Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCoronal response to an EUV wave from DEM analysis
245
0
0.0
(
0
)
Added by
Kamalam Vanninathan
Publication date
2015
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
EUV (Extreme-Ultraviolet) waves are globally propagating disturbances that have been observed since the era of the SoHO/EIT instrument. Although the kinematics of the wave front and secondary wave components have been widely studied, there is not much known about the generation and plasma properties of the wave. In this paper we discuss the effect of an EUV wave on the local plasma as it passes through the corona. We studied the EUV wave, generated during the 2011 February 15 X-class flare/CME event, using Differential Emission Measure diagnostics. We analyzed regions on the path of the EUV wave and investigated the local density and temperature changes. From our study we have quantitatively confirmed previous results that during wave passage the plasma visible in the Atmospheric Imaging Assembly (AIA) 171A channel is getting heated to higher temperatures corresponding to AIA 193A and 211A channels. We have calculated an increase of 6 - 9% in density and 5 - 6% in temperature during the passage of the EUV wave. We have compared the variation in temperature with the adiabatic relationship and have quantitatively demonstrated the phenomenon of heating due to adiabatic compression at the wave front. However, the cooling phase does not follow adiabatic relaxation but shows slow decay indicating slow energy release being triggered by the wave passage. We have also identified that heating is taking place at the front of the wave pulse rather than at the rear. Our results provide support for the case that the event under study here is a compressive fast-mode wave or a shock.
rate research
Read More
On 17 January 2010, STEREO-B observed in extreme ultraviolet (EUV) and white light a large-scale dome-shaped expanding coronal transient with perfectly connected off-limb and on-disk signatures. Veronig et al. (2010, ApJL 716, 57) concluded that the dome was formed by a weak shock wave. We have revealed two EUV components, one of which corresponded to this transient. All of its properties found from EUV, white light, and a metric type II burst match expectations for a freely expanding coronal shock wave including correspondence to the fast-mode speed distribution, while the transient sweeping over the solar surface had a speed typical of EUV waves. The shock wave was presumably excited by an abrupt filament eruption. Both a weak shock approximation and a power-law fit match kinematics of the transient near the Sun. Moreover, the power-law fit matches expansion of the CME leading edge up to 24 solar radii. The second, quasi-stationary EUV component near the dimming was presumably associated with a stretched CME structure; no indications of opening magnetic fields have been detected far from the eruption region.
Understanding the density structure of the solar corona is important for modeling both coronal heating and the solar wind. Direct measurements are difficult because of line-of-sight integration and possible unresolved structures. We present a new method for quantifying such structure using density-sensitive EUV line intensities to derive a density irregularity parameter, a relative measure of the amount of structure along the line of sight. We also present a simple model to relate the inferred irregularities to physical quantities, such as the filling factor and density contrast. For quiet Sun regions and interplume regions of coronal holes, we find a density contrast of at least a factor of three to ten and corresponding filling factors of about 10-20%. Our results are in rough agreement with other estimates of the density structures in these regions. The irregularity diagnostic provides a useful relative measure of unresolved structure in various regions of the corona.
We present first observations of a dome-shaped large-scale EUV coronal wave, recorded by the EUVI instrument onboard STEREO-B on January 17, 2010. The main arguments that the observed structure is the wave dome (and not the CME) are: a) the spherical form and sharpness of the domes outer edge and the erupting CME loops observed inside the dome; b) the low-coronal wave signatures above the limb perfectly connecting to the on-disk signatures of the wave; c) the lateral extent of the expanding dome which is much larger than that of the coronal dimming; d) the associated high-frequency type II burst indicating shock formation low in the corona. The velocity of the upward expansion of the wave dome ($v sim 650$ km s$^{-1}$) is larger than that of the lateral expansion of the wave ($v sim 280$ km s$^{-1}$), indicating that the upward dome expansion is driven all the time, and thus depends on the CME speed, whereas in the lateral direction it is freely propagating after the CME lateral expansion stops. We also examine the evolution of the perturbation characteristics: First the perturbation profile steepens and the amplitude increases. Thereafter, the amplitude decreases with r$^{-2.5 pm 0.3}$, the width broadens, and the integral below the perturbation remains constant. Our findings are consistent with the spherical expansion and decay of a weakly shocked fast-mode MHD wave.
In this study, we investigate an extreme ultraviolet (EUV) wave event on 2010 February 11, which occurred as a limb event from the Earth viewpoint and a disk event from the STEREO--B viewpoint. We use the data obtained by the Atmospheric Imaging Assembly (AIA) aboard the Solar Dynamics Observatory (SDO) in various EUV channels. The EUV wave event was launched by a partial prominence eruption. Similar to some EUV wave events in previous works, this EUV wave event contains a faster wave with a speed of $sim$445$pm$6 km s$^{-1}$, which we call coronal Moreton wave, and a slower wave with a speed of $sim$298$pm$5 km s$^{-1}$, which we call EIT wave. The coronal Moreton wave is identified as a fast-mode wave and the EIT wave is identified as an apparent propagation due to successive field-line stretching. We also observe a stationary front associated with the fast mode EUV wave. This stationary front is explained as mode conversion from the coronal Moreton wave to a slow-mode wave near a streamer.
Multi-wavelength solar images in the EUV are routinely used for analysing solar features such as coronal holes, filaments, and flares. However, images taken in different bands often look remarkably similar as each band receives contributions coming from regions with a range of different temperatures. This has motivated the search for empirical techniques that may unmix these contributions and concentrate salient morphological features of the corona in a smaller set of less redundant source images. Blind Source Separation (BSS) precisely does this. Here we show how this novel concept also provides new insight into the physics of the solar corona, using observations made by SDO/AIA. The source images are extracted using a Bayesian positive source separation technique. We show how observations made in six spectral bands, corresponding to optically thin emissions, can be reconstructed by linear combination of three sources. These sources have a narrower temperature response and allow for considerable data reduction since the pertinent information from all six bands can be condensed in only one single composite picture. In addition, they give access to empirical temperature maps of the corona. The limitations of the BSS technique and some applications are briefly discussed.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
