Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userWireless Powered Communications with Finite Battery and Finite Blocklength
161
0
0.0
(
0
)
Added by
Onel Luis Alcaraz L\\'opez
Publication date
2017
fields
Informatics Engineering
and research's language is
English
Authors
Onel L. A. Lopez
Ask ChatGPT about the research
No Arabic abstract
We analyze a wireless communication system with finite block length and finite battery energy, under quasi-static Nakagami-m fading. Wireless energy transfer is carried out in the downlink while information transfer occurs in the uplink. Transmission strategies for scenarios with/without energy accumulation between transmission rounds are characterized in terms of error probability and energy consumption. A power control protocol for the energy accumulation scenario is proposed and results show the enormous impact on improving the system performance, in terms of error probability and energy consumption. The numerical results corroborate the existence and uniqueness of an optimum target error probability, while showing that a relatively small battery could be a limiting factor for some setups, specially when using the energy accumulation strategy.
rate research
Read More
Rate-Splitting Multiple Access (RSMA) is an emerging flexible and powerful multiple access for downlink multiantenna networks. In this paper, we introduce the concept of RSMA into short-packet downlink communications. We design optimal linear precoders that maximize the sum rate with Finite Blocklength (FBL) constraints. The relations between the sum rate and blocklength of RSMA are investigated for a wide range of network loads and user deployments. Numerical results demonstrate that RSMA can achieve the same transmission rate as Non-Orthogonal Multiple Access (NOMA) and Space Division Multiple Access (SDMA) with shorter blocklengths (and therefore lower latency), especially in overloaded multi-antenna networks. Hence, we conclude that RSMA is a promising multiple access for low-latency communications.
This work focuses on the performance analysis of short blocklength communication with application in smart grids. We use stochastic geometry to compute in closed form the success probability of a typical message transmission as a function of its size (i.e. blocklength), the number of information bits and the density of interferers. Two different scenarios are investigated: (i) dynamic spectrum access where the licensed and unlicensed users, share the uplink channel frequency band and (ii) local licensing approach using the so called micro operator, which holds an exclusive license of its own. Approximated outage probability expression is derived for the dynamic spectrum access scenario, while a closed-form solution is attained for the micro-operator. The analysis also incorporates the use of retransmissions when messages are detected in error. Our numerical results show how reliability and delay are related in either scenarios.
In this paper, we investigate the optimal design of a wireless-powered covert communication (WP-CC) system, in which a probabilistic accumulate-then-transmit (ATT) protocol is proposed to maximize the communication covertness subject to a quality-of-service (QoS) requirement on communication. Specifically, in the considered WP-CC system, a full-duplex (FD) receiver transmits artificial noise (AN) to simultaneously charge an energy-constrained transmitter and to confuse a wardens detection on the transmitters communication activity. With the probabilistic ATT protocol, the transmitter sends its information with a prior probability, i.e., $p$, conditioned on the available energy being sufficient. Our analysis shows that the probabilistic ATT protocol can achieve higher covertness than the traditional ATT protocol with $p=1$. In order to facilitate the optimal design of the WP-CC system, we also derive the wardens minimum detection error probability and characterize the effective covert rate from the transmitter to the receiver to quantify the communication covertness and quality, respectively. The derived analytical results facilitate the joint optimization of the probability $p$ and the information transmit power. We further present the optimal design of a cable-powered covert communication (CP-CC) system as a benchmark for comparison. Our simulation shows that the proposed probabilistic ATT protocol (with a varying $p$) can achieve the covertness upper bound determined by the CP-CC system, while the traditional ATT protocol (with $p=1$) cannot, which again confirms the benefits brought by the proposed probabilistic ATT in covert communications.
In this paper, we consider the problem of sequential transmission over the binary symmetric channel (BSC) with full, noiseless feedback. Naghshvar et al. proposed a one-phase encoding scheme, for which we refer to as the small-enough difference (SED) encoder, which can achieve capacity and Burnashevs optimal error exponent for symmetric binary-input channels. They also provided a non-asymptotic upper bound on the average blocklength, which implies an achievability bound on rates. However, their achievability bound is loose compared to the simulated performance of SED encoder, and even lies beneath Polyanskiys achievability bound of a system limited to stop feedback. This paper significantly tightens the achievability bound by using a Markovian analysis that leverages both the submartingale and Markov properties of the transmitted message. Our new non-asymptotic lower bound on achievable rate lies above Polyanskiys bound and is close to the actual performance of the SED encoder over the BSC.
This paper presents finite-blocklength achievability bounds for the Gaussian multiple access channel (MAC) and random access channel (RAC) under average-error and maximal-power constraints. Using random codewords uniformly distributed on a sphere and a maximum likelihood decoder, the derived MAC bound on each transmitters rate matches the MolavianJazi-Laneman bound (2015) in its first- and second-order terms, improving the remaining terms to $frac12frac{log n}{n}+O left(frac 1 n right)$ bits per channel use. The result then extends to a RAC model in which neither the encoders nor the decoder knows which of $K$ possible transmitters are active. In the proposed rateless coding strategy, decoding occurs at a time $n_t$ that depends on the decoders estimate $t$ of the number of active transmitters $k$. Single-bit feedback from the decoder to all encoders at each potential decoding time $n_i$, $i leq t$, informs the encoders when to stop transmitting. For this RAC model, the proposed code achieves the same first-, second-, and third-order performance as the best known result for the Gaussian MAC in operation.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
