Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userResonance-based Detection of Magnetic Nanoparticles and Microbeads Using Nanopatterned Ferromagnets
244
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Biosensing with ferromagnet-based magnetoresistive devices has been dominated by electrical detection of particle-induced changes to the devices static magnetic configuration. There are however potential advantages to be gained from using field dependent, high frequency magnetization dynamics for magnetic particle detection. Here we demonstrate the use of nano-confined ferromagnetic resonances in periodically patterned magnetic films for the detection of adsorbed magnetic particles with diameters ranging from 6 nm to 4 $mu$m. The nanopatterned films contain arrays of holes which can act as preferential adsorption sites for small particles. Hole-localized particles act in unison to shift the resonant frequencies of the various modes of the patterned layer with shift polarities determined by the localization of each mode within the nanopatterns repeating unit cell. The same polarity shifts are observed for a large range of coverages, even when hole-localized particles are covered by quasi-continuous particle sheets. For large particles however, preferential adsorption no longer occurs, leading to resonance shifts with polarities which are independent of the mode localization. Analogous shifts are seen in continuous layers where, for small particles, the shift of the layers fundamental mode is typically about 10 times less than in patterned systems and induced by relatively weak fields emanating beyond the particle in the direction of the static applied field. This highlights the importance of having confined modes consistently positioned with respect to nearby particles.
rate research
Read More
We present a study by ferromagnetic resonance at microwave Q band of two sheets of cobalt nanoparticles obtained by annealing SiO2 layers implanted with cobalt ions. This ex- perimental study is performed as a function of the applied magnetic field orientation, tempera- ture, and dose of implanted cobalt ions. We demonstrate that each of those magnetic sheet of cobalt nanoparticles can be well modelled by a nearly two dimensional ferromagnetic sheet hav- ing a reduced effective saturation magnetization, compared to a regular thin film of cobalt. The nanoparticles are found superparamagnetic above around 210 K and ferromagnetic below this blocking temperature. Magnetostatic calculations show that a strong magnetic field gradient of around 0.1 G/nm could be produced by a ferromagnetic nanostripe patterned in such magnetic sheet of cobalt nanoparticles. Such a strong magnetic field gradient combined with electron para- magnetic resonance may be relevant for implementing an intermediate scale quantum computer based on arrays of coupled electron spins, as previously reported (Eur. Phys. J. B (2014) 87, 183). However, this new approach only works if no additional spin decoherence is introduced by the spin waves exitations of the ferromagnetic nanostructure. We thus suggest theoretically some possible magnetic anisotropy engineering of cobalt nanoparticles that could allow to suppress the spin qubit decoherence induced by the unwanted collective excitation of their spins.
Magnetic nanoparticles (MNPs) have excellent magnetic-temperature characteristic. However, current temperature measurement based on MNPs is interfered by concentration. Utilizing the electron spin resonance (ESR), we propose a highly sensitive temperature measurement method without concentration coupling. The anisotropic field is affected by temperature, thus affecting the g-value. The influence of the MNP concentration, size, and the data analysis method on temperature estimation are studied. The optimal temperature sensitivity is achieved with 15-nm MNPs while Gaussian smoothing method allows an optimal accuracy at Fe concentration of 5 mg/ml with a root mean squared error of 0.07 K.
We address the theory of the coupled lattice and magnetization dynamics of freely suspended single-domain nanoparticles. Magnetic anisotropy generates low-frequency satellite peaks in the microwave absorption spectrum and a blueshift of the ferromagnetic resonance (FMR) frequency. The low-frequency resonances are very sharp with maxima exceeding that of the FMR, because their magnetic and mechanical precessions are locked, thereby suppressing Gilbert damping. Magnetic nanoparticles can operate as nearly ideal motors that convert electromagnetic into mechanical energy. The Barnett/Einstein-de Haas effect is significant even in the absence of a net rotation.
The inertial dynamics of magnetization in a ferromagnet is investigated theoretically. The analytically derived dynamic response upon microwave excitation shows two peaks: ferromagnetic and nutation resonances. The exact analytical expressions of frequency and linewidth of the magnetic nutation resonance are deduced from the frequency dependent susceptibility determined by the inertial Landau-Lifshitz-Gilbert equation. The study shows that the dependence of nutation linewidth on the Gilbert precession damping has a minimum, which becomes more expressive with increase of the applied magnetic field.
The dynamic magnetic susceptibility of magnetic materials near ferromagnetic resonance (FMR) is very important in interpreting dc-voltage in electrical detection of FMR. Based on the causality principle and the assumption that the usual microwave absorption lineshape around FMR is Lorentzian, general forms of dynamic susceptibility of an arbitrary sample and the corresponding dc-voltage lineshape are obtained. Our main findings are: 1) The dynamic susceptibility is not a Polder tensor for material with arbitrary anisotropy. Two off-diagonal elements are not in general opposite to each other. However, the linear response coefficient of magnetization to total rf field is a Polder tensor. This may explain why two off-diagonal elements are always assumed to be opposite to each other in analyses. 2) The frequency dependence of dynamic susceptibility near FMR is fully characterized by six numbers while its field dependence is fully characterized by seven numbers. 3) A recipe of how to determine these numbers by standard microwave absorption measurements for an arbitrary sample is proposed. Our results allow one to unambiguously separate the contribution of the anisotropic magnetoresistance to dc-voltage from that of the anomalous Hall effect. With these results, one can reliably extract the information of spin pumping and the inverse spin Hall effect, and determine the spin-Hall angle. 4) The field-dependence of susceptibility matrix at a fixed frequency may have several peaks when the effective field is not monotonic of the applied field. In contrast, the frequency-dependence of susceptibility matrix at a fixed field has only one peak. Furthermore, in the case that resonance frequency is not sensitive to the applied field, the field dependence of susceptibility matrix, as well as dc-voltage, may have another non-resonance broad peak. Thus, one should be careful in interpreting observed peaks.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
