Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMoving mesh cosmology: tracing cosmological gas accretion
252
0
0.0
(
0
)
Authors
Dylan Nelson
Ask ChatGPT about the research
No Arabic abstract
We investigate the nature of gas accretion onto haloes and galaxies at z=2 using cosmological hydrodynamic simulations run with the moving mesh code AREPO. Implementing a Monte Carlo tracer particle scheme to determine the origin and thermodynamic history of accreting gas, we make quantitative comparisons to an otherwise identical simulation run with the smoothed particle hydrodynamics (SPH) code GADGET-3. Contrasting these two numerical approaches, we find significant physical differences in the thermodynamic history of accreted gas in haloes above 10^10.5 solar masses. In agreement with previous work, GADGET simulations show a cold fraction near unity for galaxies forming in massive haloes, implying that only a small percentage of accreted gas heats to an appreciable fraction of the virial temperature during accretion. The same galaxies in AREPO show a much lower cold fraction, <20% in haloes above 10^11 solar masses. This results from a hot gas accretion rate which, at this same halo mass, is an order of magnitude larger than with GADGET, while the cold accretion rate is also lower. These discrepancies increase for more massive systems, and we explain both as due to numerical inaccuracies in the standard formulation of SPH. We also observe that the relatively sharp transition from cold to hot mode dominated accretion, at a halo mass of ~10^11, is a consequence of comparing past gas temperatures to a constant threshold value independent of virial temperature. Examining the spatial distribution of accreting gas, we find that gas filaments in GADGET tend to remain collimated and flow coherently to small radii, or artificially fragment and form a large number of purely numerical blobs. Similar gas streams in AREPO show increased heating and disruption at 0.25-0.5 virial radii and contribute to the hot gas accretion rate in a manner distinct from classical cooling flows.
rate research
Read More
We compare the structural properties of galaxies formed in cosmological simulations using the smoothed particle hydrodynamics (SPH) code GADGET with those using the moving-mesh code AREPO. Both codes employ identical gravity solvers and the same sub-resolution physics but use very different methods to track the hydrodynamic evolution of gas. This permits us to isolate the effects of the hydro solver on the formation and evolution of galactic gas disks in GADGET and AREPO haloes with comparable numerical resolution. In a matching sample of GADGET and AREPO haloes we fit simulated gas disks with exponential profiles. We find that the cold gas disks formed using the moving mesh approach have systematically larger disk scale lengths and higher specific angular momenta than their GADGET counterparts across a wide range in halo masses. For low mass galaxies differences between the properties of the simulated galaxy disks are caused by an insufficient number of resolution elements which lead to the artificial angular momentum transfer in our SPH calculation. We however find that galactic disks formed in massive halos, resolved with 10^6 particles/cells, are still systematically smaller in the GADGET run by a factor of ~2. The reasons for this are: 1) The excessive heating of haloes close to the cooling radius due to spurious dissipation of the subsonic turbulence in GADGET; and 2) The efficient delivery of low angular momentum gaseous blobs to the bottom of the potential well. While this large population of gaseous blobs in GADGET originates from the filaments which are pressure confined and fragment due to the SPH surface tension while infalling into hot halo atmospheres, it is essentially absent in the moving mesh calculation, clearly indicating numerical rather than physical origin of the blob material.
We present a detailed comparison between the well-known SPH code GADGET and the new moving-mesh code AREPO on a number of hydrodynamical test problems. Through a variety of numerical experiments we establish a clear link between test problems and systematic numerical effects seen in cosmological simulations of galaxy formation. Our tests demonstrate deficiencies of the SPH method in several sectors. These accuracy problems not only manifest themselves in idealized hydrodynamical tests, but also propagate to more realistic simulation setups of galaxy formation, ultimately affecting gas properties in the full cosmological framework, as highlighted in papers by Vogelsberger et al. (2011) and Keres et al. (2011). We find that an inadequate treatment of fluid instabilities in GADGET suppresses entropy generation by mixing, underestimates vorticity generation in curved shocks and prevents efficient gas stripping from infalling substructures. In idealized tests of inside-out disk formation, the convergence rate of gas disk sizes is much slower in GADGET due to spurious angular momentum transport. In simulations where we follow the interaction between a forming central disk and orbiting substructures in a halo, the final disk morphology is strikingly different. In AREPO, gas from infalling substructures is readily depleted and incorporated into the host halo atmosphere, facilitating the formation of an extended central disk. Conversely, gaseous sub-clumps are more coherent in GADGET simulations, morphologically transforming the disk as they impact it. The numerical artefacts of the SPH solver are particularly severe for poorly resolved flows, and thus inevitably affect cosmological simulations due to their hierarchical nature. Our numerical experiments clearly demonstrate that AREPO delivers a physically more reliable solution.
We discuss cosmological hydrodynamic simulations of galaxy formation performed with the new moving-mesh code AREPO, which promises higher accuracy compared with the traditional SPH technique that has been widely employed for this problem. We use an identical set of physics in corresponding simulations carried out with the well-tested SPH code GADGET, adopting also the same high-resolution gravity solver. We are thus able to compare both simulation sets on an object-by-object basis, allowing us to cleanly isolate the impact of different hydrodynamical methods on galaxy and halo properties. In accompanying papers, we focus on an analysis of the global baryonic statistics predicted by the simulation codes, (Vogelsberger et al. 2011) and complementary idealized simulations that highlight the differences between the hydrodynamical schemes (Sijacki et al. 2011). Here we investigate their influence on the baryonic properties of simulated galaxies and their surrounding haloes. We find that AREPO leads to significantly higher star formation rates for galaxies in massive haloes and to more extended gaseous disks in galaxies, which also feature a thinner and smoother morphology than their GADGET counterparts. Consequently, galaxies formed in AREPO have larger sizes and higher specific angular momentum than their SPH correspondents. The more efficient cooling flows in AREPO yield higher densities and lower entropies in halo centers (and the opposite trend in halo outskirts) leading to higher star formation rates of massive galaxies. While both codes agree to acceptable accuracy on a number of baryonic properties of cosmic structures, our results clearly demonstrate that galaxy formation simulations greatly benefit from the use of more accurate hydrodynamical techniques such as AREPO.
Reconstruction techniques are commonly used in cosmology to reduce complicated nonlinear behaviours to a more tractable linearized system. We study a new reconstruction technique that uses the Moving-Mesh algorithm to estimate the displacement field from nonlinear matter distribution. We show the performance of this new technique by quantifying its ability to reconstruct linear modes. We study the cumulative Fisher information $I(<k_n)$ about the initial matter power spectrum in the matter power spectra in 130 $N$-body simulations before and after reconstruction, and find that the nonlinear plateau of $I(<k_n)$ is increased by a factor of $sim 50$ after reconstruction, from $I simeq 2.5 times 10^{-5} /({rm Mpc}/h)^3$ to $I simeq 1.3 times 10^{-3}/({rm Mpc}/h)^3$ at large $k$. This result includes the decorrelation between initial and final fields, which has been neglected in some previous studies. We expect this technique to be beneficial to problems such as baryonic acoustic oscillations, redshift space distortions and cosmic neutrinos that rely on accurately disentangling nonlinear evolution from underlying linear effects.
We use cosmological SPH simulations to study the kinematic signatures of cool gas accretion onto a pair of well-resolved galaxy halos. Cold-flow streams and gas-rich mergers produce a circum-galactic component of cool gas that generally orbits with high angular momentum about the galaxy halo before falling in to build the disk. This signature of cosmological accretion should be observable using background-object absorption line studies as features that are offset from the galaxys systemic velocity by ~100 km/s. Accreted gas typically co-rotates with the central disk in the form of a warped, extended cold flow disk, such that the observed velocity offset is in the same direction as galaxy rotation, appearing in sight lines that avoid the galactic poles. This prediction provides a means to observationally distinguish accreted gas from outflow gas: the accreted gas will show large one-sided velocity offsets in absorption line studies while radial/bi-conical outflows will not (except possibly in special polar projections). This rotation signature has already been seen in studies of intermediate redshift galaxy-absorber pairs; we suggest that these observations may be among the first to provide indirect observational evidence for cold accretion onto galactic halos. Cold mode halo gas typically has ~3-5 times more specific angular momentum than the dark matter. The associated cold mode disk configurations are likely related to extended HI/XUV disks seen around galaxies in the local universe. The fraction of galaxies with extended cold flow disks and associated offset absorption-line gas should decrease around bright galaxies at low redshift, as cold mode accretion dies out.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
