Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userThermal convection in granular gases with dissipative lateral walls
67
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We consider a granular gas under the action of gravity, fluidized by a vibrating base. We show that a horizontal temperature gradient, here induced by limiting dissipative lateral walls (DLW), leads always to a granular thermal convection (DLW-TC) that is essentially different from ordinary buoyancy-driven convection (BD-TC). In an experiment where BD-TC is inhibited, by reducing gravity with an inclined plane, we always observe a DLW-TC cell next to each lateral wall. Such a cell squeezes towards the nearest wall as the gravity and/or the number of grains increase. Molecular dynamics simulations reproduce the experimental results and indicate that at large gravity or number of grains the DLW-TC is barely detectable.
rate research
Read More
Buoyancy-driven (thermal) convection in dilute granular media, fluidized by a vibrating base, is known to appear without the need of lateral boundaries in a restricted region of parameters (inelasticity, gravity, intensity of energy injection). We have recently discovered a second buoyancy-driven convection effect which occurs at any value of the parameters, provided that the impact of particles with the lateral walls is inelastic (Pontuale et al., Phys. Rev. Lett. 117, 098006 (2016)). It is understood that this novel convection effect is strictly correlated to the existence of perpendicular energy fluxes: a vertical one, induced by both bulk and wall inelasticity, and a horizontal one, induced only by dissipation at the walls. Here we first review those previous results, and then present new experimental and numerical data concerning the variations of box geometry, intensity of energy injection, number of particles and width of the box.
Thermal wall is a convenient idealization of a rapidly vibrating plate used for vibrofluidization of granular materials. The objective of this work is to incorporate the Knudsen temperature jump at thermal wall in the Navier-Stokes hydrodynamic modeling of dilute granular gases of monodisperse particles that collide nearly elastically. The Knudsen temperature jump manifests itself as an additional term, proportional to the temperature gradient, in the boundary condition for the temperature. Up to a numerical pre-factor of order unity, this term is known from kinetic theory of elastic gases. We determine the previously unknown numerical pre-factor by measuring, in a series of molecular dynamics (MD) simulations, steady-state temperature profiles of a gas of elastically colliding hard disks, confined between two thermal walls kept at different temperatures, and comparing the results with the predictions of a hydrodynamic calculation employing the modified boundary condition. The modified boundary condition is then applied, without any adjustable parameters, to a hydrodynamic calculation of the temperature profile of a gas of inelastic hard disks driven by a thermal wall. We find the hydrodynamic prediction to be in very good agreement with MD simulations of the same system. The results of this work pave the way to a more accurate hydrodynamic modeling of driven granular gases.
The effects of movement of the side walls of a confined granular packing are studied by discrete element, molecular dynamics simulations. The dynamical evolution of the stress is studied as a function of wall movement both in the direction of gravity as well as opposite to it. For all wall velocities explored, the stress in the final state of the system after wall movement is fundamentally different from the original state obtained by pouring particles into the container and letting them settle under the influence of gravity. The original packing possesses a hydrostatic-like region at the top of the container which crosses over to a depth-independent stress. As the walls are moved in the direction opposite to gravity, the saturation stress first reaches a minimum value independent of the wall velocity, then increases to a steady-state value dependent on the wall-velocity. After wall movement ceases and the packing reaches equilibrium, the stress profile fits the classic Janssen form for high wall velocities, while it has some deviations for low wall velocities. The wall movement greatly increases the number of particle-wall and particle-particle forces at the Coulomb criterion. Varying the wall velocity has only small effects on the particle structure of the final packing so long as the walls travel a similar distance.
The expansion of the velocity distribution function for the homogeneous cooling state (HCS) in a Sonine polynomial series around a Maxwellian is shown to be divergent, though Borel resummable. A convergent expansion for the HCS has been devised and employed to obtain the HCS velocity distribution function and (using it) the linear transport coefficients for a three dimensional monodisperse granular gas of smooth inelastic spheres, for all physical values of the coefficient of normal restitution. The results are in very good agreement with findings of DSMC simulations.
A highly polydisperse granular gas is modeled by a continuous distribution of particle sizes, a, giving rise to a corresponding continuous temperature profile, T(a), which we compute approximately, generalizing previous results for binary or multicomponent mixtures. If the system is driven, it evolves towards a stationary temperature profile, which is discussed for several driving mechanisms in dependence on the variance of the size distribution. For a uniform distribution of sizes, the stationary temperature profile is nonuniform with either hot small particles (constant force driving) or hot large particles (constant velocity or constant energy driving). Polydispersity always gives rise to non-Gaussian velocity distributions. Depending on the driving mechanism the tails can be either overpopulated or underpopulated as compared to the molecular gas. The deviations are mainly due to small particles. In the case of free cooling the decay rate depends continuously on particle size, while all partial temperatures decay according to Haffs law. The analytical results are supported by event driven simulations for a large, but discrete number of species.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
