Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSolar energy conversion properties and defect physics of ZnSiP$_2$
486
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Implementation of an optically active material on silicon has been a persistent technological challenge. For tandem photovoltaics using a Si bottom cell, as well as for other optoelectronic applications, there has been a longstanding need for optically active, wide band gap materials that can be integrated with Si. ZnSiP$_2$ is a stable, wide band gap (2.1 eV) material that is lattice matched with silicon and comprised of inexpensive elements. As we show in this paper, it is also a defect-tolerant material. Here, we report the first ZnSiP$_2$ photovoltaic device. We show that ZnSiP$_2$ has excellent photoresponse and high open circuit voltage of 1.3 V, as measured in a photoelectrochemical configuration. The high voltage and low band gap-voltage offset are on par with much more mature wide band gap III-V materials. Photoluminescence data combined with theoretical defect calculations illuminate the defect physics underlying this high voltage, showing that the intrinsic defects in ZnSiP$_2$ are shallow and the minority carrier lifetime is 7 ns. These favorable results encourage the development of ZnSiP$_2$ and related materials as photovoltaic absorber materials.
rate research
Read More
Future generations of photoelectrodes for solar fuel generation must employ inexpensive, earth-abundant absorber materials in order to provide a large-scale source of clean energy. These materials tend to have poor electrical transport properties and exhibit carrier diffusion lengths which are significantly shorter than the absorption depth of light. As a result, many photo-excited carriers are generated too far from a reactive surface, and recombine instead of participating in solar-to-fuel-conversion. We demonstrate that plasmonic resonances in metallic nanostructures and multi-layer interference effects can be engineered to strongly concentrate sunlight close to the electrode/liquid interface, precisely where the relevant reactions take place. By comparing spectral features in the enhanced photocurrent spectra to full-field electromagnetic simulations, the contribution of surface plasmon excitations is verified. These results open the door to the optimization of a wide variety of photochemical processes by leveraging the rapid advances in the field of plasmonics.
Defects in semiconductors can exhibit multiple charge states, which can be used for charge storage applications. Here we consider such charge storage in a series of oxygen deficient phases of TiO$_2$, known as Magneli phases. These Ti$_n$O$_{2n-1}$ Magneli phases present well-defined crystalline structures, i. e., their deviation from stoichiometry is accommodated by changes in space group as opposed to point defects. We show that these phases exhibit intermediate bands with the same electronic quadruple donor transitions akin to interstitial Ti defect levels in TiO$_2$-rutile. Thus, the Magneli phases behave as if they contained a very large pseudo-defect density: $frac{1}{2}$ per formula unit Ti$_n$O$_{2n-1}$. Depending on the Fermi Energy the whole material will become charged. These crystals are natural charge storage materials with a storage capacity that rivals the best known supercapacitors.
An important challenge in the field of topological materials is to carefully disentangle the electronic transport contribution of the topological surface states from that of the bulk. For Bi$_2$Te$_3$ topological insulator samples, bulk single crystals and thin films exposed to air during fabrication processes are known to be bulk conducting, with the chemical potential in the bulk conduction band. For Bi$_2$Te$_3$ thin films grown by molecular beam epitaxy, we combine structural characterization (transmission electron microscopy), chemical surface analysis as function of time (x-ray photoelectron spectroscopy) and magnetotransport analysis to understand the low defect density and record high bulk electron mobility once charge is doped into the bulk by surface degradation. Carrier densities and electronic mobilities extracted from the Hall effect and the quantum oscillations are consistent and reveal a large bulk carrier mobility. Because of the cylindrical shape of the bulk Fermi surface, the angle dependence of the bulk magnetoresistance oscillations is two-dimensional in nature.
We propose a solar thermal energy conversion system consisting of a solar absorber, a thermoradiative cell or negative illumination photodiode, and a photovoltaic cell. Because it is a heat engine, this system can also be paired with thermal storage to provide reliable electricity generation. Heat from the solar absorber drives radiative recombination current in the thermoradiative cell, and its emitted light is absorbed by the photovoltaic cell to provide an additional photocurrent. Based on the principle of detailed balance, we calculate a limiting solar conversion efficiency of 85% for fully concentrated sunlight and 45% for one sun with an absorber and single-junction cells of equal areas. Ideal and nonideal solar thermoradiative-photovoltaic systems outperform solar thermophotovoltaic converters for low bandgaps and practical absorber temperatures. Their performance enhancement results from a high tolerance to nonradiative generation/recombination and an ability to minimize radiative heat losses. We show that a realistic device with all major losses could achieve increases in solar conversion efficiency by up to 7.9% (absolute) compared to a solar thermophotovoltaic device under low optical concentration. Our results indicate that these converters could serve as efficient heat engines for low cost single axis tracking systems.
MnBi$_2$Te$_4$ (MBT) materials are promising antiferromagnetic topological insulators where field driven ferromagnetism is predicted to cause a transition between axion insulator and Weyl semimetallic states. However, the presence of antiferromagnetic coupling between Mn/Bi antisite defects and the main Mn layer can reduce the low-field magnetization, and it has been shown that such defects are more prevalent in the structurally identical trivial magnetic insulator MnSb$_2$Te$_4$ (MST). We use high-field magnetization measurements to show that the magnetization of MBT and MST occur in stages and full saturation requires fields of~$sim$~60 Tesla. As a consequence, the low-field magnetization plateau state in MBT, where many determinations of quantum anomalous Hall state are studied, actually consists of ferrimagnetic septuple blocks containing both a uniform and staggered magnetization component.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
