اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStructural, magnetic and insulator-to-metal transitions under pressure in the GaV4S8 Mott insulator: A rich phase diagram up to 14.7 GPa
52
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In addition to its promising potential for applications, GaV4S8 shows very interesting physical properties with temperature and magnetic field. These properties can be tuned by applying hydrostatic pressure in order to reveal and understand the physics of these materials. Not only pressure induces an insulator-to-metal transition in GaV4S8 but it also has an interesting effect on the structural and magnetic transitions. Using a combination of AC calorimetry, capacitance, and resistivity measurements under pressure, we determine the evolution of the structural and magnetic transitions with pressure and thus establish the T-P phase diagram of GaV4S8. To detect the insulator-to-metal transition, we use optical conductivity and DC resistivity measurements and we follow the evolution of the Mott gap under pressure. The structural transition temperature increases with pressure and a second transition appears above 6 GPa indicating a possible new phase with a very small gap. Pressure has surprisingly a very weak effect on the ferromagnetic transition that persists even very close to the IMT that occurs at around 14 GPa, implying that the metallic state may also be magnetic.
قيم البحث
اقرأ أيضاً
We present a study of the effect of very high pressure on the orthorhombic perovskite GdMnO3 by Raman spectroscopy and synchrotron x-ray diffraction up to 53.2 GPa. The experimental results yield a structural and insulator-to-metal phase transition c
lose to 50 GPa, from an orthorhombic to a metrically cubic structure. The phase transition is of first order with a pressure hysteresis of about 6 GPa. The observed behavior under very high pressure might well be a general feature in rare-earth manganites.
Nitrogen vacancy (NV) centers, optically-active atomic defects in diamond, have attracted tremendous interest for quantum sensing, network, and computing applications due to their excellent quantum coherence and remarkable versatility in a real, ambi
ent environment. Taking advantage of these strengths, we report on NV-based local sensing of the electrically driven insulator-to-metal transition (IMT) in a proximal Mott insulator. We studied the resistive switching properties of both pristine and ion-irradiated VO2 thin film devices by performing optically detected NV electron spin resonance measurements. These measurements probe the local temperature and magnetic field in electrically biased VO2 devices, which are in agreement with the global transport measurement results. In pristine devices, the electrically-driven IMT proceeds through Joule heating up to the transition temperature while in ion-irradiated devices, the transition occurs non-thermally, well below the transition temperature. Our results provide the first direct evidence for non-thermal electrically induced IMT in a Mott insulator, highlighting the significant opportunities offered by NV quantum sensors in exploring nanoscale thermal and electrical behaviors in Mott materials.
The pressure-induced insulator to metal transition (IMT) of layered magnetic nickel phosphorous tri-sulfide NiPS3 was studied in-situ under quasi-uniaxial conditions by means of electrical resistance (R) and X-ray diffraction (XRD) measurements. This
sluggish transition is shown to occur at 35 GPa. Transport measurements show no evidence of superconductivity to the lowest measured temperature (~ 2 K). The structure results presented here differ from earlier in-situ work that subjected the sample to a different pressure state, suggesting that in NiPS3 the phase stability fields are highly dependent on strain. It is suggested that careful control of the strain is essential when studying the electronic and magnetic properties of layered van der Waals solids.
We investigated the pressure-dependent optical response of the low-dimensional Mott-Hubbard insulator TiOBr by transmittance and reflectance measurements in the infrared and visible frequency range. A suppression of the transmittance above a critical
pressure and a concomitant increase of the reflectance are observed, suggesting a pressure-induced metallization of TiOBr. The metallic phase of TiOBr at high pressure is confirmed by the presence of additional excitations extending down to the far-infrared range. The pressure-induced metallization coincides with a structural phase transition, according to the results of x-ray powder diffraction experiments under pressure.
Since the beginnings of the electronic age, a quest for ever faster and smaller switches has been initiated, since this element is ubiquitous and foundational in any electronic circuit to regulate the flow of current. Mott insulators are promising ca
ndidates to meet this need as they undergo extremely fast resistive switching under electric field. However the mechanism of this transition is still under debate. Our spatially-resolved {mu}-XRD imaging experiments carried out on the prototypal Mott insulator (V0.95Cr0.05)2O3 show that the resistive switching is associated with the creation of a conducting filamentary path consisting in an isostructural compressed phase without any chemical nor symmetry change. This clearly evidences that the resistive switching mechanism is inherited from the bandwidth-controlled Mott transition. This discovery might hence ease the development of a new branch of electronics dubbed Mottronics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
