Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMinimum X-ray source size for a lamp-post corona in light-bending models for AGN
118
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The lamppost model is often used to describe the X-ray source geometry in AGN, where an infinitesimal point source is located on the black hole spin axis. This is especially invoked for Narrow Line Seyfert 1 (NLS1) galaxies, where an extremely broad iron line seen in episodes of low X-ray flux can both be explained by extremely strong relativistic effects as the source approaches the black hole horizon. The most extreme spectrum seen from the NLS1 1H0707-495 requires that the source is less than 1Rg above the event horizon in this geometry. However, the source must also be large enough to intercept sufficient seed photons from the disk to make the hard X-ray Compton continuum which produces the observed iron line/reflected spectrum. We use a fully relativistic ray tracing code to show that this implies that the source must be substantially larger than 1Rg in 1H0707-495 if the disk is the source of seed photons. Hence the source cannot fit as close as 1Rg to the horizon, so the observed spectrum and variability are not formed purely by effects of strong gravity but probably also by changes in corona and inner accretion flow geometry.
rate research
Read More
[Abridged] Context. The high-energy radiation from black-hole binaries may be due to the reprocessing of a lamp located on the black hole axis, emitting X-rays. The observed spectrum is made of 3 components: the direct spectrum; the thermal bump; and the reflected spectrum made of the Compton hump and the iron-line complex. Aims. We aim at computing accurately the complete reprocessed spectrum (thermal bump + reflected) of black-hole binaries over the entire X-ray band. We also determine the strength of the direct component. Our choice of parameters is adapted to a source showing an important thermal component. Methods. We compute in full GR the illumination of a thin disk by a lamp along the rotation axis. We use the ATM21 radiative transfer code to compute the spectrum emitted along the disk. We ray trace this local spectrum to determine the reprocessed spectrum as observed at infinity. We discuss the dependence of the local and ray-traced spectra on the emission angle and spin. Results. We show the importance of the angle dependence of the total disk specific intensity spectrum emitted by the illuminated atmosphere when the thermal disk emission if fully taken into account. High spin implies high temperature in the inner regions, so the emitted thermal disk spectrum covers the iron-line complex. As a result we locally observe absorption lines produced in the hot disk atmosphere. Absorption lines are narrow and disappear after ray tracing the local spectrum. Conclusions. Our results mainly highlight the importance of considering the angle dependence of the local spectrum when computing reprocessed spectra, as was already found in a recent study. The main new result of our work is to show the importance of computing the thermal bump of the spectrum, as this feature can change considerably the observed iron-line complex.
We discuss a model of an X-ray illuminating source above an accretion disk of a rotating black hole. Within the so called lamp-post scheme we compute the expected (observed) polarization properties of the radiation reaching an observer. We explore the dependencies on model parameters, employing Monte Carlo radiation transfer computations of the X-ray reflection on the accretion disk and taking general relativity effects into account. In particular, we discuss the role of the black hole spin, of the observer viewing angle, and of the primary X-ray source distance from the black hole. We give several examples of the resulting polarization degree for two types of exemplary objects - active galactic nuclei and Galactic black holes. In order to assess potential observability of the polarization features, we assume the sensitivity of the proposed New Hard X-ray Mission (NHXM). We examine the energy range from several keV to ~50 keV, so the iron-line complex and the Compton hump are included in our model spectra. We find the resultant polarization degree to increase at the higher end of the studied energy band, i.e. at >~20 keV. Thus, the best results for polarimetry of reflection spectra should be achieved at the Compton hump energy region. We also obtain higher polarization degree for large spin values of the black hole, small heights of the primary source, and low inclination angles of the observer.
The innermost regions of accretion disks around black holes are strongly irradiated by X-rays that are emitted from a highly variable, compact corona, in the immediate vicinity of the black hole. The X-rays that are seen reflected from the disk and the time delays, as variations in the X-ray emission echo or reverberate off the disk provide a view of the environment just outside the event horizon. I Zwicky 1 (I Zw 1), is a nearby narrow line Seyfert 1 galaxy. Previous studies of the reverberation of X-rays from its accretion disk revealed that the corona is composed of two components; an extended, slowly varying component over the surface of the inner accretion disk, and a collimated core, with luminosity fluctuations propagating upwards from its base, which dominates the more rapid variability. Here we report observations of X-ray flares emitted from around the supermassive black hole in I Zw 1. X-ray reflection from the accretion disk is detected through a relativistically broadened iron K line and Compton hump in the X-ray emission spectrum. Analysis of the X-ray flares reveals short flashes of photons consistent with the re-emergence of emission from behind the black hole. The energy shifts of these photons identify their origins from different parts of the disk. These are photons that reverberate off the far side of the disk and bent around the black hole and magnified by the strong gravitational field. Observing photons bent around the black hole confirms a key prediction of General Relativity.
We develop a physically motivated, spherical corona model to investigate the frequency-dependent time lags in AGN. The model includes the effects of Compton up-scattering between the disc UV photons and coronal electrons, and the subsequent X-ray reverberation from the disc. The time lags are associated with the time required for multiple scatterings to boost UV photons up to soft and hard X-ray energies, and the light crossing time the photons take to reach the observer. This model can reproduce not only low-frequency hard and high-frequency soft lags, but also the clear bumps and wiggles in reverberation profiles which should explain the wavy-residuals currently observed in some AGN. Our model supports an anti-correlation between the optical depth and coronal temperatures. In case of an optically thin corona, time delays due to propagating fluctuations may be required to reproduce observed time lags. We fit the model to the lag-frequency data of 1H0707-495, Ark 564, NGC 4051 and IRAS 13224-3809 estimated using the minimal bias technique so that the observed lags here are highest-possible quality. We find their corona size is ~7-15 r_g having the constrained optical depth ~2-10. The coronal temperature is ~150-300 keV. Finally, we note that the reverberation wiggles may be signatures of repeating scatters inside the corona that control the distribution of X-ray sources.
The Lightweight Asymmetry and Magnetism Probe (LAMP) is a micro-satellite mission concept dedicated for astronomical X-ray polarimetry and is currently under early phase study. It consists of segmented paraboloidal multilayer mirrors with a collecting area of about 1300 cm^2 to reflect and focus 250 eV X-rays, which will be detected by position sensitive detectors at the focal plane. The primary targets of LAMP include the thermal emission from the surface of pulsars and synchrotron emission produced by relativistic jets in blazars. With the expected sensitivity, it will allow us to detect polarization or place a tight upper limit for about 10 pulsars and 20 blazars. In addition to measuring magnetic structures in these objects, LAMP will also enable us to discover bare quark stars if they exist, whose thermal emission is expected to be zero polarized, while the thermal emission from neutron stars is believed to be highly polarized due to plasma polarization and the quantum electrodynamics (QED) effect. Here we present an overview of the mission concept, its science objectives and simulated observational results.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
