Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userFast equilibrium switch of a micro mechanical oscillator
135
0
0.0
(
0
)
Authors
Anne Le Cunuder
Ask ChatGPT about the research
No Arabic abstract
We demonstrate an accurate method to control the motion of a micromechanical oscillator in contact with a thermal bath. The experiment is carried out on the cantilever tip of an Atomic Force Microscope (AFM). Applying an appropriate time dependent external force, we decrease the time necessary to reach equilibrium by two orders of magnitude compared to the intrinsic equilibration time. Finally, we analyze the energetic cost of such a fast equilibration, by measuring with kBT accuracy the energy exchanges along the process.
rate research
Read More
The mechanical resonance properties of a micro-electro-mechanical oscillator with a gap of 1.25 $mu$m was studied in superfluid $^3$He-B at various pressures. The oscillator was driven in the linear damping regime where the damping coefficient is independent of the oscillator velocity. The quality factor of the oscillator remains low ($Qapprox 80$) down to 0.1 $T_c$, 4 orders of magnitude less than the intrinsic quality factor measured in vacuum at 4 K. In addition to the Boltzmann temperature dependent contribution to the damping, a damping proportional to temperature was found to dominate at low temperatures. We propose a multiple scattering mechanism of the surface Andreev bound states to be a possible cause for the anomalous damping.
We study instabilities and relaxation to equilibrium in a long-range extension of the Fermi-Pasta-Ulam-Tsingou (FPU) oscillator chain by exciting initially the lowest Fourier mode. Localization in mode space is stronger for the long-range FPU model. This allows us to uncover the sporadic nature of instabilities, i.e., by varying initially the excitation amplitude of the lowest mode, which is the control parameter, instabilities occur in narrow amplitude intervals. Only for sufficiently large values of the amplitude, the system enters a permanently unstable regime. These findings also clarify the long-standing problem of the relaxation to equilibrium in the short-range FPU model. Because of the weaker localization in mode space of this latter model, the transfer of energy is retarded and relaxation occurs on a much longer time-scale.
Cooling of a 58 MHz micro-mechanical resonator from room temperature to 11 K is demonstrated using cavity enhanced radiation pressure. Detuned pumping of an optical resonance allows enhancement of the blue shifted motional sideband (caused by the oscillators Brownian motion) with respect to the red-shifted sideband leading to cooling of the mechanical oscillator mode. The reported cooling mechanism is a manifestation of the effect of radiation pressure induced dynamical backaction. These results constitute an important step towards achieving ground state cooling of a mechanical oscillator.
Ultralow dissipation plays an important role in sensing applications and exploring macroscopic quantum phenomena using micro-and nano-mechanical systems. We report a diamagnetic-levitated micro-mechanical oscillator operating at a low temperature of 3K with measured dissipation as low as 0.59 $mu$Hz and a quality factor as high as $2 times 10^7$. To the best of our knowledge the achieved dissipation is the lowest in micro- and nano-mechanical systems to date, orders of magnitude improvement over the reported state-of-the-art systems based on different principles. The cryogenic diamagnetic-levitated oscillator described here is applicable to a wide range of mass, making it a good candidate for measuring both force and acceleration with ultra-high sensitivity. By virtue of the naturally existing strong magnetic gradient, this system has great potential in quantum spin mechanics study.
We study numerically the behavior of RNA secondary structures under influence of a varying external force. This allows to measure the work $W$ during the resulting fast unfolding and refolding processes. Here, we investigate a medium-size hairpin structure. Using a sophisticated large-deviation algorithm, we are able to measure work distributions with high precision down to probabilities as small as $10^{-46}$. Due to this precision and by comparison with exact free-energy calculations we are able to verify the theorems of Crooks and Jarzynski. Furthermore, we analyze force-extension curves and the configurations of the secondary structures during unfolding and refolding for typical equilibrium processes and non-equilibrium processes, conditioned to selected values of the measured work $W$, typical and rare ones. We find that the non-equilibrium processes where the work values are close to those which are most relevant for applying Crooks and Jarzynski theorems, respectively, are most and quite similar to the equilibrium processes. Thus, a similarity of equilibrium and non-equilibrium behavior with respect to a mere scalar variable, which occurs with a very small probability but can be generated in a controlled but non-targeted way, is related to a high similarity for the set of configurations sampled along the full dynamical trajectory.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
