Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDepth of Ultra High Energy Cosmic Ray Induced Air Shower Maxima Measured by the Telescope Array Black Rock and Long Ridge FADC Fluorescence Detectors and Surface Array in Hybrid Mode
100
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The Telescope Array observatory utilizes fluorescence detectors and surface detectors to observe air showers produced by ultra high energy cosmic rays in the Earths atmosphere. Cosmic ray events observed in this way are termed hybrid data. The depth of air shower maximum is related to the mass of the primary particle that generates the shower. This paper reports on shower maxima data collected over 8.5 years using the Black Rock Mesa and Long Ridge fluorescence detectors in conjunction with the array of surface detectors. We compare the means and standard deviations of the observed $X_{mathrm{max}}$ distributions with Monte Carlo $X_{mathrm{max}}$ distributions of unmixed protons, helium, nitrogen, and iron, all generated using the QGSJet~II-04 hadronic model. We also perform an unbinned maximum likelihood test of the observed data, which is subjected to variable systematic shifting of the data $X_{mathrm{max}}$ distributions to allow us to test the full distributions, and compare them to the Monte Carlo to see which elements are not compatible with the observed data. For all energy bins, QGSJet~II-04 protons are found to be compatible with Telescope Array hybrid data at the 95% confidence level after some systematic $X_{mathrm{max}}$ shifting of the data. Three other QGSJet~II-04 elements are found to be compatible using the same test procedure in an energy range limited to the highest energies where data statistics are sparse.
rate research
Read More
We present a measurement of the energy spectrum of ultra-high-energy cosmic rays performed by the Telescope Array experiment using monocular observations from its two new FADC-based fluorescence detectors. After a short description of the experiment, we describe the data analysis and event reconstruction procedures. Since the aperture of the experiment must be calculated by Monte Carlo simulation, we describe this calculation and the comparisons of simulated and real data used to verify the validity of the aperture calculation. Finally, we present the energy spectrum calculated from the merged monocular data sets of the two FADC-based detectors, and also the combination of this merged spectrum with an independent, previously published monocular spectrum measurement performed by Telescope Arrays third fluorescence detector (Abu-Zayyad {it et al.}, {Astropart. Phys.} 39 (2012), 109). This combined spectrum corroborates the recently published Telescope Array surface detector spectrum (Abu-Zayyad {it et al.}, {Astrophys. Journ.} 768 (2013), L1) with independent systematic uncertainties.
Ultra high energy cosmic rays provide the highest known energy source in the universe to measure proton cross sections. Though conditions for collecting such data are less controlled than an accelerator environment, current generation cosmic ray observatories have large enough exposures to collect significant statistics for a reliable measurement for energies above what can be attained in the lab. Cosmic ray measurements of cross section use atmospheric calorimetry to measure depth of air shower maximum ($X_{mathrm{max}}$), which is related to the primary particles energy and mass. The tail of the $X_{mathrm{max}}$ distribution is assumed to be dominated by showers generated by protons, allowing measurement of the inelastic proton-air cross section. In this work the proton-air inelastic cross section measurement, $sigma^{mathrm{inel}}_{mathrm{p-air}}$, using data observed by Telescope Arrays Black Rock Mesa and Long Ridge fluorescence detectors and surface detector array in hybrid mode is presented. $sigma^{mathrm{inel}}_{mathrm{p-air}}$ is observed to be $520.1 pm 35.8$[Stat.] $^{+25.0}_{-40}$[Sys.]~mb at $sqrt{s} = 73$ TeV. The total proton-proton cross section is subsequently inferred from Glauber formalism and is found to be $sigma^{mathrm{tot}}_{mathrm{pp}} = 139.4 ^{+23.4}_{-21.3}$ [Stat.]$ ^{+15.0}_{-24.0}$[Sys.]~mb.
One of the uncertainties in interpretation of ultra-high energy cosmic ray (UHECR) data comes from the hadronic interaction models used for air shower Monte Carlo (MC) simulations. The number of muons observed at the ground from UHECR-induced air showers is expected to depend upon the hadronic interaction model. One may therefore test the hadronic interaction models by comparing the measured number of muons with the MC prediction. In this paper, we present the results of studies of muon densities in UHE extensive air showers obtained by analyzing the signal of surface detector stations which should have high $it{muon , purity}$. The muon purity of a station will depend on both the inclination of the shower and the relative position of the station. In 7 years data from the Telescope Array experiment, we find that the number of particles observed for signals with an expected muon purity of $sim$65% at a lateral distance of 2000 m from the shower core is $1.72 pm 0.10{rm (stat.)} pm 0.37 {rm (syst.)}$ times larger than the MC prediction value using the QGSJET II-03 model for proton-induced showers. A similar effect is also seen in comparisons with other hadronic models such as QGSJET II-04, which shows a $1.67 pm 0.10 pm 0.36$ excess. We also studied the dependence of these excesses on lateral distances and found a slower decrease of the lateral distribution of muons in the data as compared to the MC, causing larger discrepancy at larger lateral distances.
Previous measurements of the composition of Ultra-High Energy Cosmic Rays(UHECRs) made by the High Resolution Flys Eye(HiRes) and Pierre Auger Observatory(PAO) are seemingly contradictory, but utilize different detection methods, as HiRes was a stereo detector and PAO is a hybrid detector. The five year Telescope Array(TA) Middle Drum hybrid composition measurement is similar in some, but not all, respects in methodology to PAO, and good agreement is evident between data and a light, largely protonic, composition when comparing the measurements to predictions obtained with the QGSJetII-03 and QGSJet-01c models. These models are also in agreement with previous HiRes stereo measurements, confirming the equivalence of the stereo and hybrid methods. The data is incompatible with a pure iron composition, for all models examined, over the available range of energies. The elongation rate and mean values of Xmax are in good agreement with Pierre Auger Observatory data. This analysis is presented using two methods: data cuts using simple geometrical variables and a new pattern recognition technique.
Since 2007, the Telescope Array (TA) experiment, based in Utah, USA, has been observing ultra high energy cosmic rays to understand their origins. The experiment involves a surface detector (SD) array and three fluorescence detector (FD) stations. FD stations, installed surrounding the SD array, measure the air fluorescence light emitted from extensive air showers (EASs) for precise determination of their energies and species. The detectors employed at one of the three FD stations were relocated from the High Resolution Flys Eye experiment. At the other two stations, newly designed detectors were constructed for the TA experiment. An FD consists of a primary mirror and a camera equipped with photomultiplier tubes. To obtain the EAS parameters with high accuracies, understanding the FD optical characteristics is important. In this paper, we report the characteristics and installation of new FDs and the performances of the FD components. The results of the monitored mirror reflectance during the observation time are also described in this report.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
