Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userViscous Taylor droplets in axisymmetric and planar tubes: from Brethertons theory to empirical models
167
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The aim of this study is to derive accurate models for quantities characterizing the dynamics of droplets of non-vanishing viscosity in capillaries. In particular, we propose models for the uniform-film thickness separating the droplet from the tube walls, for the droplet front and rear curvatures and pressure jumps, and for the droplet velocity in a range of capillary numbers, $Ca$, from $10^{-4}$ to $1$ and inner-to-outer viscosity ratios, $lambda$, from $0$, i.e. a bubble, to high viscosity droplets. Theoretical asymptotic results obtained in the limit of small capillary number are combined with accurate numerical simulations at larger $Ca$. With these models at hand, we can compute the pressure drop induced by the droplet. The film thickness at low capillary numbers ($Ca<10^{-3}$) agrees well with Brethertons scaling for bubbles as long as $lambda<1$. For larger viscosity ratios, the film thickness increases monotonically, before saturating for $lambda>10^3$ to a value $2^{2/3}$ times larger than the film thickness of a bubble. At larger capillary numbers, the film thickness follows the rational function proposed by Aussillous & Quere (2000) for bubbles, with a fitting coefficient which is viscosity-ratio dependent. This coefficient modifies the value to which the film thickness saturates at large capillary numbers. The velocity of the droplet is found to be strongly dependent on the capillary number and viscosity ratio. We also show that the normal viscous stresses at the front and rear caps of the droplets cannot be neglected when calculating the pressure drop for $Ca>10^{-3}$.
rate research
Read More
Effects of spinning motion on the bouncing and coalescence between a spinning droplet and a non-spinning droplet undergoing the head-on collision were numerically studied by using a Volume-of-Fluid method. A prominent discovery is that the spinning droplet can induce significant non-axisymmetric flow features for the head-on collision of equal-size droplets composed of the same liquid. Specifically, a non-axisymmetric bouncing was observed, and it is caused by the conversion of the spinning angular momentum into the orbital angular momentum. This process is accompanied by the rotational kinetic energy loss due to the interaction between the rotational and radial flows of the droplets. A non-axisymmetric internal flow and a delayed separation after temporary coalescence were also observed, and they are caused by the enhanced interface oscillation and internal-flow-induced viscous dissipation. The spinning motion can also promote the mass interminglement of droplets because the locally non-uniform mass exchange occurs at the early collision stage by non-axisymmetric flow and is further stretched along the filament at later collision stages. In addition, it is found that the non-axisymmetric flow features increase with increasing the orthogonality of the initial translational motion and the spinning motion of droplets.
The off-center collision of binary bouncing droplets of equal size was studied numerically by a volume-of-fluid (VOF) method with two marker functions, which has been validated by comparing with available experimental results. A non-monotonic kinetic energy recovery with varying impact parameters was found based on the energy budget analysis. This can be explained by the prolonged entanglement time and the enhanced internal-flow-induced viscous dissipation for bouncing droplets at intermediate impact parameters, compared with those at smaller or larger impact parameters. The universality of this non-monotonicity was numerically verified, and thereby an approximate fitting formula was proposed to correlate the kinetic energy dissipation factor with the impact parameter for various Weber numbers and Ohnesorge numbers. From the vortex dynamics perspective, a helicity analysis of droplet internal flow identifies a strong three-dimensional interaction between the ring-shaped vortices and the line-shaped shear layers for off-center collisions. Furthermore, we demonstrated theoretically and verified numerically that the equivalence between the total enstrophy and the total viscous dissipation, which holds for a single-phase flow system confined by stationary boundaries, is not generally satisfied for the two-phase flow system containing gas-liquid interfaces. This is attributed to the work done by the unbalanced viscous stresses, which results from the interfacial flow and the vorticity associated with the movement of the oscillating interface.
We consider extensional flows of a dense layer of spheres in a viscous fluid and employ force and torque balances to determine the trajectory of particle pairs that contribute to the stress. In doing this, we use Stokesian dynamics simulations to guide the choice of the near-contacting pairs that follow such a trajectory. We specify the boundary conditions on the representative trajectory, and determine the distribution of particles along it and how the stress depends on the microstructure and strain rate. We test the resulting predictions using the numerical simulations. Also, we show that the relation between the tensors of stress and strain rate involves the second and fourth moments of the particle distribution function.
The dynamics of individual liquid plugs pushed at constant pressure head inside prewetted cylindrical capillary tubes is investigated experimentally and theoretically. It is shown that, depending on the thickness of the prewetting film and the magnitude of the pressure head, the plugs can either experience a continuous acceleration leading to a dramatic decrease of their size and eventually their rupture or conversely, a progressive deceleration associated with their growth and an exacerbation of the airway obstruction. These behaviors are quantitatively reproduced with a simple nonlinear model [Baudoin et al., Proc. Nat. Ac. Sci. USA, 2013, 110, 859] adapted here for cylindrical channels. Furthermore, an analytical criterion for the transition between these two regimes is derived and successfully compared with extensive experimental data. The potential implications of this work for pulmonary obstructive diseases are discussed.
Building on the recent theoretical work of Wray, Duffy and Wilson [J. Fluid Mech. 884, A45 (2020)] concerning the competitive diffusion-limited evaporation of multiple thin sessile droplets in proximity to each other, we obtain theoretical predictions for the spatially non-uniform densities of the contact-line deposits (often referred to as coffee stains or ring stains) left on the substrate after such droplets containing suspended solid particles have completely evaporated. Neighbouring droplets interact via their vapour fields, which results in a spatially non-uniform shielding effect. We give predictions for the deposits from a pair of identical droplets, which show that the deposit is reduced the most where the droplets are closest together, and demonstrate excellent quantitative agreement with experimental results of Pradhan and Panigrahi [Coll. Surf. A 482, 562-567 (2015)]. We also give corresponding predictions for a triplet of identical droplets arranged in an equilateral triangle, which show that the effect of shielding on the deposit is more subtle in this case.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
