Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTransient electrical conductivity of W-based electron beam induced deposits during growth, irradiation and exposure to air
125
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
W-based granular metals have been prepared by electron beam induced deposition from the tungsten-hexacarbonyl W(CO)6 precursor. In situ electrical conductivity measurements have been performed to monitor the growth process and to investigate the behavior of the deposit under electron beam post irradiation and by exposure to air. During the first part of the growth process, the electrical conductivity grows non-linearly, independent of the electron beam parameters. This behavior is interpreted as the result of the increase of the W-particles diameter. Once the growth process is terminated, the electrical conductivity decreases with the logarithm of time, sigma ln(t). Temperature-dependent conductivity measurements of the deposits reveal that the electrical transport takes place by means of electron tunneling either between W-metal grains or between grains and trap sites in the matrix. After venting the electron microscope the electrical conductivity of the deposits shows a degradation behavior, which depends on the composition. Electron post-irradiation increases the electrical conductivity of the deposits.
rate research
Read More
We have fabricated Pt-containing granular metals by focused electron beam induced deposition from the $(CH_3)_3CH_3C_5H_4Pt$ precursor gas. The granular metals are made of platinum nanocrystallites embedded in a carbonaceous matrix. We have exposed the as-grown nanocomposites to low energy electron beam irradiation and we have measured the electrical conductivity as a function of the irradiation dose. Postgrowth electron beam irradiation transforms the matrix microstructure and thus the strength of the tunneling coupling between Pt nanocrystallites. For as-grown samples (weak tunnel coupling regime) we find that the temperature dependence of the electrical conductivity follows the stretched exponential behavior characteristic of the correlated variable-range hopping transport regime. For briefly irradiated samples (strong tunnel coupling regime) the electrical conductivity is tuned across the metal-insulator transition. For long-time irradiated samples the electrical conductivity behaves like that of a metal. In order to further analyze changes of the microstructure as a function of the electron irradiation dose we have carried out transmission electron microscope (TEM), micro-Raman and atomic force microscopy (AFM) investigations. TEM pictures reveal that the crystallites size of long-time irradiated samples is larger than that of as-grown samples. Furthermore we do not have evidence of microstructural changes in briefly irradiated samples. By means of micro-Raman we find that by increasing the irradiation dose the matrix changes following a graphitization trajectory between amorphous carbon and nanocrystalline graphite. Finally, by means of AFM measurements we observe a reduction of the volume of the samples with increasing irradiation time which we attribute to the removal of carbon molecules.
The authors report micro-Raman investigation of changes in the single and bilayer graphene crystal lattice induced by the low and medium energy electron-beam irradiation (5 and 20 keV). It was found that the radiation exposures results in appearance of the strong disorder D band around 1345 1/cm indicating damage to the lattice. The D and G peak evolution with the increasing radiation dose follows the amorphization trajectory, which suggests graphenes transformation to the nanocrystalline, and then to amorphous form. The results have important implications for graphene characterization and device fabrication, which rely on the electron microscopy and focused ion beam processing.
We present very low temperature Scanning Tunneling Microscopy and Spectroscopy (STM/S) measurements in W-based amorphous superconducting nanodeposits grown using a metal-organic precursor and focused-ion-beam. The superconducting gap closely follows s-wave BCS theory, and STS images under magnetic fields show a hexagonal vortex lattice whose orientation is related to features observed in the topography through STM. Our results demonstrate that the superconducting properties at the surface of these deposits are very homogeneous, down to atomic scale. This, combined with the huge nanofabrication possibilities of the focused-ion-beam technique, paves the way to use focused-ion-beam to make superconducting circuitry of many different geometries.
We have prepared iron microwires in a combination of focused electron beam induced deposition (FEBID) and autocatalytic growth from the iron pentacarbonyl, Fe(CO)5, precursor gas under UHV conditions. The electrical transport properties of the microwires were investigated and it was found that the temperature dependence of the longitudinal resistivity (rhoxx) shows a typical metallic behaviour with a room temperature value of about 88 micro{Omega} cm. In order to investigate the magnetotransport properties we have measured the isothermal Hall-resistivities in the range between 4.2 K and 260 K. From these measurements positive values for the ordinary and the anomalous Hall coefficients were derived. The relation between anomalous Hall resistivity (rhoAN) and longitudinal resistivity is quadratic, rhoAN rho^2 xx, revealing an intrinsic origin of the anomalous Hall effect. Finally, at low temperature in the transversal geometry a negative magnetoresistance of about 0.2 % was measured.
Low stability of organic-inorganic perovskite (CH3NH3PbI3) solar cells in humid air environments is a serious drawback which could limit practical application of this material severely. In this study, from real-time spectroscopic ellipsometry characterization, the degradation mechanism of ultra-smooth CH3NH3PbI3 layers prepared by a laser evaporation technique is studied. We present evidence that the CH3NH3PbI3 degradation in humid air proceeds by two competing reactions of (i) the PbI2 formation by the desorption of CH3NH3I species and (ii) the generation of a CH3NH3PbI3 hydrate phase by H2O incorporation. In particular, rapid phase change occurs in the near-surface region and the CH3NH3PbI3 layer thickness reduces rapidly in the initial 1-h air exposure even at a low relative humidity of 40%. After the prolonged air exposure, the CH3NH3PbI3 layer is converted completely to hexagonal platelet PbI2/hydrate crystals that have a distinct atomic-scale multilayer structure with a period of 0.65 nm. We find that conventional x-ray diffraction and optical characterization in the visible region, used commonly in earlier works, are quite insensitive to the surface phase change. Based on results obtained in this work, we discuss the degradation mechanism of CH3NH3PbI3 in humid air.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
