Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDusty winds II. Observational Implications
124
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We compare observations of AGB stars and predictions of the Elitzur & Ivezic (2001) steady-state radiatively driven dusty wind model. The model results are described by a set of similarity functions of a single independent variable, and imply general scaling relations among the system parameters. We find that the model properly reproduces various correlations among the observed quantities and demonstrate that dust drift through the gas has a major impact on the structure of most winds. From data for nearby oxygen-rich and carbon-rich mass-losing stars we find that (1) the dispersion in grain properties within each group is rather small; (2) both the dust cross-section per gas particle and the dust-to-gas mass ratio are similar for the two samples even though the stellar atmospheres and grain properties are very different; (3) the dust abundance in both outflows is significantly below the Galactic average, indicating that most of the Galactic dust is not stardust - contrary to popular belief, but in support of Draine (2009). Our model results can be easily applied to recent massive data sets, such as the Spitzer SAGE survey of the Large Magellanic Cloud, and incorporated in galaxy evolution models.
rate research
Read More
From extensive radiative transfer calculations we find that clumpy torus models with No about 5--15 dusty clouds along radial equatorial rays successfully explain AGN infrared observations. The dust has standard Galactic composition, with individual cloud optical depth tV about 30--100 at visual. The models naturally explain the observed behavior of the 10mic silicate feature, in particular the lack of deep absorption features in AGN of any type. The weak 10mic emission feature tentatively detected in type 2 QSO can be reproduced if in these sources No drops to about 2 or tV exceeds about 100. The clouds angular distribution must have a soft-edge, e.g., Gaussian profile, the radial distribution should decrease as $1/r$ or $1/r^2$. Compact tori can explain all observations, in agreement with the recent interferometric evidence that the ratio of the torus outer to inner radius is perhaps as small as about 5--10. Clumpy torus models can produce nearly isotropic IR emission together with highly anisotropic obscuration, as required by observations. In contrast with strict variants of unification schemes where the viewing-angle uniquely determines the classification of an AGN into type 1 or 2, clumpiness implies that it is only a probabilistic effect; a source can display type 1 properties even from directions close to the equatorial plane. The fraction of obscured sources depends not only on the torus angular thickness but also on the cloud number No. The observed decrease of this fraction at increasing luminosity can be explained with a decrease of either torus angular thickness or cloud number, but only the latter option explains also the possible emergence of a 10mic emission feature in QSO2.
High spatial resolution observations of protoplanetary disks (PPDs) by ALMA have revealed many details that are providing interesting constraints on the disk physics as well as dust dynamics, both of which are essential for understanding planet formation. We carry out high-resolution, 2D global hydrodynamic simulations, including the effects of dust feedback, to study the stability of dusty rings. When the ring edges are relatively sharp and the dust surface density becomes comparable to the gas surface density, we find that dust feedback enhances the radial gradients of both the azimuthal velocity profile and the potential vorticity profile at the ring edges. This eventually leads to instabilities on meso-scales (spatial scales of several disk scale heights), causing dusty rings to be populated with many compact regions with highly concentrated dust densities on meso-scales. We also produce synthetic dust emission images using our simulation results and discuss the comparison between simulations and observations.
A simple 1D dynamical model of thermally driven disc winds is proposed, based on the results of recent, 2.5D axi-symmetric simulations. Our formulation of the disc wind problem is in the spirit of the original Parker (1958) and Bondi (1952) problems, namely we assume an elementary flow configuration consisting of an outflow following pre-defined trajectories in the presence of a central gravitating point mass. Viscosity and heat conduction are neglected. We consider two different streamline geometries, both comprised of straight lines in the (x,z)-plane: (i) streamlines that converge to a geometric point located at (x,z)=(0,-d) and (ii) streamlines that emerge at a constant inclination angle from the disc midplane (the x-axis, as we consider geometrically thin accretion discs). The former geometry is commonly used in kinematic models to compute synthetic spectra, while the latter, which exhibits self-similarity, is likely unused for this purpose, although it easily can be with existing kinematic models. We make the case that it should be, i.e. that geometry (ii) leads to transonic wind solutions with substantially different properties owing to its lack of streamline divergence. Both geometries can be used to complement recent efforts to estimate photoevaporative mass loss rates from protoplanetary discs. Pertinent to understanding our disc wind results, which are also applicable to X-ray binaries and active galactic nuclei, is a focused discussion on lesser known properties of classic Parker wind solutions. We find that the parameter space corresponding to decelerating Parker wind solutions is made larger due to rotation and leads instead to disc wind solutions that always accelerate after the bulk velocity is slowed to a minimum value. Surprisingly, Keplerian rotation may allow for two different transonic wind solutions for the same physical conditions.
Young stars exhibit variability due to changes in the gas accretion rate onto them, an effect that should be quite significant in the early stages of their formation. As protostars are embedded within their natal cloud, this variability may only be inferred through long wavelength observations. We perform radiative transfer simulations of young stellar objects (YSOs) formed in hydrodynamical simulations, varying the structure and luminosity properties in order to estimate the long-wavelength, sub-mm and mm, variations of their flux. We find that the flux increase due to an outburst event depends on the protostellar structure and is more prominent at sub-mm wavelengths than at mm wavelengths; e.g. a factor of 40 increase in the luminosity of the young protostar leads to a flux increase of a factor of 10 at 250 micron but only a factor of 2.5 at 1.3 mm. We find that the interstellar radiation field dilutes the flux increase but that this effect may be avoided if resolution permits the monitoring of the inner regions of a YSO, where the heating is primarily due to protostellar radiation. We also confirm that the bolometric temperature and luminosity of outbursting protostars may result in an incorrect classification of their evolutionary stage.
Tidal encounters in star clusters perturb discs around young protostars. In Cuello et al. (2019a, Paper I) we detailed the dynamical signatures of a stellar flyby in both gas and dust. Flybys produce warped discs, spirals with evolving pitch angles, increasing accretion rates, and disc truncation. Here we present the corresponding observational signatures of these features in optical/near-infrared scattered light and (sub-) millimeter continuum and CO line emission. Using representative prograde and retrograde encounters for direct comparison, we post-process hydrodynamical simulations with radiative transfer methods to generate a catalogue of multi-wavelength observations. This provides a reference to identify flybys in recent near-infrared and sub-millimetre observations (e.g., RW Aur, AS 205, HV Tau & DO Tau, FU Ori, V2775 Ori, and Z CMa).
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
