Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userInsights from Synthetic Star-forming Regions: II. Verifying Dust Surface Density, Dust Temperature & Gas Mass Measurements with Modified Blackbody Fitting
128
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We use a large data-set of realistic synthetic observations (PaperI) to assess how observational techniques affect the measurement of physical properties of star-forming regions. In this paper (PaperII), we explore the reliability of the measured total gas mass, dust surface density and dust temperature maps derived from modified blackbody fitting of synthetic Herschel observations. We found from our pixel-by-pixel analysis of the measured dust surface density and dust temperature a worrisome error spread especially close to star-formation sites and low-density regions, where for those contaminated pixels the surface densities can be under/overestimated by up to three orders of magnitude. In light of this, we recommend to treat the pixel-based results from this technique with caution in regions with active star formation. In regions of high background typical in the inner Galactic plane, we are not able to recover reliable surface density maps of individual synthetic regions, since low-mass regions are lost in the FIR background. When measuring the total gas mass of regions in moderate background, we find that modified blackbody fitting works well (absolute error:+9%;-13%) up to 10kpc distance (errors increase with distance). Commonly, the initial images are convolved to the largest common beam-size, which smears contaminated pixels over large areas. The resulting information loss makes this commonly-used technique less verifiable as now chi^2-values cannot be used as a quality indicator of a fitted pixel. Our control measurements of the total gas mass (without the step of convolution to the largest common beam size) produce similar results (absolute error:+20%;-7%) while having much lower median errors especially for the high-mass stellar feedback phase. In upcoming papers (III&IV) we test the reliability of measured star-formation rate with direct and indirect techniques.
rate research
Read More
Through synthetic observations of a hydrodynamical simulation of an evolving star-forming region, we assess how the choice of observational techniques affects the measurements of properties which trace star formation. Testing and calibrating observational measurements requires synthetic observations which are as realistic as possible. In this part of the paper series (Paper I), we explore different techniques for how to map the distributions of densities and temperatures from the particle-based simulations onto a Voronoi mesh suitable for radiative transfer and consequently explore their accuracy. We further test different ways to set up the radiative transfer in order to produce realistic synthetic observations. We give a detailed description of all methods and ultimately recommend techniques. We have found that the flux around 20 microns is strongly overestimated when blindly coupling the dust radiative transfer temperature with the hydrodynamical gas temperature. We find that when instead assuming a constant background dust temperature in addition to the radiative transfer heating, the recovered flux is consistent with actual observations. We present around 5800 realistic synthetic observations for Spitzer and Herschel bands, at different evolutionary time-steps, distances and orientations. In the upcoming papers of this series (Paper II, Paper III and Paper IV), we will test and calibrate measurements of the star-formation rate (SFR), gas mass and the star-formation efficiency (SFE) using our realistic synthetic observations.
Through an extensive set of realistic synthetic observations (produced in Paper I), we assess in this part of the paper series (Paper III) how the choice of observational techniques affects the measurement of star-formation rates (SFRs) in star-forming regions. We test the accuracy of commonly used techniques and construct new methods to extract the SFR, so that these findings can be applied to measure the SFR in real regions throughout the Milky Way. We investigate diffuse infrared SFR tracers such as those using 24 {mu}m, 70 {mu}m and total infrared emission, which have been previously calibrated for global galaxy scales. We set up a toy model of a galaxy and show that the infrared emission is consistent with the intrinsic SFR using extra-galactic calibrated laws (although the consistency does not prove their reliability). For local scales, we show that these techniques produce completely unreliable results for single star-forming regions, which are governed by different characteristic timescales. We show how calibration of these techniques can be improved for single star-forming regions by adjusting the characteristic timescale and the scaling factor and give suggestions of new calibrations of the diffuse star-formation tracers. We show that star-forming regions that are dominated by high-mass stellar feedback experience a rapid drop in infrared emission once high-mass stellar feedback is turned on, which implies different characteristic timescales. Moreover, we explore the measured SFRs calculated directly from the observed young stellar population. We find that the measured point sources follow the evolutionary pace of star formation more directly than diffuse star-formation tracers.
We present {lambda}1.3 mm CARMA observations of dust polarization toward 30 star-forming cores and 8 star-forming regions from the TADPOL survey. We show maps of all sources, and compare the ~2.5 resolution TADPOL maps with ~20 resolution polarization maps from single-dish submillimeter telescopes. Here we do not attempt to interpret the detailed B-field morphology of each object. Rather, we use average B-field orientations to derive conclusions in a statistical sense from the ensemble of sources, bearing in mind that these average orientations can be quite uncertain. We discuss three main findings: (1) A subset of the sources have consistent magnetic field (B-field) orientations between large (~20) and small (~2.5) scales. Those same sources also tend to have higher fractional polarizations than the sources with inconsistent large-to-small-scale fields. We interpret this to mean that in at least some cases B-fields play a role in regulating the infall of material all the way down to the ~1000 AU scales of protostellar envelopes. (2) Outflows appear to be randomly aligned with B-fields; although, in sources with low polarization fractions there is a hint that outflows are preferentially perpendicular to small-scale B-fields, which suggests that in these sources the fields have been wrapped up by envelope rotation. (3) Finally, even at ~2.5 resolution we see the so-called polarization hole effect, where the fractional polarization drops significantly near the total intensity peak. All data are publicly available in the electronic edition of this article.
The infrared data from the Spitzer Space Telescope has provided an invaluable tool for identifying physical processes in star formation. In this study we calculate the IRAC color space of UV fluorescent molecular hydrogen (H$_2$) and Polycyclic Aromatic Hydrocarbon (PAH) emission in photodissociation regions (PDRs) using the Cloudy code with PAH opacities from Draine & Li 2007. We create a set of color diagnostics that can be applied to study the structure of PDRs and to distinguish between FUV excited and shock excited H$_2$ emission. To test this method we apply these diagnostics to Spitzer IRAC data of NGC 2316. Our analysis of the structure of the PDR is consistent with previous studies of the region. In addition to UV excited emission, we identify shocked gas that may be part of an outflow originating from the cluster.
Most protostars have luminosities that are fainter than expected from steady accretion over the protostellar lifetime. The solution to this problem may lie in episodic mass accretion -- prolonged periods of very low accretion punctuated by short bursts of rapid accretion. However, the timescale and amplitude for variability at the protostellar phase is almost entirely unconstrained. In A JCMT/SCUBA-2 Transient Survey of Protostars in Nearby Star Forming Regions, we are monitoring monthly with SCUBA-2 the sub-mm emission in eight fields within nearby (<500 pc) star forming regions to measure the accretion variability of protostars. The total survey area of ~1.6 sq.deg. includes ~105 peaks with peaks brighter than 0.5 Jy/beam (43 associated with embedded protostars or disks) and 237 peaks of 0.125-0.5 Jy/beam (50 with embedded protostars or disks). Each field has enough bright peaks for flux calibration relative to other peaks in the same field, which improves upon the nominal flux calibration uncertainties of sub-mm observations to reach a precision of ~2-3% rms, and also provides quantified confidence in any measured variability. The timescales and amplitudes of any sub-mm variation will then be converted into variations in accretion rate and subsequently used to infer the physical causes of the variability. This survey is the first dedicated survey for sub-mm variability and complements other transient surveys at optical and near-IR wavelengths, which are not sensitive to accretion variability of deeply embedded protostars.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
