Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userPossibility of microscopic liquid water formation at landing sites on Mars and their observational potential
168
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Microscopic liquid brines, especially calcium-perchlorate could emerge by deliquescence on Mars during night time hours. Using climate model computations and orbital humidity observations, the ideal periods and their annual plus daily characteristics at various past, current and future landing sites were compared. Such results provide context for future analysis and targeting the related observations by the next missions for Mars. Based on the analysis, at most (but not all) past missions landing sites, microscopic brine could emerge during night time for different durations. Analysing the conditions at ExoMars rovers primary landing site at Oxia Planum, the best annual period was found to be between $L_s$ 115 - 225, and in $Localhspace{0.1cm} Time$ 2 - 5, after midnight. In an ideal case, 4 hours of continuous liquid phase can emerge there. Local conditions might cause values to differ from those estimated by the model. Thermal inertia could especially make such differences (low TI values favour fast cooling and $textrm{H}_2textrm{O}$ cold trapping at loose surfaces) and the concentration of calcium-perchlorate salt in the regolith also influences the process (it might occur preferentially at long-term exposed surfaces without recent loose dust coverage). These factors should be taken into account while targeting future liquid water observations on Mars.
rate research
Read More
The Mars Science Laboratory (MSL) Rover Environmental Monitoring Station (REMS) has now made continuous in-situ meteorological measurements for several martian years at Gale crater, Mars. Of importance in the search for liquid formation are REMS measurements of ground temperature and in-air measurements of temperature and relative humidity, which is with respect to ice. Such data can constrain the surface and subsurface stability of brines. Here we use updated calibrations to REMS data and consistent relative humidity comparisons (i.e., w.r.t. liquid vs w.r.t. ice) to investigate the potential formation of surface and subsurface liquids throughout MSLs traverse. We specifically study the potential for the deliquescence of calcium perchlorate. Our data analysis suggests that surface brine formation is not favored within the first 1648 sols as there are only two times (sols 1232 and 1311) when humidity-temperature conditions were within error consistent with a liquid phase. On the other hand, modeling of the subsurface environment would support brine production in the shallow subsurface. Indeed, we find that the shallow subsurface for terrains with low thermal inertia ($Gammalesssim 300$ J m$^{-2}$ K$^{-1}$ s$^{-1/2}$) may be occasionally favorable to brine formation through deliquescence. Terrains with $Gammalesssim175$ J m$^{-2}$ K$^{-1}$ s$^{-1/2}$ and albedos of $gtrsim0.25$ are the most apt to subsurface brine formation. Should brines form, they would occur around Ls 100$^{circ}$. Their predicted properties would not meet the Special nor Uncertain Region requirements, as such they would not be potential habitable environments to life as we know it.
The Lunar Geophysical Network (LGN) mission is proposed to land on the Moon in 2030 and deploy packages at four locations to enable geophysical measurements for 6-10 years. Returning to the lunar surface with a long-lived geophysical network is a key next step to advance lunar and planetary science. LGN will greatly expand our primarily Apollo-based knowledge of the deep lunar interior by identifying and characterizing mantle melt layers, as well as core size and state. To meet the mission objectives, the instrument suite provides complementary seismic, geodetic, heat flow, and electromagnetic observations. We discuss the network landing site requirements and provide example sites that meet these requirements. Landing site selection will continue to be optimized throughout the formulation of this mission. Possible sites include the P-5 region within the Procellarum KREEP Terrane (PKT; (lat:$15^{circ}$; long:$-35^{circ}$), Schickard Basin (lat:$-44.3^{circ}$; long:$-55.1^{circ}$), Crisium Basin (lat:$18.5^{circ}$; long:$61.8^{circ}$), and the farside Korolev Basin (lat:$-2.4^{circ}$; long:$-159.3^{circ}$). Network optimization considers the best locations to observe seismic core phases, e.g., ScS and PKP. Ray path density and proximity to young fault scarps are also analyzed to provide increased opportunities for seismic observations. Geodetic constraints require the network to have at least three nearside stations at maximum limb distances. Heat flow and electromagnetic measurements should be obtained away from terrane boundaries and from magnetic anomalies at locations representative of global trends. An in-depth case study is provided for Crisium. In addition, we discuss the consequences for scientific return of less than optimal locations or number of stations.
Since the Apollo program or earlier it has been widely believed that the lunar regolith was compacted through vibrations including nearby impact events, thermal stress release in the regolith, deep moon quakes, and shallow moon quakes. Experiments have shown that vibrations both compact and re-loosen regolith as a function of depth in the lunar soil column and amplitude of the vibrational acceleration. Experiments have also identified another process that is extremely effective at compacting regolith: the expansion and contraction of individual regolith grains due to thermal cycling in the upper part of the regolith where the diurnal thermal wave exists. Remote sensing data sets from the Moon suggest that the soil is less compacted in regions where there is less thermal cycling, including infrared emissions measured by the Diviner radiometer on the Lunar Reconnaissance Orbiter (LRO). Here, we performed additional experiments in thermal cycling simulated lunar regolith and confirm that it is an effective compaction mechanism and may explain the remote sensing data. This creates a consistent picture that the soil really is looser in the upper layers in polar regions, which may be a challenge for rovers that must drive in the looser soil.
Identification of the main planet formation site is fundamental to understanding how planets form and migrate to the current locations. We consider the heavy-element content trend of observed exoplanets derived from improved measurements of mass and radius, and explore how this trend can be used as a tracer of their formation sites. Using gas accretion recipes obtained from detailed hydrodynamical simulations, we confirm that the disk-limited gas accretion regime is most important for reproducing the heavy-element content trend. Given that such a regime is specified by two characteristic masses of planets, we compute these masses as a function of the distance ($r$) from the central star, and then examine how the regime appears in the mass-semimajor axis diagram. Our results show that a plausible solid accretion region emerges at $r simeq 0.6$ au and expands with increasing $r$, using the conventional disk model. Given that exoplanets that possess the heavy-element content trend distribute currently near their central stars, our results imply the importance of planetary migration that would occur after solid accretion onto planets might be nearly completed at $r geq 0.6$ au. Self-consistent simulations would be needed to verify the predictions herein.
The history of rivers on Mars is an important constraint on Martian climate evolution. The timing of relatively young, alluvial fan-forming rivers is especially important, as Mars Amazonian atmosphere is thought to have been too thin to consistently support surface liquid water. Previous regional studies suggested that alluvial fans formed primarily between the Early Hesperian and the Early Amazonian. In this study, we describe how a combination of a global impact crater database, a global geologic map, a global alluvial fan database, and statistical models can be used to estimate the timing of alluvial fan formation across Mars. Using our global approach and improved statistical modeling, we find that alluvial fan formation likely persisted into the last ~2.5 Gyr, well into the Amazonian period. However, the data we analyzed was insufficient to place constraints on the duration of alluvial fan formation. Going forward, more crater data will enable tighter constraints on the parameters estimated in our models and thus further inform our understanding of Mars climate evolution.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
