Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMagnetism in nanoparticle LaCoO3
90
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
LaCoO3 (LCO) nanoparticles were synthesized and their magnetic and structural properties were examined using SQUID magnetometery and neutron diffraction. The nanoparticles exhibit ferromagnetic long-range order beginning at T_C approximately 87K that persists to low temperatures. This behavior is contrasted with the ferromagnetism of bulk LCO, which also starts at T_C approximately 87K but is suppressed below a second transition at T_o approximately 37K, due to a structural phase transition. The ferromagnetism in both systems is attributed to the tensile stress from particle surfaces and impurity phase interfaces. This stress locally increases the Co-O-Co bond angle gamma, and competes with the thermal contraction of the lattice. It has recently been shown that LCO loses long-range ferromagnetic order when gamma decreases below the critical value gamma_c = 162.8 degrees. Consistent with this model, we show that gamma in nanoparticles remains larger than gamma_c at low temperatures, likely a consequence of all spins being in close proximity to surfaces or interfaces.
rate research
Read More
Bulk and nanoparticle powders of LaCoO3 (LCO) were synthesized, and their magnetic and structural properties were studied using SQUID magnetometry and neutron diffraction. The bulk and large nanoparticles exhibit weak ferromagnetism (FM) below T ~ 85K and a crossover from strong to weak antiferromagnetic (AFM) correlations near a transition expressed in the lattice parameters, To ~ 40K. This crossover does not occur in the smallest nanoparticles; instead, the magnetic behavior is predominantly ferromagnetic. The amount of FM in the nanoparticles depends on the amount of Co3O4 impurity phase, which induces tensile strain on the LCO lattice. A core-interface model is introduced, with the core region exhibiting the AFM crossover and with FM in the interface region near surfaces and impurity phases.
Bulk La_wCoO3 particles with w=1.1, 1.0, 0.9, 0.8, and 0.7 were synthesized using starting materials with varying molar ratios of La2O3 and Co3O4. The resulting particles are characterized as LaCoO3 crystals interfaced with a crystalline Co3O4 phase. X-ray and neutron scattering data show little effect on the average structure and lattice parameters of the LaCoO3 phase resulting from the Co3O4 content, but magnetization data indicate that the amount of Co3O4 strongly affects the ferromagnetic ordering at the interfaces below T_C ~89K. In addition to ferromagnetic long-range order, LaCoO3 exhibits antiferromagnetic behavior with an unusual temperature dependence. The magnetization for fields 20 Oe < H < 5 kOe is fit to a combination of a power law ((T-T_C)/T_C)^beta behavior representing the ferromagnetic long-range order and sigmoid-convoluted Curie-Weiss-like behavior representing the antiferromagnetic behavior. The critical exponent beta=0.63 +- 0.02 is consistent with 2D (surface) ordering. Increased Co3O4 correlates well to increased ferromagnetism. The weakening of the antiferromagnetism below T ~ 40K is a consequence of the lattice reaching a critical rhombahedral distortion as T is decreased for core regions far from the Co3O4 interfaces. We introduce a model that describes the ferromagnetic behavior of the interface regions and the unusual antiferromagnetism of the core regions.
We present magnetization and magnetostriction studies of the insulating perovskite LaCoO3 in magnetic fields approaching 100 T. In marked contrast with expectations from single-ion models, the data reveal two distinct first-order spin transitions and well-defined magnetization plateaux. The magnetization at the higher plateau is only about half the saturation value expected for spin-1 Co3+ ions. These findings strongly suggest collective behavior induced by strong interactions between different electronic -- and therefore spin -- configurations of Co3+ ions. We propose a model of these interactions that predicts crystalline spin textures and a cascade of four magnetic phase transitions at high fields, of which the first two account for the experimental data.
We investigate the structure and magnetic properties of thin films of the LaCoO$_{3}$ compound. Thin films are deposited by pulsed laser deposition on various substrates in order to tune the strain from compressive to tensile. Single-phase (001) oriented LaCoO$_{3}$ layers were grown on all substrates despite large misfits. The tetragonal distortion of the films covers a wide range from -2% to 2.8%. Our LaCoO$_{3}$ films are ferromagnetic with Curie temperature around 85 K, contrary to the bulk. The total magnetic moment is below $1mu_{B}$/Co$^{3+}$, a value relatively small for an exited spin-state of the Co$^{3+}$ ions, but comparable to values reported in literature. A correlation of strain states and magnetic moment of Co$^{3+}$ ions in LaCoO$_{3}$ thin films is observed.
Epitaxially strained LaCoO3 (LCO) thin films were grown with different film thickness, t, on (001) oriented (LaAlO3)0.3(SrAl0.5Ta0.5O3)0.7 (LSAT) substrates. After initial pseudomorphic growth the films start to relieve their strain partly by the formation of periodic nano-twins with twin planes predominantly along the <100> direction. Nano-twinning occurs already at the initial stage of growth, albeit in a more moderate way. Pseudomorphic grains, on the other hand, still grow up to a thickness of at least several tenths of nanometers. The twinning is attributed to the symmetry lowering of the epitaxially strained pseudo-tetragonal structure towards the relaxed rhombohedral structure of bulk LCO. However, the unit-cell volume of the pseudo-tetragonal structure is found to be nearly constant over a very large range of t. Only films with t > 130 nm show a significant relaxation of the lattice parameters towards values comparable to those of bulk LCO.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
