اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSingle Photon Atomic Sorting: Isotope Separation with Maxwells Demon
192
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Isotope separation is one of the grand challenges of modern society and holds great potential for basic science, medicine, energy, and defense. We consider here a new and general approach to isotope separation. The method is based on an irreversible change of the mass-to-magnetic moment ratio of a particular isotope in an atomic beam, followed by a magnetic multipole whose gradients deflect and guide the atoms. The underlying mechanism is a reduction of the entropy of the beam by the information of a single-scattered photon for each atom that is separated. We numerically simulate isotope separation for a range of examples, including lithium, for which we describe the experimental setup we are currently constructing. Simulations of other examples demonstrate this techniques general applicability to almost the entire periodic table. We show that the efficiency of the process is only limited by the available laser power, since one photon on average enables the separation of one atom. The practical importance of the proposed method is that large-scale isotope separation should be possible, using ordinary inexpensive magnets and the existing technologies of supersonic beams and lasers.
قيم البحث
اقرأ أيضاً
We demonstrate a general and efficient informational cooling technique for atoms which is an experimental realization of a one-dimensional Maxwells Demon. The technique transfers atoms from a magnetic trap into an optical trap via a single spontaneou
s Raman transition which is discriminatively driven near each atoms classical turning point. In this way, nearly all of the atomic ensembles kinetic energy in one dimension is removed. We develop a simple analytical model to predict the efficiency of transfer between the traps and provide evidence that the performance is limited only by particle dynamics in the magnetic trap. Transfer efficiencies up to 2.2% are reported. We show that efficiency can be traded for phase-space compression, and we report compression up to a factor of 350. Our results represent a 15-fold improvement over our previous demonstration of the cooling technique.
We propose and analyze Maxwells demon based on a single qubit with avoided level crossing. Its operation cycle consists of adiabatic drive to the point of minimum energy separation, measurement of the qubit state, and conditional feedback. We show th
at the heat extracted from the bath at temperature $T$ can ideally approach the Landauer limit of $k_BTln 2$ per cycle even in the quantum regime. Practical demon efficiency is limited by the interplay of Landau-Zener transitions and coupling to the bath. We suggest that an experimental demonstration of the demon is fully feasible using one of the standard superconducting qubits.
We report the cooling of an atomic ensemble with light, where each atom scatters only a single photon on average. This is a general method that does not require a cycling transition and can be applied to atoms or molecules which are magnetically trap
ped. We discuss the application of this new approach to the cooling of hydrogenic atoms for the purpose of precision spectroscopy and fundamental tests.
The first direct experimental replication of the Maxwell Demon thought experiment is outlined. The experiment determines the velocity/kinetic energy distribution of the particles in a sample by a novel interpretation of the results from a standard ti
me-of-flight (TOF) small angle neutron scattering (SANS) procedure. Perspex at 293 K was subjected to neutrons at 82.2 K. The key result is a TOF velocity distribution curve that is a direct spatial and time-dependent microscopic probe of the velocity distribution of the Perspex nuclei at 293 K. Having this curve, one can duplicate the Demons approach by selecting neutrons at known kinetic energies. One example is given: namely, two reservoirs -- hot and cold reservoirs -- were generated from the 293 K source without disturbing its original 293 K energy distribution.
We study the physical mechanism of Maxwells Demon (MD) helping to do extra work in thermodynamic cycles, by describing measurement of position, insertion of wall and information erasing of MD in a quantum mechanical fashion. The heat engine is exempl
ified with one molecule confined in an infinitely deep square potential inserted with a movable solid wall, while the MD is modeled as a two-level system (TLS) for measuring and controlling the motion of the molecule. It is discovered that the the MD with quantum coherence or on a lower temperature than that of the heat bath of the particle would enhance the ability of the whole work substance formed by the system plus the MD to do work outside. This observation reveals that the role of the MD essentially is to drive the whole work substance being off equilibrium, or equivalently working with an effective temperature difference. The elaborate studies with this model explicitly reveal the effect of finite size off the classical limit or thermodynamic limit, which contradicts the common sense on Szilard heat engine (SHE). The quantum SHEs efficiency is evaluated in detail to prove the validity of second law of thermodynamics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
