160-nm-skyrmions proliferation at <1 ns, contraction at 5 ns, drift from 10 ns to 4 microsecond and coalescence at 5 microsecond. These motions relay the multiscale arrangement and relaxation of skyrmion clusters in a repeatable cycle of 20 kHz. Such repeatable dynamics of skyrmions, arising from the weakened but still persistent topological protection around defects, enables us to visualize the whole life of the skyrmions, as well as demonstrating the possible high-frequency manipulations of topological charges brought by skyrmions.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
