Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userA geometrical view of scalar modulation instability
170
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We present a novel approach to the analysis of a full model of scalar modulation instability (MI) by means of a simple geometrical description in the power vs. frequency plane. This formulation allows to relate the shape of the MI gain to any arbitrary dispersion profile of the medium. As a result, we derive a straightforward explanation of the non-trivial dependence of the cutoff power on high-order dispersion and obtain explicitly the power that maximizes the gain. Our approach puts forth a powerful tool to synthesize a desired MI gain with the potential application to a vast number of parametric-amplification and supercontinuum-generation devices whose functioning relies upon modulation instability.
rate research
Read More
We report on the experimental and numerical observation of polarization modulation instability (PMI) in a nonlinear fiber Kerr resonator. This phenomenon is phased-matched through the relative phase detuning between the intracavity fields associated with the two principal polarization modes of the cavity. Our experimental investigation is based on a 12-m long fiber ring resonator in which a polarization controller is inserted to finely control the level of intra-cavity birefringence. Depending on the amount of birefringence, the temporal patterns generated via PMI are found to be either stationary or to exhibit a period-doubled dynamics. Experimental results are in good agreement with numerical simulations based on an Ikeda map for the two orthogonally polarized modes. Our study provides new insights into the control of modulation instability in multimode Kerr resonators. Modulation instability (MI) is a nonlinear phenomenon characterized by the exponential growth and evolution of periodic perturbations on top of an intense continuous-wave (cw) laser beam [1, 2]. Underpinned by a nonlinearly phase-matched parametric process, it is associated with a transfer of energy from a narrow pump frequency component to a pair of sidebands arranged symmetrically around the pump. In single-pass optical fiber propagation, MI can be naturally phase-matched through a balance between anomalous group-velocity dispersion and Kerr nonlinearity [1, 2]. In contrast, more general phase-matching conditions are possible in the context of passive Kerr resonators, such as fiber ring cavities, because of the crucial role played by the systems boundary conditions [3-5]. Various configurations of MI have been investigated in that context, including MI in the normal dispersion regime, MI via bichromatic or incoherent driving, as well as competition between MI and Faraday or period-doubled (P2) instabilities [6--12]. Moreover, at variance with single-pass propagation, MI in Kerr resonators can lead to the emergence of stationary periodic (Turing) patterns; such patterns are now understood to be intimately related to temporal cavity solitons and microresonator optical frequency combs [13--16]. Birefringence, and nonlinear coupling between the polarization components of light, is also known to contribute to the phase-matching of parametric processes. This leads to polarization MI (PMI) and the emergence of vector temporal patterns [17-19]. In driven resonators, PMI has only been investigated theoretically so far [20-22], but recent demonstrations of orthogonally-polarized dual comb generation in microresonators are sparking a renewed interest in this process [23]. In this Letter, we report on the direct experimental observation of PMI in a passive Kerr resonator. Our experimental test-bed is based on a normally dispersive fiber ring cavity that incorporates a polarization controller for adjustment of the intra-cavity birefringence. This localized birefringence gives rise to a relative phase detuning between the two orthogonal polarization modes of the cavity, which in turn affects the frequency shift of the PMI sidebands. We also find that birefringence can lead to period-doubled (P2) dynamics, characterized by a two round-trip cycle. Our experimental results are in good agreement with theoretical predictions and numerical simulations based on an iterative two-component Ikeda map. The experimental setup is displayed in Fig. 1(a). It consists of a L = 12-m long passive fiber ring cavity with a finesse F of about 27, mainly built out of spun fiber. To avoid competition with scalar MI [2], we have built a cavity with normal group-velocity dispersion estimated to 2 = 47 ps 2 /km, a value large enough to neglect third-order dispersion. Also, the use of a spun fiber (nearly isotropic) avoids group-velocity mismatch between the polarization components. Additionally, to prevent any additional source of bending-induced birefringence, the fiber was carefully off-spooled and wound directly on our experimental board with a large 50-cm diameter. We estimate that this causes a birefringence $Delta$n no greater than 10 --8 [24], which can be neglected in our study.
We derive analytical expressions for the coherence in the onset of modulation instability, in excellent agreement with thorough numerical simulations. As usual, we start by a linear perturbation analysis, where broadband noise is added to a continuous wave (CW) pump; then, we investigate the effect of adding a deterministic seed to the CW pump, a case of singular interest as it is commonly encountered in parametric amplification schemes. Results for the dependence of coherence on parameters such as fiber type, pump power, propagated distance, seed signal-to-noise ratio are presented. Finally, we show the importance of including higher-order linear and nonlinear dispersion when dealing with generation in longer wavelength regions (mid IR). We believe these results to be of relevance when applied to the analysis of the coherence properties of supercontinua generated from CW pumps.
We revisit the problem of modulation instability (MI) in optical fibers, including higher-order dispersion terms, self-steepening, and Raman response. We derive expressions for the MI gain and use them to explore the role of self-steepening towards a high-power limit. We show that, contrary to common wisdom, there is a pump power level that maximizes the MI gain. Further increasing the power not only diminishes the gain, but eventually makes it disappear. We believe these findings to be of special relevance, for instance, when applied to the generation of supercontinuum in the mid and far infrared bands. Finally, numerical simulations confirming our analytical results are presented.
Manipulating the polarization of light on the microscale or nanoscale is essential for integrated photonics and quantum optical devices. Nowadays, the metasurface allows one to build on-chip devices that efficiently manipulate the polarization states. However, it remains challenging to generate different types of polarization states simultaneously, which is required to encode information for quantum computing and quantum cryptography applications. By introducing geometrical-scaling-induced (GSI) phase modulations, we demonstrate that an assembly of circularly polarized (CP) and linearly polarized (LP) states can be simultaneously generated by a single metasurface made of L-shaped resonators with different geometrical features. Upon illumination, each resonator diffracts the CP state with a certain GSI phase. The interaction of these diffractions leads to the desired output beams, where the polarization state and the propagation direction can be accurately tuned by selecting the geometrical shape, size, and spatial sequence of each resonator in the unit cell. As an example of potential applications, we show that an image can be encoded with different polarization profiles at different diffraction orders and decoded with a polarization analyzer. This approach resolves a challenging problem in integrated optics and is inspiring for on-chip quantum information processing.
We investigate multi-wave mixing associated with the strongly pump depleted regime of induced modulation instability (MI) in optical fibers. For a complete transfer of pump power into the sideband modes, we theoretically and experimentally demonstrate that it is necessary to use a much lower seeding modulation frequency than the peak MI gain value. Our analysis shows that a record 95 % of the input pump power is frequency converted into the comb of sidebands, in good quantitative agreement with analytical predictions based on the simplest exact breather solution of the nonlinear Schrodinger equation.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
