اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRefinement of the equation of state of tantalum
85
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The volume of tantalum versus pressure has been accurately measured up to 101 GPa by single-crystal x-ray diffraction, with helium as pressure transmitting medium. Slight deviation from previous static determinations is observed. Discrepancy with reduced shock-wave and ultrasonic data supports recent doubts about the calibration of the ruby pressure scale. Finally, first principle calculations of the literature show a positive curvature in $P(V)$ relative to the experimental data, even with a modified pressure scale.
قيم البحث
اقرأ أيضاً
Quasi-two-dimensional (quasi-2D) materials hold promise for future electronics because of their unique band structures that result in electronic and mechanical properties sensitive to crystal strains in all three dimensions. Quantifying crystal strai
n is a prerequisite to correlating it with the performance of the device, and calls for high resolution but spatially resolved rapid characterization methods. Here we show that using fly-scan nano X-ray diffraction we can accomplish a tensile strain sensitivity below 0.001% with a spatial resolution of better than 80 nm over a spatial extent of 100 $mu$m on quasi 2D flakes of 1T-TaS2. Coherent diffraction patterns were collected from a $sim$ 100 nm thick sheet of 1T-TaS2 by scanning 12keV focused X-ray beam across and rotating the sample. We demonstrate that the strain distribution around micron and sub-micron sized bubbles that are present in the sample may be reconstructed from these images. The experiments use state of the art synchrotron instrumentation, and will allow rapid and non-intrusive strain mapping of thin film samples and electronic devices based on quasi 2D materials.
The simplest anharmonic characteristics of Ir and Rh are discussed in the framework of a previously developed simple pseudopotential model which describes the elastic moduli, phonon spectra and the lattice heat capacity in the harmonic approximation
of these metals succesfully. The microscopic Gruneisen parameters, the dependences of the elastic moduli on pressure, the coefficient of thermal expansion and the equations of state at the finite temperatures have been calculated. The ab initio calculations of the energy-band structure and the equation of state for Ir at T=0 have been done to test the model for adequacy at high pressures. The values of different contributions (zero-point oscillations, quasiharmonic, etc.) in the considered thermodynamic characteristics of Ir and Rh are discussed.
The 300 K equation of state of cubic (zinc-blende) boron phosphide BP has been studied by in situ single-crystal X-ray diffraction with synchrotron radiation up to 55 GPa. The measurements have been performed under quasi-hydrostatic conditions using
a Ne pressure medium in a diamond anvil cell. A fit of the experimental p-V data to the Vinet equation of state yields the bulk modulus B0 of 179(1) GPa with its pressure derivative of 3.3(1). These values are in a good agreement with previous elastic measurements, as well as with semiempirical estimations.
We report a giant spin Hall effect (SHE) in {beta}-Ta that generates spin currents intense enough to induce efficient spin-transfer-torque switching of ferromagnets, thereby providing a new approach for controlling magnetic devices that can be superi
or to existing technologies. We quantify this SHE by three independent methods and demonstrate spin-torque (ST) switching of both out-of-plane and in-plane magnetized layers. We implement a three-terminal device that utilizes current passing through a low impedance Ta-ferromagnet bilayer to effect switching of a nanomagnet, with a higher-impedance magnetic tunnel junction for read-out. The efficiency and reliability of this device, together with its simplicity of fabrication, suggest that this three-terminal SHE-ST design can eliminate the main obstacles currently impeding the development of magnetic memory and non-volatile spin logic technologies.
Diamond is used extensively as a component in high energy density experiments, but existing equation of state (EOS) models do not capture its observed response to dynamic loading. In particular, in contrast with first principles theoretical EOS model
s, no solid-solid phase changes have been detected, and no general-purpose EOS models match the measured ambient isotherm. We have performed density functional theory (DFT) calculations of the diamond phase to ~10TPa, well beyond its predicted range of thermodynamic stability, and used these results as the basis of a Mie-Greuneisen EOS. We also performed DFT calculations of the elastic moduli, and calibrated an algebraic elasticity model for use in simulations. We then estimated the flow stress of diamond by comparison with the stress-density relation measured experimentally in ramp-loading experiments. The resulting constitutive model allows us to place a constraint on the Taylor-Quinney factor (the fraction of plastic work converted to heat) from the observation that diamond does not melt on ramp compression.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
