Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userLarge Tunneling Anisotropic Magneto-Seebeck Effect in a CoPt|MgO|Pt Tunnel Junction
121
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We theoretically investigate the Tunneling Anisotropic Magneto-Seebeck effect in a realistically-modeled CoPt|MgO|Pt tunnel junction using coherent transport calculations. For comparison we study the tunneling magneto-Seebeck effect in CoPt|MgO|CoPt as well. We find that the magneto-Seebeck ratio of CoPt|MgO|Pt exceeds that of CoPt|MgO|CoPt for small barrier thicknesses, reaching 175% at room temperature. This result provides a sharp contrast to the magnetoresistance, which behaves oppositely for all barrier thicknesses and differs by one order of magnitude between devices. Here the magnetoresistance results from differences in transmission brought upon by changing the tunnel junctions magnetization configuration. The magneto-Seebeck effect results from variations in asymmetry of the energy-dependent transmission instead. We report that this difference in origin allows for CoPt|MgO|Pt to possess strong thermal magnetic-transport anisotropy.
rate research
Read More
We find an unusual angular dependence of the tunneling magneto-Seebeck effect (TMS). The conductance shows normally a cosine-dependence with the angle between the magnetizations of the two ferromagnetic leads. In contrast, the angular dependence of the TMS depends strongly on the tunneling magneto resistance (TMR) ratio. For small TMR ratios we obtain also a cosine-dependence whereas for very large TMR ratios the angular dependence approaches a step-like function.
The angular dependence of the thermal transport in insulating or conducting ferromagnets is derived on the basis of the Onsager reciprocity relations applied to a magnetic system. It is shown that the angular dependence of the temperature gradient takes the same form as that of the anisotropic magnetoresistance, including anomalous and planar Hall contributions. The measured thermocouple generated between the extremities of the non-magnetic electrode in thermal contact to the ferromagnet follows this same angular dependence. The sign and amplitude of the magneto-voltaic signal is controlled by the difference of the Seebeck coefficients of the thermocouple.
We investigate the spin-dependent Seebeck coefficient and the tunneling magneto thermopower of CoFeB/MgO/CoFeB magnetic tunnel junctions (MTJ) in the presence of thermal gradients across the MTJ. Thermal gradients are generated by an electric heater on top of the nanopillars. The thermo power voltage across the MTJ is found to scale linearly with the heating power and reveals similar field dependence as the tunnel magnetoresistance. The amplitude of the thermal gradient is derived from calibration measurements in combination with finite element simulations of the heat flux. Based on this, large spin-dependent Seebeck coefficients of the order of (240 pm 110) muV/K are derived. From additional measurements on MTJs after dielectric breakdown, a tunneling magneto thermopower up to 90% can be derived for 1.5 nm MgO based MTJ nanopillars.
Thermoelectric effects in magnetic tunnel junctions are currently an attractive research topic. Here, we demonstrate that the tunnel magneto-Seebeck effect (TMS) in CoFeB/MgO/CoFeB tunnel junctions can be switched on to a logic 1 state and off to 0 by simply changing the magnetic state of the CoFeB electrodes. We enable this new functionality of magnetic tunnel junctions by combining a thermal gradient and an electric field. This new technique unveils the bias-enhanced tunnel magneto-Seebeck effect, which can serve as the basis for logic devices or memories in a green information technology with a pure thermal write and read process. Furthermore, the thermally generated voltages that are referred to as the Seebeck effect are well known to sensitively depend on the electronic structure and therefore have been valued in solid-state physics for nearly one hundred years. Here, we lift Seebecks historic discovery from 1821 to a new level of current spintronics. Our results show that the signal crosses zero and can be adjusted by tuning a bias voltage that is applied between the electrodes of the junction; hence, the name of the effect is bias-enhanced tunnel magneto-Seebeck effect (bTMS). Via the spin- and energy-dependent transmission of electrons in the junction, the bTMS effect can be configured using the bias voltage with much higher control than the tunnel magnetoresistance (TMR) and even completely suppressed for only one magnetic configuration, which is either parallel (P) or anti-parallel (AP). This option allows a readout contrast for the magnetic information of -3000% at room temperature while maintaining a large signal for one magnetic orientation. This contrast is much larger than the value that can be obtained using the TMR effect. Moreover, our measurements are a step towards the experimental realization of high TMS ratios, which are predicted for specific Co-Fe compositions.
We study the tunneling magneto thermo power (TMTP) in CoFeB/MgO/CoFeB magnetic tunnel junction nanopillars. Thermal gradients across the junctions are generated by a micropatterned electric heater line. Thermo power voltages up to a few tens of muV between the top and bottom contact of the nanopillars are measured which scale linearly with the applied heating power and hence with the applied temperature gradient. The thermo power signal varies by up to 10 muV upon reversal of the relative magnetic configuration of the two CoFeB layers from parallel to antiparallel. This signal change corresponds to a large spin-dependent Seebeck coefficient of the order of 100 muV/K and a large TMTP change of the tunnel junction of up to 90%.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
