Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userA Three-Dimensional View of Turbulence: Constraints on Turbulent Motions in the HD 163296 Protoplanetary Disk using DCO$^+$
99
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Gas kinematics are an important part of the planet formation process. Turbulence influences planetesimal growth and migration from the scale of sub-micron dust grains through gas-giant planets. Radio observations of resolved molecular line emission can directly measure this non-thermal motion and, taking advantage of the layered chemical structure of disks, different molecular lines can be combined to map the turbulence throughout the vertical extent of a protoplanetary disk. Here we present ALMA observations of three molecules (DCO$^+$(3-2), C$^{18}$O(2-1) and CO(2-1)) from the disk around HD 163296. We are able to place stringent upper limits ($v_{rm turb}<$0.06c$_s$, $<$0.05c$_s$ and $<$0.04c$_s$ for CO(2-1), C$^{18}$O(2-1) and DCO$^+$(3-2) respectively), corresponding to $alphalesssim$3$times$10$^{-3}$, similar to our prior limit derived from CO(3-2). This indicates that there is little turbulence throughout the vertical extent of the disk, contrary to theoretical predictions based on the magneto-rotational instability and gravito-turbulence. In modeling the DCO$^+$ emission we also find that it is confined to three concentric rings at 65.7$pm$0.9 au, 149.9$^{+0.5}_{-0.7}$ au and 259$pm$1 au, indicative of a complex chemical environment.
rate research
Read More
Knowledge of the midplane temperature of protoplanetary disks is one of the key ingredients in theories of dust growth and planet formation. However, direct measurement of this quantity is complicated, and often depends on the fitting of complex models to the data. In this paper we demonstrate a method to directly measure the midplane gas temperature from an optically thick molecular line, if the disk is moderately inclined. The only model assumption that enters is that the line is very optically thick, also in the midplane region where we wish to measure the temperature. Freeze-out of the molecule onto dust grains could thwart this. However, in regions that are expected to be warm enough to avoid freeze-out, this method should work. We apply the method to the CO 2-1 line channel maps of the disk around HD 163296. We find that the midplane temperature between 100 and 400 au drops only mildly from 25 K down to 18 K. While we see no direct evidence of the midplane being optically thin due to strong CO depletion by freeze-out, we cannot rule it out either. The fact that the inferred temperatures are close to the expected CO freeze-out temperature could be an indication of this. Incidently, for the disk around HD 163296 we also find dynamic evidence for a rather abrupt outer edge of the disk, suggestive of outside-in photoevaporation or truncation by an unseen companion.
The high spatial and line sensitivity of ALMA opens the possibility of resolving emission from molecules in circumstellar disks. With an understanding of physical conditions under which molecules have high abundance, they can be used as direct tracers of distinct physical regions. In particular, DCO+ is expected to have an enhanced abundance within a few Kelvin of the CO freezeout temperature of 19 K, making it a useful probe of the cold disk midplane. We compare ALMA line observations of HD 163296 to a grid of models. We vary the upper- and lower-limit temperatures of the region in which DCO+ is present as well as the abundance of DCO+ in order to fit channel maps of the DCO+ J=5-4 line. To determine the abundance enhancement compared to the general interstellar medium, we carry out similar fitting to HCO+ J=4-3 and H13CO+ J=4-3 observations. ALMA images show centrally peaked extended emission from HCO+ and H13CO+. DCO+ emission lies in a resolved ring from ~110 to 160 AU. The outer radius approximately corresponds to the size of the CO snowline as measured by previous lower resolution observations of CO lines in this disk. The ALMA DCO+ data now resolve and image the CO snowline directly. In the best fitting models, HCO+ exists in a region extending from the 19 K isotherm to the photodissociation layer with an abundance of 3x10^-10 relative to H2. DCO+ exists within the 19-21 K region of the disk with an abundance ratio [DCO+] / [HCO+] = 0.3. This represents a factor of 10^4 enhancement of the DCO+ abundance within this narrow region of the HD 163296 disk. Such a high enhancement has only previously been seen in prestellar cores. The inferred abundances provide a lower limit to the ionization fraction in the midplane of the cold outer disk (approximately greater than 4x10^-10), and suggest the utility of DCO+ as a tracer of its parent molecule H2D+. Abridged
We aim at estimating the dust scale height of protoplanetary disks from millimeter continuum observations. First, we present a general expression of intensity of a ring in a protoplanetary disk, and show that we can constrain the dust scale height by the azimuthal intensity variation. Then, we apply the presented methodology to the two distinct rings at 68 au and at 100 au of the protoplanetary disk around HD 163296. We constrain the dust scale height by comparing the DSHARP high-resolution millimeter dust continuum image with radiative transfer simulations using RADMC-3D. We find that h_d/h_g > 0.84 at the inner ring and h_d/h_g < 0.11 at the outer ring with the 3 sigma uncertainties, where h_d is the dust scale height and h_g is the gas scale height. This indicates that the dust is flared at the inner ring and settled at the outer ring. We further constrain the ratio of turbulence parameter alpha to gas-to-dust-coupling parameter St from the derived dust scale height; alpha/St > 2.4 at the inner ring, and alpha/St < 1.1*10^{-2} at the outer ring. This result shows that the turbulence is stronger or the dust is smaller at the inner ring than at the outer ring.
High resolution ALMA observations revealed a variety of rich substructures in numerous protoplanetary disks. These structures consist of rings, gaps and asymmetric features. It is debated whether planets can be accounted for these substructures in the dust continuum. Characterizing the origin of asymmetries as seen in HD 163296 might lead to a better understanding of planet formation and the underlying physical parameters of the system. We test the possibility of the formation of the crescent-shaped asymmetry in the HD 163296 disk through planet-disk interaction. The goal is to obtain constraints on planet masses and eccentricities and disk viscosities. Two dimensional, multi-fluid, hydrodynamical simulations are performed with the FARGO3D code including three embedded planets. Dust is described with the pressureless fluid approach and is distributed over eight size bins. Resulting grids are post-processed with the radiative transfer code RADMC-3D and the CASA software to model synthetic observations. We find that the crescent-shaped asymmetry can be qualitatively modeled with a Jupiter mass planet at a radial distance of 48 au. Dust is trapped preferably in the trailing Lagrange point L5 with a mass of 10 to 15 earth masses. Increased values of eccentricity of the innermost Jupiter mass planet damages the stability of the crescent-shaped feature and does not reproduce the observed radial proximity to the first prominent ring in the system. Generally, a low level of viscosity ($alpha leq 2cdot10^{-3}$) is necessary to allow the existence of such a feature. Including dust feedback the leading point L4 can dominantly capture dust for dust grains with an initial Stokes number $leq 3.6cdot 10^{-2}$. The observational results suggest a negligible effect of dust feedback since only one such feature has been detected so far.
With an emphasis on improving the fidelity even in super-resolution regimes, new imaging techniques have been intensively developed over the last several years, which may provide substantial improvements to the interferometric observation of protoplanetary disks. In this study, sparse modeling (SpM) is applied for the first time to observational data sets taken by the Atacama Large Millimeter/submillimeter Array (ALMA). The two data sets used in this study were taken independently using different array configurations at Band 7 (330 GHz), targeting the protoplanetary disk around HD 142527; one in the shorter-baseline array configuration (~ 430 m), and the other in the longer-baseline array configuration (~ 1570 m). The image resolutions reconstructed from the two data sets are different by a factor of ~ 3. We confirm that the previously known disk structures appear on the images produced by both SpM and CLEAN at the standard beam size. The image reconstructed from the shorter-baseline data using the SpM matches that obtained with the longer-baseline data using CLEAN, achieving a super-resolution image from which a structure finer than the beam size can be reproduced. Our results demonstrate that on-going intensive development in the SpM imaging technique is beneficial to imaging with ALMA.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
