اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUltra-high-precision velocity measurements of oscillations in alpha Cen A
56
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have made differential radial velocity measurements of the star alpha Cen A using two spectrographs, UVES and UCLES, both with iodine absorption cells for wavelength referencing. Stellar oscillations are clearly visible in the time series. After removing jumps and slow trends in the data, we show that the precision of the velocity measurements per minute of observing time is 0.42 m/s for UVES and 1.0 m/s for UCLES, while the noise level in the Fourier spectrum of the combined data is 1.9 cm/s. As such, these observations represent the most precise velocities ever measured on any star apart from the Sun.
قيم البحث
اقرأ أيضاً
The Doppler method of exoplanet detection has been extremely successful, but suffers from contaminating noise from stellar activity. In this work a model of a rotating star with a magnetic field based on the geometry of the K2 star Epsilon Eridani is
presented and used to estimate its effect on simulated radial velocity measurements. A number of different distributions of unresolved magnetic spots were simulated on top of the observed large-scale magnetic maps obtained from eight years of spectropolarimetric observations. The radial velocity signals due to the magnetic spots have amplitudes of up to 10 m s$^{-1}$, high enough to prevent the detection of planets under 20 Earth masses in temperate zones of solar type stars. We show that the radial velocity depends heavily on spot distribution. Our results emphasize that understanding stellar magnetic activity and spot distribution is crucial for detection of Earth analogues.
High precision radial velocity (RV) measurements in the near infrared are on high demand, especially in the context of exoplanet search campaigns shifting their interest to late type stars in order to detect planets with ever lower mass or targeting
embedded pre-main-sequence objects. ESO is offering a new spectrograph at the VLT -- CRIRES -- designed for high resolution near-infrared spectroscopy with a comparably broad wavelength coverage and the possibility to use gas-cells to provide a stable RV zero-point. We investigate here the intrinsic short-term RV stability of CRIRES, both with gas-cell calibration data and on-sky measurements using the absorption lines of the Earths atmosphere imprinted in the source spectrum as a local RV rest frame. Moreover, we also investigate for the first time the intrinsic stability of telluric lines at 4100 nm for features originating in the lower troposphere. Our analysis of nearly 5 hours of consecutive observations of MS Vel, a M2II bright giant centred at two SiO first overtone band-heads at 4100 nm, demonstrates that the intrinsic short-term stability of CRIRES is very high, showing only a slow and fully compensateable drift of up to 60 m/s after 4.5 hours. The radial velocity of the telluric lines is constant down to a level of approx. +/- 10 m/s (or 7/1000 of one pixel). Utilising the same telluriclines as a rest frame for our radial velocity measurements of the science target, we obtain a constant RV with a precision of approx. +/- 20 m/s for MS Vel as expected for a M-giant.
High-precision spectrographs play a key role in exoplanet searches and Doppler asteroseismology using the radial velocity technique. The 1 m/s level of precision requires very high stability and uniformity of the illumination of the spectrograph. In
fiber-fed spectrographs such as SOPHIE, the fiber-link scrambling properties are one of the main conditions for high precision. To significantly improve the radial velocity precision of the SOPHIE spectrograph, which was limited to 5-6 m/s, we implemented a piece of octagonal-section fiber in the fiber link. We present here the scientific validation of the upgrade of this instrument, demonstrating a real improvement. The upgraded instrument, renamed SOPHIE+, reaches radial velocity precision in the range of 1-2 m/s. It is now fully efficient for the detection of low-mass exoplanets down to 5-10 Earth mass and for the identification of acoustic modes down to a few tens of cm/s.
A set of long and nearly continuous observations of alpha Centauri A should allow us to derive an accurate set of asteroseismic constraints to compare to models, and make inferences on the internal structure of our closest stellar neighbour. We inten
d to improve the knowledge of the interior of alpha Centauri A by determining the nature of its core. We combined the radial velocity time series obtained in May 2001 with three spectrographs in Chile and Australia: CORALIE, UVES, and UCLES. The resulting combined time series has a length of 12.45 days and contains over 10,000 data points and allows to greatly reduce the daily alias peaks in the power spectral window. We detected 44 frequencies that are in good overall agreement with previous studies, and found that 14 of these show possible rotational splittings. New values for the large and small separations have been derived. A comparison with stellar models indicates that the asteroseismic constraints determined in this study allows us to set an upper limit to the amount of convective-core overshooting needed to model stars of mass and metallicity similar to those of alpha Cen A.
We infer from different seismic observations the energy supplied per unit of time by turbulent convection to the acoustic modes of Alpha Cen A (HD 128620), a star which is similar but not identical to the Sun. The inferred rates of energy supplied to
the modes (i.e. mode excitation rates) are found to be significantly larger than in the Sun. They are compared with those computed with an excitation model that includes two sources of driving, the Reynolds stress contribution and the advection of entropy fluctuations. The model also uses a closure model, the Closure Model with Plumes (CMP hereafter), that takes the asymmetry between the up- and down-flows (i.e. the granules and plumes, respectively) into account. Different prescriptions for the eddy-time correlation function are also confronted to observational data. Calculations based on a Gaussian eddy-time correlation underestimate excitation rates compared with the values derived from observations for Alpha Cen A. On the other hand, calculations based on a Lorentzian eddy-time correlation lie within the observational error bars. This confirms results obtained in the solar case. With respect to the helioseismic data, those obtained for Alpha Cen A constitute an additional support for our model of excitation. We show that mode masses must be computed taking turbulent pressure into account. Finally, we emphasize the need for more accurate seismic measurements in order to discriminate, in the case of Alpha Cen A, between the CMP closure model and the quasi-Normal Approximation as well as to confirm or not the need to include the excitation by the entropy fluctuations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
