No Arabic abstract
Spitzer Space Telescope Infrared Array Camera (IRAC) imaging provides an opportunity to study all known morphological types of galaxies in the mid-IR at a depth significantly better than ground-based near-infrared and optical images. The goal of this study is to examine the imprint of the de Vaucouleurs classification volume in the 3.6 micron band, which is the best Spitzer waveband for galactic stellar mass morphology owing to its depth and its reddening-free sensitivity mainly to older stars. For this purpose, we have prepared classification images for 207 galaxies from the Spitzer archive, most of which are formally part of the Spitzer Survey of Stellar Structure in Galaxies (S^4G), a Spitzer post-cryogenic (warm) mission Exploration Science Legacy Program survey of 2,331 galaxies closer than 40 Mpc. For the purposes of morphology, the galaxies are interpreted as if the images are {it blue light}, the historical waveband for classical galaxy classification studies. We find that 3.6 micron classifications are well-correlated with blue-light classifications, to the point where the essential features of many galaxies look very similar in the two very different wavelength regimes. Drastic differences are found only for the most dusty galaxies. Consistent with a previous study by Eskridge et al. (2002), the main difference between blue light and mid-IR types is an approximately 1 stage interval difference for S0/a to Sbc or Sc galaxies, which tend to appear earlier in type at 3.6 microns due to the slightly increased prominence of the bulge, the reduced effects of extinction, and the reduced (but not completely eliminated) effect of the extreme population I stellar component. We present an atlas of all of the 207 galaxies analyzed here, and bring attention to special features or galaxy types that are particularly distinctive in the mid-IR.
This paper is the third which examines galaxy morphology from the point of view of comprehensive de Vaucouleurs revised Hubble-Sandage (CVRHS) classification, a variation on the original de Vaucouleurs classification volume that accounts for finer details of galactic structure, including lenses, nuclear structures, embedded disks, boxy and disky components, and other features. The classification is applied to the EFIGI sample, a well-defined set of nearby galaxies which were previously examined by Baillard et al. and de Lapparent et al. The survey is focussed on statistics of features, and brings attention to exceptional examples of some morphologies, such as skewed bars, blue bar ansae, bar-outer pseudoring misalignment, extremely elongated inner SB rings, outer rings and lenses, and other features that are likely relevant to galactic secular evolution and internal dynamics. The possibility of using these classifications as a training set for automated classification algorithms is also discussed.
The Spitzer Survey of Stellar Structure in Galaxies S^4G is an Exploration Science Legacy Program approved for the Spitzer post-cryogenic mission. It is a volume-, magnitude-, and size-limited (d < 40 Mpc, |b| > 30 degrees, m_(Bcorr) < 15.5, D25>1) survey of 2,331 galaxies using IRAC at 3.6 and 4.5 microns. Each galaxy is observed for 240 s and mapped to > 1.5 x D25. The final mosaicked images have a typical 1 sigma rms noise level of 0.0072 and 0.0093 MJy / sr at 3.6 and 4.5 microns, respectively. Our azimuthally-averaged surface brightness profile typically traces isophotes at mu_3.6 (AB) (1 sigma) ~ 27 mag arcsec^-2, equivalent to a stellar mass surface density of ~ 1 Msun pc^-2. S^4G thus provides an unprecedented data set for the study of the distribution of mass and stellar structures in the local Universe. This paper introduces the survey, the data analysis pipeline and measurements for a first set of galaxies, observed in both the cryogenic and warm mission phase of Spitzer. For every galaxy we tabulate the galaxy diameter, position angle, axial ratio, inclination at mu_3.6 (AB) = 25.5 and 26.5 mag arcsec^-2 (equivalent to ~ mu_B (AB) =27.2 and 28.2 mag arcsec^-2, respectively). These measurements will form the initial S^4G catalog of galaxy properties. We also measure the total magnitude and the azimuthally-averaged radial profiles of ellipticity, position angle, surface brightness and color. Finally, we deconstruct each galaxy using GALFIT into its main constituent stellar components: the bulge/spheroid, disk, bar, and nuclear point source, where necessary. Together these data products will provide a comprehensive and definitive catalog of stellar structures, mass and properties of galaxies in the nearby Universe.
The mid-infrared is an optimal window to trace stellar mass in nearby galaxies and the 3.6$mu m$ IRAC band has been exploited to this effect, but such mass estimates can be biased by dust emission. We present our pipeline to reveal the old stellar flux at 3.6$mu m$ and obtain stellar mass maps for more than 1600 galaxies available from the Spitzer Survey of Stellar Structure in Galaxies (S$^{4}$G). This survey consists of images in two infrared bands (3.6 and 4.5$mu m$), and we use the Independent Component Analysis (ICA) method presented in Meidt et al. (2012) to separate the dominant light from old stars and the dust emission that can significantly contribute to the observed 3.6$mu m$ flux. We exclude from our ICA analysis galaxies with low signal-to-noise ratio (S/N < 10) and those with original [3.6]-[4.5] colors compatible with an old stellar population, indicative of little dust emission (mostly early Hubble types, which can directly provide good mass maps). For the remaining 1251 galaxies to which ICA was successfully applied, we find that as much as 10-30% of the total light at 3.6$mu m$ typically originates from dust, and locally it can reach even higher values. This contamination fraction shows a correlation with specific star formation rates, confirming that the dust emission that we detect is related to star formation. Additionally, we have used our large sample of mass estimates to calibrate a relationship of effective mass-to-light ratio ($M/L$) as a function of observed [3.6]-[4.5] color: $log(M/L)=-0.339 (pm 0.057) times ([3.6]-[4.5]) -0.336 (pm 0.002)$. Our final pipeline products have been made public through IRSA, providing the astronomical community with an unprecedentedly large set of stellar mass maps ready to use for scientific applications.
We investigate the clustering of galaxies selected in the 3.6 micron band of the Spitzer Wide-area Infrared Extragalactic (SWIRE) legacy survey. The angular two-point correlation function is calculated for eleven samples with flux limits of S_3.6 > 4-400 mujy, over an 8 square degree field. The angular clustering strength is measured at >5-sigma significance at all flux limits, with amplitudes of A=(0.49-29)times10^{-3} at one degree, for a power-law model, Atheta^{-0.8}. We estimate the redshift distributions of the samples using phenomological models, simulations and photometric redshifts, and so derive the spatial correlation lengths. We compare our results with the GalICS (Galaxies In Cosmological Simulations) models of galaxy evolution and with parameterized models of clustering evolution. The GalICS simulations are consistent with our angular correlation functions, but fail to match the spatial clustering inferred from the phenomological models or the photometric redshifts. We find that the uncertainties in the redshift distributions of our samples dominate the statistical errors in our estimates of the spatial clustering. At low redshifts (median z<0.5) the comoving correlation length is approximately constant, r_0=6.1pm0.5h^{-1} Mpc, and then decreases with increasing redshift to a value of 2.9pm0.3h^{-1} Mpc for the faintest sample, for which the median redshift is z=1. We suggest that this trend can be attributed to a decrease in the average galaxy and halo mass in the fainter flux-limited samples, corresponding to changes in the relative numbers of early- and late-type galaxies. However, we cannot rule out strong evolution of the correlation length over 0.5<z<1.
We have performed two-dimensional multicomponent decomposition of 144 local barred spiral galaxies using 3.6 $mu {rm m}$ images from the Spitzer Survey of Stellar Structure in Galaxies. Our model fit includes up to four components (bulge, disk, bar, and a point source) and, most importantly, takes into account disk breaks. We find that ignoring the disk break and using a single disk scale length in the model fit for Type II (down-bending) disk galaxies can lead to differences of 40% in the disk scale length, 10% in bulge-to-total luminosity ratio (B/T), and 25% in bar-to-total luminosity ratios. We find that for galaxies with B/T $geq$ 0.1, the break radius to bar radius, $r_{rm br}/R_{rm bar}$, varies between 1 and 3, but as a function of B/T the ratio remains roughly constant. This suggests that in bulge-dominated galaxies the disk break is likely related to the outer Lindblad Resonance (OLR) of the bar, and thus moves outwards as the bar grows. For galaxies with small bulges, B/T $<$ 0.1, $r_{rm br}/R_{rm bar}$ spans a wide range from 1 to 6. This suggests that the mechanism that produces the break in these galaxies may be different from that in galaxies with more massive bulges. Consistent with previous studies, we conclude that disk breaks in galaxies with small bulges may originate from bar resonances that may be also coupled with the spiral arms, or be related to star formation thresholds.