Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStimulated emission from ZnO thin films with high optical gain and low loss
92
0
0.0
(
0
)
Added by
Christophe Couteau Asst Prof
Publication date
2013
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
Stimulated surface- and edge-emission were investigated for ZnO thin films grown epitaxially by pulsed laser deposition. The lasing threshold was 0.32 MW/cm2 for surface pumping and 0.5 MW/cm2 for edge pumping, which is significantly lower than thresholds observed previously. A modified variable stripe length method was used to measure the gain, which was 1369 cm-1 for N-band emission. Losses were measured using the shifting excitation spot method and values of 6.2 cm-1 and 6.3 cm-1 were found for the N-band and P-band, respectively. The measured gain and loss were the highest and lowest (respectively) ever reported for ZnO films.
rate research
Read More
Strontium molybdate (SrMoO3) thin films are shown to exhibit plasmonic behaviour with a zero crossover wavelength of the real part of the dielectric permittivity tunable between 600 and 950 nm (2.05 eV and 1.31 eV). The films are grown epitaxially on strontium titanate (SrTiO3), magnesium oxide (MgO), and lanthanum aluminate (LaAlO3) substrates by pulsed laser deposition. SrMoO3 is shown to have optical losses lower than those of gold at the point at which the real part of the dielectric permittivity is equal to -2, while possessing low electrical resistivity of 100E-6 Ohm cm at room temperature. Spectroscopic ellipsometry measurements reveal that SrMoO3 shows plasmonic behaviour, moreover we demonstrate that the epsilon near zero (ENZ) wavelength is tunable by engineering the residual strain in the films. The relatively broadband ENZ behaviour observed in SrMoO3 demonstrates its potential suitability for transformation optics along with plasmonic applications in the visible to near infrared spectral range.
We report on the growth of epitaxial ZnO thin films and ZnO based heterostructures on sapphire substrates by laser molecular beam epitaxy (MBE). We first discuss some recent developments in laser-MBE such as flexible ultra-violet laser beam optics, infrared laser heating systems or the use of atomic oxygen and nitrogen sources, and describe the technical realization of our advanced laser-MBE system. Then we describe the optimization of the deposition parameters for ZnO films such as laser fluence and substrate temperature and the use of buffer layers. The detailed structural characterization by x-ray analysis and transmission electron microscopy shows that epitaxial ZnO thin films with high structural quality can be achieved, as demonstrated by a small out-of-plane and in-plane mosaic spread as well as the absence of rotational domains. We also demonstrate the heteroepitaxial growth of ZnO based multilayers as a prerequisite for spin transport experiments and the realization of spintronic devices. As an example, we show that TiN/Co/ZnO/Ni/Au multilayer stacks can be grown on (0001)-oriented sapphire with good structural quality of all layers and well defined in-plane epitaxial relations.
Magnetite thin fims have been grown epitaxially on ZnO and MgO substrates using molecular beam epitaxy. The film quality was found to be strongly dependent on the oxygen partial pressure during growth. Structural, electronic, and magnetic properties were analyzed utilizing Low Energy Electron Diffraction (LEED), HArd X-ray PhotoElectron Spectroscopy (HAXPES), Magneto Optical Kerr Effect (MOKE), and X-ray Magnetic Circular Dichroism (XMCD). Diffraction patterns show clear indication for growth in the (111) direction on ZnO. Vertical structure analysis by HAXPES depth profiling revealed uniform magnetite thin films on both type of substrates. Both, MOKE and XMCD measurements show in-plane easy magnetization with a reduced magnetic moment in case of the films on ZnO.
Multilayer films of ZnO with Co were deposited on glass substrates then annealed in a vacuum. The magnetisation of the films increased with annealing but not the magnitude of the magneto-optical signals. The dielectric functions for the films were calculated using the MCD spectra. A Maxwell Garnett theory of a metallic Co/ZnO mixture is presented. The extent to which this explains the MCD spectra taken on the films is discussed.
High quality ZnO thin films were gown using the pulsed laser deposition technique on (0001) Al$_2$O$_3$ substrates in an oxidizing atmosphere, using a Zn metallic target. We varied the growth conditions such as the deposition temperature and the oxygen pressure. First, using a battery of techniques such as x-rays diffraction, Rutherford Backscattering spectroscopy and atomic force microscopy, we evaluated the structural quality, the stress and the degree of epitaxy of the films. Second, the relations between the deposition conditions and the structural properties, that are directly related to the nature of the thin films, are discussed qualitatively. Finally, a number of issues on how to get good-quality ZnO films are addressed.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
