Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userFrequency Combs in a Lumped-Element Josephson-Junction Circuit
179
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We investigate the dynamics of a microwave-driven Josephson junction capacitively coupled to a lumped element LC oscillator. In the regime of driving where the Josephson junction can be approximated as a Kerr oscillator, this minimal nonlinear system has been previously shown to exhibit a bistability in phase and amplitude. In the present study, we characterize the full phase diagram and show that besides a parameter regime exhibiting bistability, there is also a regime of self-oscillations characterized by a frequency comb in its spectrum. We discuss the mechanism of comb generation which appears to be different from those studied in microcavity frequency combs and mode-locked lasers. We then address the fate of the comb-like spectrum in the regime of strong quantum fluctuations, reached when nonlinearity becomes the dominant scale with respect to dissipation. We find that the nonlinearity responsible for the emergence of the frequency combs also leads to its dephasing, leading to broadening and ultimate disappearance of sharp spectral peaks. Our study explores the fundamental question of the impact of quantum fluctuations for quantum systems which do not possess a stable fixed point in the classical limit.
rate research
Read More
We present a compact and efficient design in terms of gain, bandwidth and dynamical range for the Josephson mixer, the superconducting circuit performing three-wave mixing at microwave frequencies. In an all lumped-element based circuit with galvanically coupled ports, we demonstrate non degenerate amplification for microwave signals over a bandwidth up to 50 MHz for a power gain of 20 dB. The quantum efficiency of the mixer is shown to be about 70$%$ and its saturation power reaches $-112$ dBm.
We present a lumped-element Josephson parametric amplifier (JPA) utilizing a straightforward fabrication process involving a single electron beam lithography step followed by double-angle evaporation of aluminum and in-situ oxidation. The Josephson junctions forming the SQUID are fabricated using bridgeless shadow evaporation technique, which enables reliable fabrication of relatively large ($sim9~mathrm{mu m^2}$) junctions. Our strongly coupled flux-pumped JPA achieves 20~dB gain with 95~MHz bandwidth around 5~GHz, while the center frequency is tunable by more than 1~GHz, with the additional possibility for rapid tuning by varying the pump frequency alone. Analytical calculations based on the input-output theory reproduce our measurement results closely.
The voltage oscillations which occur in an ideally current-biased Josephson junction, were proposed to make a current standard for metrology. We demonstrate similar oscillations in a more complex Josephson circuit derived from the Cooper pair box: the quantronium. When a constant current I is injected in the gate capacitor of this device, oscillations develop at the frequency fB=I/2e, with e the electron charge. We detect these oscillations through the sidebands induced at multiples of fB in the spectrum of a microwave signal reflected on the circuit, up to currents I exceeding 100 pA. We discuss the potential interest of this current to frequency conversion experiment for metrology.
A neutral quantum particle with magnetic moment encircling a static electric charge acquires a quantum mechanical phase (Aharonov-Casher effect). In superconducting electronics the neutral particle becomes a fluxon that moves around superconducting islands connected by Josephson junctions. The full understanding of this effect in systems of many junctions is crucial for the design of novel quantum circuits. Here we present measurements and quantitative analysis of fluxon interference patterns in a six Josephson junction chain. In this multi-junction circuit the fluxon can encircle any combination of charges on five superconducting islands, resulting in a complex pattern. We compare the experimental results with predictions of a simplified model that treats fluxons as independent excitations and with the results of the full diagonalization of the quantum problem. Our results demonstrate the accuracy of the fluxon interference description and the quantum coherence of these arrays.
Odd frequency (odd-$omega$) electron pair correlations naturally appear at the interface between BCS superconductors and other materials. The detection of odd-$omega$ pairs, which are necessarily non-local in time, is still an open problem. The main reason is that they do not contribute to static measurements described by time-local correlation functions. Therefore, dynamical measurements, which depend on non-local time correlations, are suitable for detecting these pairs. In this work, we study the signatures of odd-$omega$ pairs in the supercurrent noise through a weak link between two superconductors at different superconducting phases. We show that the finite frequency current noise can be decomposed into three different contributions coming from even frequency (even-$omega$), odd-$omega$ pair amplitudes, and electron-hole correlation functions. Odd-$omega$ pairing, which is inter-lead (between electrons at different sides of the junction), provides a positive contribution to the noise, becoming maximal at a superconducting phase difference of $pi$. In contrast, intra-lead even-$omega$ pair amplitude tends to reduce the noise, except for a region close to $pi$, controlled by the transmission of the junction.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
