اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA Generalized Space-Frequency Index Modulation Scheme for Downlink MIMO Transmissions with Improved Diversity
73
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Multidimensional Index Modulations (IM) are a novel alternative to conventional modulations which can bring considerable benefits for future wireless networks. Within this scope, in this paper we present a new scheme, named as Precoding-aided Transmitter side Generalized Space-Frequency Index Modulation (PT-GSFIM), where part of the information bits select the active antennas and subcarriers which then carry amplitude and phase modulated symbols. The proposed scheme is designed for multiuser multiple-input multiple-output (MU-MIMO) scenarios and incorporates a precoder which removes multiuser interference (MUI) at the receivers. Furthermore, the proposed PT-GSFIM also integrates signal space diversity (SSD) techniques for tackling the typical poor performance of uncoded orthogonal frequency division multiplexing (OFDM) based schemes. By combining complex rotation matrices (CRM) and subcarrier-level interleaving, PT-GSFIM can exploit the inherent diversity in frequency selective channels and improve the performance without additional power or bandwidth. To support reliable detection of the multidimensional PT-GSFIM we also propose three different detection algorithms which can provide different tradeoffs between performance and complexity. Simulation results shows that proposed PT-GSFIM scheme, can provide significant gains over conventional MU-MIMO and GSM schemes.
قيم البحث
اقرأ أيضاً
In this correspondence, we propose a space domain index modulation (IM) scheme for the downlink of multiuser multiple-input multiple-output (MU-MIMO) systems. Instead of the most common approach where spatial bits select active receiver antennas, in
the presented scheme the spatial information is mapped onto the transmitter side. This allows IM to better exploit large dimensional antenna settings which are typically easier to deploy at the base station. In order to mitigate inter-user interference and allow single user detection, a precoder is adopted at the BS. Furthermore two alternative enhanced signal construction methods are proposed for minimizing the transmitted power or enable an implementation with a reduced number of RF chains. Simulation results for different scenarios show that the proposed approach can be an attractive alternative to conventional precoded MU-MIMO.
Rate-splitting multiple access (RSMA) is a general multiple access scheme for downlink multi-antenna systems embracing both classical spatial division multiple access and more recent non-orthogonal multiple access. Finding a linear precoding strategy
that maximizes the sum spectral efficiency of RSMA is a challenging yet significant problem. In this paper, we put forth a novel precoder design framework that jointly finds the linear precoders for the common and private messages for RSMA. Our approach is first to approximate the non-smooth minimum function part in the sum spectral efficiency of RSMA using a LogSumExp technique. Then, we reformulate the sum spectral efficiency maximization problem as a form of the log-sum of Rayleigh quotients to convert it into a tractable non-convex optimization problem. By interpreting the first-order optimality condition of the reformulated problem as an eigenvector-dependent nonlinear eigenvalue problem, we reveal that a leading eigenvector is a local optimal solution. To find the leading eigenvector, we propose a computationally efficient algorithm inspired by a power iteration method. Simulation results show that the proposed RSMA transmission strategy provides significant improvement in the sum spectral efficiency compared to the state-of-the-art RSMA transmission methods, while requiring considerably less computational complexity.
This work focuses on the downlink communication of a multiuser MIMO system where the base station antennas and the users receiving antennas are all active, but at each transmission, only a subset of the receive antennas is selected by the base statio
n to receive the information symbols, and the particular chosen subset (pattern) represents part of the information conveyed to the user. In this paper we present a mathematical model for the system and develop expressions that are fairly general and adequate for its analysis. Based on these expressions we propose a procedure to optimize the choice by the ERB of the sets of antenna patterns to be used in the transmissions to the different users, aiming at the maximization of the detection signal-to-noise ratio. Performance results, with and without the optimization procedure, are presented for different scenarios.
Channel estimation is challenging for the reconfigurable intelligence surface (RIS) assisted millimeter wave (mmWave) communications. Since the number of coefficients of the cascaded channels in such systems is closely dependent on the product of the
number of base station antennas and the number of RIS elements, the pilot overhead would be prohibitively high. In this letter, we propose a cascaded channel estimation framework for an RIS assisted mmWave multiple-input multiple-output system, where the wideband effect on transmission model is considered. Then, we transform the wideband channel estimation into a parameter recovery problem and use a few pilot symbols to detect the channel parameters by the Newtonized orthogonal matching pursuit algorithm. Moreover, the Cramer-Rao lower bound on the channel estimation is introduced. Numerical results show the effectiveness of the proposed channel estimation scheme.
An eight element, compact Ultra Wideband-Multiple Input Multiple Output (UWB-MIMO) antenna capable of providing high data rates for future Fifth Generation (5G) terminal equipments along with the provision of necessary bandwidth for Third Generation
(3G) and Fourth Generation (4G) communications that accomplishes band rejection from 4.85 to 6.35 GHz by deploying a Inductor Capacitor (LC) stub on the ground plane is presented. The incorporated stub also provides flexibility to reject any selected band as well as bandwidth control. The orthogonal placement of the printed monopoles permits polarization diversity and provides high isolation. In the proposed eight element UWB-MIMO/diversity antenna, monopole pair 3-4 are 180o mirrored transform of monopole pair 1-2 which lie on the opposite corners of a planar 50 x 50 mm2 substrate. Four additional monopoles are then placed perpendicularly to the same board leading to a total size of 50 x 50 x 25 mm3 only. The simulated results are validated by comparing the measurements of a fabricated prototype. It was concluded that the design meets the target specifications over the entire bandwidth of 2 to 12 GHz with a reflection coefficient better than -10 dB (except the rejected band), isolation more than 17 dB, low envelope correlation, low gain variation, stable radiation pattern, and strong rejection of the signals in the Wireless Local Area Network (WLAN) band. Overall, compact and reduced complexity of the proposed eight element architecture, strengthens its practical viability for the diversity applications in future 5G terminal equipments amongst other MIMO antennas designs present in the literature.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
