Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userInsight into dielectric response of ferroelectric relaxors by statistical modeling
109
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Ferroelectric relaxors are complex materials with distinct properties. The understanding of their dielectric susceptibility, which strongly depends on both temperature and probing frequency, have interested researchers for many years. Here we report a macroscopic and phenomenological approach based on statistical modeling to investigate and better understand how the dielectric response of a relaxor depends on temperature. Employing the Maxwell-Boltzmann distribution and considering temperature dependent dipolar orientational polarizability, we propose a minimum statistical model and specific equations to understand and fit numerical and experimental dielectric responses versus temperature. We show that the proposed formula can successfully fit the dielectric response of typical relaxors, including Ba(Zr,Ti)O$_{3}$, Pb(Zn$_{1/3}$Nb$_{2/3}$)$_{0.87}$Ti$_{0.13}$O$_{3}$, and Pb(Mg$_{1/3}$Nb$_{2/3}$)O$_{3}$-0.05Pb(Zr$_{0.53}$Ti$_{0.47}$)O$_{3}$, which demonstrates the general applicability of this approach.
rate research
Read More
It has been considered that polar nanoregions in relaxors form at Burns temperature Td approx 600 K. High-temperature dielectric investigations of Pb(Mg1/3Nb2/3)O3 (PMN) and 0.7PMN-0.3PbTiO3 reveal, however, that the dielectric dispersion around 600 K appears due to the surface-layer contributions. The intrinsic response, analyzed in terms of the universal scaling, imply much higher Td or formation of polar nanoregions in a broad temperature range, while high dielectric constants manifest that polar order exists already at the highest measured temperatures of 800 K. The obtained critical exponents indicate critical behavior associated with universality classes typically found in spin glasses.
The origin of the functional properties of complex oxide superlattices can be resolved using time-resolved synchrotron x-ray diffraction into contributions from the component layers making up the repeating unit. The CaTiO3 layers of a CaTiO3/BaTiO3 superlattice have a piezoelectric response to an applied electric field, consistent with a large continuous polarization throughout the superlattice. The overall piezoelectric coefficient at large strains, 54 pm/V, agrees with first-principles predictions in which a tetragonal symmetry is imposed on the superlattice by the SrTiO3 substrate.
Ferroelectric materials are interesting candidates for future photovoltaic applications due to their potential to overcome the fundamental limits of conventional single bandgap semiconductor-based solar cells. Although a more efficient charge separation and above bandgap photovoltages are advantageous in these materials, tailoring their photovoltaic response using ferroelectric functionalities remains puzzling. Here we address this issue by reporting a clear hysteretic character of the photovoltaic effect as a function of electric field and its dependence on the poling history. Furthermore, we obtain insight into light induced nonequilibrium charge carrier dynamics in Bi2FeCrO6 films involving not only charge generation, but also recombination processes. At the ferroelectric remanence, light is able to electrically depolarize the films with remanent and transient effects as evidenced by electrical and piezoresponse force microscopy (PFM) measurements. The hysteretic nature of the photovoltaic response and its nonlinear character at larger light intensities can be used to optimize the photovoltaic performance of future ferro-electric-based solar cells.
Broadband dielectric spectroscopy from Hz up to the infrared (IR) range and temperature interval 10-300 K was carried out for xBaZrO3-(1-x)BaTiO3 (BZT-x, x = 0.6, 0.7, 0.8) solid solution ceramics and compared with similar studies for x = 0, 0.2, 0.4, 1 ceramics published recently (Phys. Rev. B 86, 014106 (2012)). Rather complex IR spectra without appreciable mode softening are ascribed to Last-Slater transverse optic (TO) phonon eigenvector mixing and possible two-mode mixed crystal behavior. Fitting of the complete spectral range requires a relaxation in the 100 GHz range for all the samples. Below 1 GHz another relaxation appears, which is thermally activated and obeys the same Arrhenius behavior for all the relaxor BZT samples. The frequently reported Vogel-Fulcher behavior in BZT relaxors is shown to be an artifact of the evaluation from the permittivity or loss vs. temperature dependences instead of its evaluation from loss vs. frequency maxima. The relaxation is assigned to local hopping of the off-centered Ti4+ ions in the frozen BTO clusters, whose size is rather small and cannot grow on cooling. Therefore BZT is to be considered as a dipolar glass rather than relaxor ferroelectric.
We have synthesised ceramic specimens of the tetragonal tungsten bronze K3Li2Ta5O15 (KLT) and characterized its phase transition via X-ray, dielectric permittivity, ultrasonic spectroscopy and heat capacity measurements. The space group of KLT is reported as both P4/mbm or Cmmm with the orthorhombic distortion occurring when there are higher partial pressures of volatile K and Li used within the closed crucibles for the solid state synthesis. The data show strong relaxor behaviour, with the temperature at which the two dielectric relative permittivity peaks decreasing with 104 K $geqslant$ Tm1 $geqslant$ 69 K and 69 K $geqslant$ Tm2 $geqslant$ 46 K as probe frequency f is reduced from 1 MHz to 316 Hz. The data satisfy a Vogel-Fulcher model with an extrapolated freezing temperature for {epsilon} and {epsilon} of Tf1 = + 15.8 and - 11.8 K and Tf2 = - 5.0 and - 15.0 K for f $rightarrow$ 0 (tending to dc). Therefore by tuning frequency, the transition could be shifted to absolute zero suggesting KLT has a relaxor-type quantum critical point. In addition, we have reanalysed the conflicting literature for Pb2Nb2O7 pyrochlore which suggests that this is also a relaxor-type quantum critical point as the freezing temperature from Vogel-Fulcher fitting is below absolute zero. Since the transition temperature evidenced in the dielectric data at ca. 100 kHz shifts below zero Kelvin for very low frequencies, heat capacity data collected in the zero-frequency (dc) limit, should not indicate a transition. Both of these materials show promise as possible new relaxor-type quantum critical points within non-perovskite based structures as multiple compounds are reported with low-temperature transitions.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
